0432442 EXHAUST HOUSING ASSY. EVINRUDE
E10ECES, E10EEIR, E10EENA, E10EESC, E15ECEC, E15EEIA, E15EENM, E15EESR
EXHAUST
Price: query
Rating:
BRP EVINRUDE entire parts catalog list:
- MIDSECTION (ALL MODELS EXCEPT SEL) » 0432442
E10EENA, E10ELENA, E10RELENA, E10RENA, E10RLENA, E10SELENA, TE10RELENA 1992
E10EESC, E10ELESC, E10RELESC, E10RESC, E10RLESC, E10SELESC, TE10ELESC, TE10RELESC, TE10RLESC 1990
E15ECEC, E15ELCEC, E15RCEC, E15RLCEC, TE15RLCEC 1989
E15EEIA, E15ELEIA, E15REIA, E15RELEIA, E15RLEIA 1991
E15EENM, E15ELENM, E15RELENM, E15RENM, E15RLENM 1992
E15EESR, E15ELESR, E15RELESR, E15RESR, E15RLESR 1990
Information:
Table 1
J1939 Code and Description Comments
110-17
Engine Coolant Temperature : Low - least severe (1) The coolant temperature did not rise above a temperature threshold after an extended period of operation under load. Probable Causes
Jacket water heater
Sensor
Connectors and wiring
Temperature regulators
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand.Cooling System Conditioner contains alkali. Avoid contact with skin and eyes.
Recommended Actions
Table 2
Troubleshooting Test Steps Values Results
1. Check for Codes
A. Connect Cat® Electronic Technician (ET) to the service tool connector.
B. Look for active codes that are associated with the system for the event code.
Codes
Result: An associated code is active.
Repair: Troubleshoot any associated codes before continuing with this test.
Result: A code is active or logged.
Proceed to Test Step 2.
2. Check the Water Temperature Regulators
Note: The water temperature regulators should not begin to open until jacket water reaches opening temperature for the regulators.
A. Allow the engine to cool and then start the engine. Check the hose at the outlet for the jacket water. If the hose is warm and normal operating temperature is not achieved yet, a regulator may be stuck open.
B. If the water temperature regulators are malfunctioning, check the water temperature regulators. Refer to Testing and Adjusting, "Testing the Cooling System" for additional information.
Regulators
Result: The temperature regulators are NOT OK.
Repair: Replace the water temperature regulators.
Verify that the repair eliminated the problem.
If the problem is not resolved, proceed to Test Step 3.
3. Check the Coolant Temperature Sensor
Note: The sensor may be indicating an incorrect temperature that is within the normal range of the sensor.
A. Connect Cat ET.
B. Use Cat ET to monitor the following temperature:
- Coolant temperature
Note: The temperature should rise steadily as the engine is warmed.
C. Ensure that the temperature is reasonable.
D. Reference the reading to another temperature indicator when possible. Refer to Testing and Adjusting, "Testing the Cooling System" for additional information.
Sensor
Result: The temperature sensor is OK.
Proceed to Test Step 4.
Result: The temperature sensor is NOT OK.
Proceed to Test Step 4.
4. Inspect the Electrical Connectors and the Wiring
A. Turn the main disconnect switch to the OFF position.
B. Thoroughly inspect the connectors. Refer to Troubleshooting, "Electrical Connectors-Inspect" for additional information.
C. Perform a 45 N (10 lb) pull test on the connector wires.
D. Check the harness for abrasions and pinch points.
Connectors and Wiring
Result: The connectors and wiring appear to be OK.
Repair: Replace the sensor.
Verify that the repair eliminated the problem.
Result: There is a problem with the connectors and/or wiring.
Repair: Repair or replace the connectors or wiring. Ensure that all the seals are properly in place and ensure that the connectors are coupled.
Verify that the repair eliminated the problem.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).
Parts exhaust EVINRUDE:
0322404
0322404 EXHAUST COVER, Outer
10824M, 10924B, E10ECCD, E10ECDB, E10ECES, E10ECOM, E10ECSE, E10ECUE, E10EEIR, E10EENA, E10EESC, E10ELCID, E10ELCNS, E10ELCRA, E10ELCTC, E15ECCS, E15ECDE, E15ECEC, E15ECIS, E15ECNC, E15ECOB, E15ECRM, E15ECSD, E15ECTR, E15ECUD, E15EEIA, E15EENM, E15EE
0326922
0326922 EXHAUST SEAL, Gearcase extension 5" LONGER PARTS
BE10EEDD, BE10FAEDC, BE10FAEUR, BE10RELEUS, BE15EEDS, BE15RELEUC, BE8FRBECA, BE8FRBEDC, BE8FRBEUR, E10ECCD, E10ECDB, E10ECES, E10ECOM, E10ECUE, E10EECC, E10EEIR, E10EENA, E10EEOE, E10EERB, E10EESC, E10EETM, E10ELCID, E10ELCNS, E10ELCRA, E10ELCTC, E10
0328497
0328497 EXHAUST COVER,Inner
BE10EEDD, BE10RELEUS, BE15EEDS, BE15RELEUC, E10ECDB, E10ECOM, E10EECC, E10EEIR, E10EENA, E10EEOE, E10EERB, E10EETM, E10ELCRA, E10ELCTC, E15ECDE, E15ECOB, E15ECRM, E15ECTR, E15EECR, E15EEIA, E15EENM, E15EEOD, E15EERE, E15EETB, E15WREES, E15WRLSIR, E15
0330439
0330439 EXHAUST TUBE, Inner
E10ECCD, E10ECDB, E10ECES, E10ECOM, E10ECUE, E15ECCS, E15ECDE, E15ECEC, E15ECOB, E15ECUD
0330440
0330440 EXHAUST TUBE, Inner
BE10EEDD, BE10RELEUS, BE15EEDS, BE15RELEUC, E10ECCD, E10ECDB, E10ECES, E10ECOM, E10ECUE, E10EECC, E10EEIR, E10EENA, E10EEOE, E10EERB, E10EESC, E10EETM, E15ECCS, E15ECDE, E15ECEC, E15ECOB, E15ECUD, E15EECR, E15EEIA, E15EENM, E15EEOD, E15EERE, E15EESR,
0432496