0333967 EVINRUDE COVER, Thermostat and valves


0333967 COVER, Thermostat and valves EVINRUDE E120TLEND, E120TLETF, E125ESXENR, E125ESXETA, E140CXATF, E140CXENM, E60ELCEA, E60ELEIB, E60ELENE, E60ELESM, E60TTLEIB, E60TTLENE, E65WMLEIB, E65WMLENE, E65WMLESM, E65WMLZ, E70ELCCA, E70ELCEM, E70ELEIE, E70ELEND, E70ELESB, E70TTLEIE, E70TTLEND, T65WML COVER
0333967 COVER, Thermostat and valves EVINRUDE
Rating:
63

Buy COVER, Thermostat and valves 0333967 EVINRUDE genuine, new aftermarket parts with delivery
Number on catalog scheme: 32
 

BRP EVINRUDE entire parts catalog list:

E120TLEND, E120TXEND, VE120TLEND, VE120TXEND 1992
E120TLETF, E120TLETS, E120TXATF, E120TXATS, E120TXETF, E120TXETS, VE120TLETF, VE120TLETS, VE120TXETF, VE120TXETS 1993
E125ESXENR 1992
E125ESXETA, E125ESXETF 1993
E140CXATF, E140CXATS, E140CXETB, E140CXETF, E140TLATC, E140TLATF, E140TLETC, E140TLETF, E140TXATF, E140TXATS, E140TXETC, E140TXETF, VE140TLETC, VE140TLETF, VE140TXETC, VE140TXETF 1993
E140CXENM, E140TLENS, E140TXENS, VE140TLENS, VE140TXENS 1992
E60ELCEA, E60TLCEA, E60TTLCEA, TE60TLCEA, TE60TLESF 1989
E60ELEIB, E60TLEIB, TE60TLEIB, VE60ELEIB, VE60TLEIB 1991
E60ELENE, E60TLENE, TE60TLENE, VE60ELENE, VE60TLENE 1992
E60ELESM, E60TLESM, E60TTLESM, TE60TLESF, TE60TLESM, VE60ELESM, VE60TLESM 1990
E60TTLEIB 1991
E60TTLENE 1992
E65WMLEIB 1991
E65WMLENE 1992
E65WMLESM 1990
E65WMLZ 1989
E70ELCCA, E70TLCCA 1988
E70ELCEM, E70TLCEM, TE70TLCEM, TE70TLESF 1989
E70ELEIE, E70TLEIE, VE70ELEIE, VE70TLEIE 1991
E70ELEND, E70TLEND, VE70ELEND, VE70TLEND 1992
E70ELESB, E70TLESB, TE70TLESB, TE70TLESF, VE70ELESB, VE70TLESB 1990
E70TTLEIE 1991
E70TTLEND 1992
T65WMLM 1988

Information:


For any type of leak (coolant, lube, or fuel) clean up the fluid. If leaking is observed, find the source and correct the leak. If leaking is suspected, check the fluid levels more often than recommended until the leak is found or fixed, or until the suspicion of a leak is proved to be unwarranted.
Accumulated grease and/or oil on an engine or deck is a fire hazard. Remove this debris with steam cleaning or high pressure water.
Air Inlet and Exhaust System
Inspect the piping for the air inlet and exhaust system and the elbows for cracks.
Inspect exhaust bellows for leaks.
Ensure that the air filters are in place.
Ensure that all clamps and connections are secure.
Observe the air cleaner service indicator. Service the air cleaner when the yellow diaphragm enters the red zone, or when the red piston locks in the visible position.Cooling System
Inspect the cooling system for leaks or loose connections.
Inspect the cooling system hoses for cracks and for loose clamps.
Inspect the water pumps for evidence of leaks.
Inspect the fan drive belts for cracks and for deterioration.
Check the coolant level. Add coolant, if necessary. For information on the proper coolant to use, see this Operation and Maintenance Manual, "Refill Capacities and Recommendations".Note: The water pump seal is lubricated by coolant in the cooling system. A small amount of leakage to occur as the engine cools down and the parts contract is normal.Excessive coolant leakage may indicate the need to replace the water pump seal. For the removal of the water pump and the installation of the water pump and/or seals, refer to the Service Manual for the engine or consult your Cat dealer.Driven Equipment
Perform any maintenance that is required for the driven equipment.Electrical System
Inspect the wiring for the following conditions:
Loose connections
Wiring that is worn or frayed
Inspect the ground strap for a good connection and for good condition.
Inspect the engine-to-frame ground strap for a good connection and for good condition.Fuel System
All valves in the fuel return line must be open before and during engine operation to help prevent high fuel pressure. High fuel pressure may cause filter housing failure or other damage.
Inspect the fuel lines for loose fittings and leaks. Ensure that the fuel lines are properly clamped.
Ensure that the fuel is supplied to the engine.
Drain the water and the sediment from fuel tanks daily to ensure that only clean fuel enters the fuel system.If the engine has not been started for several weeks, fuel may have drained from the fuel system. Air may have entered the filter housing. Also, when fuel filters have been changed, some air space will be left in the housing. In these instances, prime the fuel system. See this Operation and Maintenance Manual (Maintenance Section), "Fuel System-Prime" for information on priming the fuel system.Lubrication System
Illustration 1 g00735162
(3) "ENGINE STOPPED WITH OIL COLD" side
(4) "ENGINE AT LOW IDLE WITH WARM OIL" side
(5) "ADD" mark
(6) "FULL" mark
Check the engine crankcase oil level. Maintain the oil level between the "ADD" and "FULL" marks on the "ENGINE STOPPED" side of the oil level gauge. For information on the proper oil to use, see this Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Check for leaks at the following components: crankshaft seals, crankcase, oil filters, oil gallery plugs, sensors, and valve covers.
Inspect the tubes, tee pieces, and clamps on the crankcase breathers.Starting System
Disconnect any battery chargers that are not protected against the high current drain that is created when the electric starting motor is engaged.
Inspect the battery cables for good connections and for corrosion.
Inspect the gauges and/or the control panel for good condition.
Reset the shutoff (if equipped) and alarm components.


