0315093 EVINRUDE GASKET, Air silencer

Table 1
Diagnostic Codes Table
Code and Description Conditions which Generate this Code System Response
549-2 Throttle Lock Switch : Erratic, Intermittent, or Incorrect The Electronic Control Module (ECM) detects an invalid signal from the throttle lock switch. The code is logged. The ECM will disable the automatic control of engine speed. Throttle hold mode and the throttle lock feature are disabled.
The ECM will illuminate the check engine lamp. The ECM will pulse the action lamp and the action alarm at a rate of .5 Hz per second.
2770-3 Throttle Lock Resume/Decel Switch : Voltage Above Normal Both contacts of the "throttle lock resume/decel switch"are in the open state. The code is logged. The ECM will disable the automatic control of engine speed. Throttle hold mode and the throttle lock feature are disabled.
The ECM will illuminate the check engine lamp. The ECM will pulse the action lamp and the action alarm at a rate of .5 Hz per second.
2770-4 Throttle Lock Resume/Decel Switch : Voltage Below Normal Both contacts of the "throttle lock resume/decel switch" are in the closed state.
2771-3 Throttle Lock Set/Accel Switch : Voltage Above Normal Both contacts of the "throttle lock set/accel switch" are in the open state. The code is logged. The ECM will disable the automatic control of engine speed. Throttle hold mode and the throttle lock feature are disabled.
The ECM will illuminate the check engine lamp. The ECM will pulse the action lamp and the action alarm at a rate of .5 Hz per second.
2771-4 Throttle Lock Set/Accel Switch : Voltage Below Normal Both contacts of the "throttle lock set/accel switch" are in the closed state. The throttle lock feature is activated through the use of the throttle hold mode switch and the throttle speed set switch in order to maintain a desired engine speed. The throttle hold mode switch is a three-position rocker switch that is used to select the mode of operation. The throttle speed set switch is a two-position momentary rocker switch. This switch is for setting the engine speed and/or adjusting the engine speed. The throttle lock feature has the following three modes of operation:
Automatic
Manual
OFFAutomatic ModeDepress the throttle hold mode switch in the forward direction to the AUTO position in order to select the automatic mode. Use the throttle pedal to achieve the desired engine speed and then depress the throttle speed set switch in the forward direction (SET/ACCEL) in order to set the desired engine speed.Note: The throttle lock lamp will be illuminated when the engine speed is sustained in the automatic mode.Acceleration - Moving the throttle speed set switch in the forward direction (SET/ACCEL) will increase the desired engine speed. Momentarily bumping the throttle speed set switch will increase the desired engine speed by 100 rpm. Holding the throttle speed set switch for more than 250 milliseconds will increase the desired engine speed at a rate of 700 rpm per second. Moving the throttle pedal past the engine speed setpoint will increase the engine speed. This will deactivate the automatic throttle.Deceleration - Moving the throttle speed set switch in the backward direction (RESUME/DECEL) will decrease the desired engine speed. Momentarily bumping the throttle speed set switch will decrease the desired engine speed by 100 rpm. Holding the throttle speed set switch for more than 250 milliseconds will decrease the desired engine speed at a rate of 700 rpm per second.Note: Actual engine speed may ramp at a