0439533 EVINRUDE DECAL SET

data-element=".content_table_1">
Table 1
Table for Customer Specified Parameters    
"Parameter"    Available Range or Options    Default    
"Selected Engine Rating"    
"Rating Number"     Dependent on engine power     Unavailable    
"Multitorque Ratio"     Unavailable (Standard Ratings)
"MT-1", "MT-2", or "MT-4" (Multi-Torque Ratings)     "MT-4" (Multi-Torque)    
"ECM Identification Parameters"    
"Vehicle ID"     17 Digits
Available characters are dependent on the service tools.     all zeroes    
"Security Access Parameters"    
"ECM Wireless Communication Enable"     "Yes"
"No"     "No"    
"Vehicle Speed Parameters"    
"Vehicle Speed Calibration"     2485 to 93226 PPKM (4000 to 150000 PPM)    
8696 PPKM (14000 PPM)    
"Vehicle Speed Cal (J1939 - Trans)"     0 to 6500     Not Programmed    
"Vehicle Speed Cal (J1939 - ABS)"     0 to 6.550     Not Programmed    
"Vehicle Speed Limit"    
48 to 204 km/h (30 to 127 mph)    
204 km/h (127 mph)    
"VSL Protection"     1300 to TEL rpm     TEL rpm    
"Tachometer Calibration"     12.0 to 500.0 pulses per revolution     113.0 pulses per revolution    
"Soft Vehicle Speed Limit"     "Yes"
"No"     "No"    
"Low Speed Range Axle Ratio"     1.00 to 19.99     1.00    
"High Speed Range Axle Ratio"     1.0 to 9.9     1.00    
"Cruise Control Parameters"    
"Low Cruise Control Speed Set Limit"    
24 to 204 km/h (15 to 127 mph)    
204 km/h (127 mph)    
"High Cruise Control Speed Set Limit"    
48 to 204 km/h (30 to 127 mph)    
204 km/h (127 mph)    
"Engine Retarder Mode"     "Coast"
"Latch"
"Manual"     "Manual"    
"Engine Retarder Minimum VSL Type"     "Hard Limit"
"Soft Limit"     "Hard Limit"    
"Engine Retarder Minimum Vehicle Speed"    
0 to 204 km/h (0 to 127 mph)    
0 km/h (0 mph)    
"Auto Retarder in Cruise"    
0 to 16 km/h (0 to 10 mph)    
0 km/h (0 mph)    
"Auto Retarder in Cruise Increment"    
0 to 8 km/h (0 to 5 mph)    
3 km/h (2 mph)    
"Cruise/Idle/PTO Switch Configuration"     "Set/Accel-Reset/Decel"
"Set/Decel-Reset/Accel"     "Set/Accel-Reset/Decel"    
"Soft Cruise Control"     "Yes"
"No"     "Yes"    
"Adaptive Cruise Control Enable"     "Disabled"
"Enabled"     "Disabled"    
"Idle Parameters"    
"Idle Vehicle Speed Limit"    
2 to 24 km/h (1 to 15 mph)    
2 km/h (1 mph)    
"Idle RPM Limit"     600 rpm to TEL rpm     TEL rpm    
"Idle/PTO RPM Ramp Rate"     5 to 1000 rpm/sec     50 rpm/sec    
"Idle/PTO Bump RPM"     5 to 500 rpm     20 rpm    
"Dedicated PTO Parameters"    
"PTO Configuration"     "Off"
"Cab Switches"
"Remote Switches"
"Remote Throttle"     "Off"    
"PTO Top Engine Limit"     600 to TEL rpm     TEL rpm    
"PTO Engine RPM Set Speed (0 = Off)"     Low Idle to PTO TEL rpm     0    
"PTO Engine RPM Set Speed A"     Low Idle rpm to PTO TEL rpm     0    
"PTO Engine RPM Set Speed B"     Low Idle rpm to PTO TEL rpm     0    
"PTO to Set Speed"     "Yes"
"No"     "No"    
"Maximum PTO Enable Speed"     Low Idle to TEL rpm     TEL rpm    
"PTO Cab Controls RPM Limit"     "Low idle rpm"
"TEL rpm"
"PTO TEL rpm"     "TEL rpm"    
"PTO Kickout Vehicle Speed Limit"    
2 to 204 km/h (1 to 127 mph)    
2 km/h (1 mph)    
"Torque Limit"     270 N m (200 lb ft) to Rated Torque    
3400 N m (2500 lb ft)    
"PTO Shutdown Time"     3 to 1440 minutes     0    
"PTO Shutdown Timer Maximum RPM"     600 to 2120 rpm     2120 rpm    
"PTO Activates Cooling Fan"     "Normal"
"Continuous"     "Normal"    
"Engine/Gear Parameters"    
"Lower Gears Engine RPM Limit"     1100 to TEL rpm     TEL rpm    
"Lower Gears Turn Off Speed"    
5 to 48 km/h (3 to 30 mph)    
5 km/h (3 mph)    
"Intermediate Gears Engine RPM Limit"     1100 to TEL rpm     TEL rpm    
"Intermediate Gears Turn Off Speed"    
8 to 80 km/h (5 to 50 mph)    
8 km/h (5 mph)    
"Gear Down Protection RPM Limit"     1300 to TEL rpm     TEL rpm    
"Gear Down Protection Turn On Speed"    
48 to 204 km/h (30 to 127 mph)    
204 km/h (127 mph)    
"Top Engine Limit (TEL)"     1600 to 2120 rpm     Dependent on the engine rating    
"Top Engine Limit with Droop"     "Yes"
"No"