Parts cover EVINRUDE:

0321673
COVER, Mount bracket, lower
0321673 COVER, Mount bracket, lower
70873C, 70973R, BE50DTLEDC, BE50DTLEUR, BE60ELEDR, BE60ELEUA, BE60TLECM, BE70ELECB, BE70ELEDA, BE70ELEUM, E50DTLECA, E50DTLEOS, E50TTLECA, E50TTLEDC, E50TTLEOS, E50TTLEUR, E60ELCCR, E60ELCDS, E60ELCEA, E60ELCUC, E60ELEIB, E60ELENE, E60ELEOC, E60ELERS
0388651
COVER ASSY
0388651 COVER ASSY
70873C, 70973R, BE50DTLEDC, BE50DTLEUR, BE60ELEDR, BE60ELEUA, BE60TLECM, BE70ELECB, BE70ELEDA, BE70ELEUM, E50DTLECA, E50DTLEOS, E50TTLECA, E50TTLEDC, E50TTLEOS, E50TTLEUR, E60ELCCR, E60ELCDS, E60ELCEA, E60ELCUC, E60ELEIB, E60ELENE, E60ELEOC, E60ELERS
0330373
COVER, Exhaust hsg., front
0330373 COVER, Exhaust hsg., front
E60ELCCR, E60ELCDS, E60ELCEA, E60ELCUC, E60ELEIB, E60ELENE, E60ELESM, E60ELETD, E60TTLEIB, E60TTLENE, E60TTLETD, E65RWLCDR, E65RWLCOC, E65WMLCDR, E65WMLCOC, E65WMLCUA, E65WMLEIB, E65WMLENE, E65WMLESM, E65WMLETD, E65WMLZ, E70ELCCA, E70ELCDC, E70ELCEM,
0329562
COVER, Temp switch
0329562 COVER, Temp switch
BE10FAEDC, BE10FAEUR, BE10FDLECM, BE10FDLEDR, BE10FDLEUA, BE115ELEDR, BE115ELEUA, BE115GLECM, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE15FAEDR, BE15FAEUA, BE15FDLECM, BE175EXECD, BE175EXEDB, BE175EXEUC, BE200CXECM, BE
0334942
 
0334942 COVER, Cable & horn
E115JKLEOC, E115JKLERS, E40EEIA, E40EENJ, E40EEOD, E40EERE, E40EESR, E40EETB, E50BEEIA, E50BEENJ, E50BEEOD, E50BEERE, E50BEESR, E50BEETB, E50TTLEOS, E60ELCEA, E60ELESM, E60TTLEIB, E60TTLENE, E60TTLEOC, E60TTLERS, E60TTLETD, E70TTLEIE, E70TTLEND, E70T
0335474
COVER, Stern bracket, stbd.
0335474 COVER, Stern bracket, stbd.
BE115ELEDR, BE115ELEUA, BE115GLECM, BE115TLEDA, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE175EXECD, BE175EXEDB, BE175EXEUC, BE200CXECM, BE200CXEDR, BE200CXEUA, BE225CXECS, BE225CXEDE, BE225CXEUD, BE90ELEDR, BE90ELEUA,
0335475
COVER, Stern bracket, port
0335475 COVER, Stern bracket, port
BE115ELEDR, BE115ELEUA, BE115GLECM, BE115TLEDA, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE175EXECD, BE175EXEDB, BE175EXEUC, BE200CXECM, BE200CXEDR, BE200CXEUA, BE225CXECS, BE225CXEDE, BE225CXEUD, BE90ELEDR, BE90ELEUA,
0435482
COVER & SEAL ASSY.
0435482 COVER & SEAL ASSY.
BE115ELEDR, BE115ELEUA, BE115GLECM, BE115TLEDA, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE175EXECD, BE175EXEDB, BE175EXEUC, BE200CXECM, BE200CXEDR, BE200CXEUA, BE225CXECS, BE225CXEDE, BE225CXEUD, BE250CXECB, BE250CXEDA
Back to top