0313065 EVINRUDE GASKET,Adapter to block

Parameter Descriptions
Equipment ID
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the engine's application. A maximum of 17 characters can be entered in the field.Engine Serial Number
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM.ECM Part Number
This parameter identifies the part number for the ECM.ECM Serial Number
This parameter identifies the serial number for the ECM.Software Group Part Number
This parameter identifies the part number of the flash file that is currently installed in the ECM.Software Group Release Date
This parameter identifies the release date of the flash file that is currently installed in the ECM.Software Group Description
This parameter identifies the description of the application for the flash file that is currently installed in the ECM.Full Load Setting (FLS)
FLS is a parameter that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.Full Torque Setting (FTS)
FTS is similar to FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.Rated Power
This parameter specifies the rated power of the engine.Rated Peak Torque
This parameter specifies the rated peak torque of the engine.Top Engine Speed Range
This parameter specifies the maximum speed setting for the engine.Test Spec
This is the engine's "Test Specifiction Number". Use this number to retrieve data that is related to the engine's specifications from the Technical Marketing Information System (TMI). The following information can be retrieved from TMI:
"As shipped consists"
"Engine test specifications"
"Systems data"
"Physical data"
"Gasket kit data"
"Reman parts"
"Performance data"A link to TMI Web can be found on the web site for the Service Information System (SIS).Total Tattletale
The total tattletale counts the number of changes to system parameters.Low System Battery Voltage Elevated Idle
This parameter enables operation of the elevated idle function if a low battery condition is detected by the ECM.Ether Solenoid Configuration
This parameter is enabled in order to define the installation status of an ether starting aid for the engine.Engine Fan Reversing Feature
The "Engine Fan Reversing Feature" aids in clearing debris from the radiator.Engine Cooling Fan Map
This parameter identifies the current map that is used by the ECM to drive the engine cooling fan.Security System Immobilizer Installation Status
This feature enables the ECM to provide the functionality for the installation of a Machine Security System (MSS). Engine Retarder Enable Command (Option)
This parameter is enabled in order to define the installation status of compression brakes for the engine.Engine Warmup Elevated Idle Feature Enable Status
This feature allows a strategy for elevated idle to be enabled during cold engine operation.Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Configuration Group 1
Equipment ID 17 alphanumeric characters Blank None
ECM Identification Parameters
Engine Serial Number 0XX00000 or XXX00000 Blank Factory
ECM Serial Number Hardware Dependent Blank Read Only(1)
ECM Part Number Hardware Dependent Blank Read Only(1)
Software Group Part Number Software Dependent Read Only(1)
Software Group Release Date Software Dependent Read Only(1)
Software Group Description Software Dependent Read Only(1)
System Parameters
FLS Programmed at the Factory Factory
FTS Programmed at the Factory Factory
Rated Power Software Dependent Read Only(1)