0383524 EVINRUDE PISTON, Less rings, standard

INSTALL FUEL PRIMING PUMP
1. Put priming pump (1) and the gasket in position and install the clamp and bolts to hold it.2. Open the fuel supply line to the engine. REMOVE FUEL TRANSFER PUMP
1. Close the fuel supply line to the engine.2. Disconnect fuel lines (2) from fuel transfer pump (1).3. Remove the four bolts to remove fuel transfer pump (1) from the engine INSTALL FUEL TRANSFER PUMP
1. Make a replacement of the O-ring seal on the fuel transfer pump if necessary. Put clean engine oil on the seal.2. Put fuel transfer pump (1) in position on the engine oil pump. Make sure the drive coupling for the fuel transfer pump is engaged correctly with the engine oil pump shaft.3. Install the bolts that hold the fuel transfer pump.4. Connect fuel lines (2) to fuel transfer pump (1).5. Open the fuel supply line to the engine and use the fuel priming pump to remove (bleed) the air from the system. DISASSEMBLE FUEL TRANSFER PUMP
start by:a) remove fuel transfer pump1. Pull drive coupling (2) from the pump shaft.2. Remove O-ring seal (1) from the pump.3. Remove cap (6), seal washer (5), spring (4) and relief valve poppet (3) from the pump bracket assembly.4. Remove bolts (7) and remove pump head (8) from plate (9).5. If necessary, remove check valve (10) from head (8).6. Remove plate (9) from the pump casing.7. Remove gasket (11) and the O-ring seal from the opposite side of plate (9).8. If necessary, remove the bearings from plate (9). 9. Remove gear assembly (12) and shaft assembly (13) from the pump bracket and casing (14).10. Remove casing (14) and sleeved (15) from pump bracket (16).11. Remove the O-ring seal from casing (14).12. Remove outer seal (17) and inner seal (18) from bracket (16).13. If necessary, remove the two bearings from bracket (16). ASSEMBLE FUEL TRANSFER PUMP
1. Use tool group (A) to install the inner and outer lip type seals in bracket (1). Make sure the lips of the seals are in the position shown at assembly. Put clean engine oil on the lips of the seals. 2. Use tool group (A) to install bearings (2) 1.5 mm (.06 in) below the surface of bracket (1).3. Install sleeves (4) in bracket (1).4. Install O-ring seal (5) in casing (3) and put casing (3) over sleeves (4) on bracket (1).5. Install gear assembly (6) and shaft assembly (7) in the bracket and casing.6. Use tool group (A) to install bearings (8) 1.5 mm (.06 in) below the surface of plate (9).7. Install O-ring seal (10) in plate (9) and put plate (9) in position on the pump casing. 8. Use tool group (A) to install the check valve in head (11) until it makes contact with the shoulder in its bore. Make sure the spring on the check valve is toward the inside before it is installed.9. Put gasket (12) and head (11) in position on the plate and install the two bolts that hold the pump together.10. Install the relief valve poppet (13), spring (14), the seal washer and cap (15) in the pump.11. Install O-ring seal (16) around the pump and put clean engine oil on it.12. Install drive coupling (17) on the pump shaft.end by:a) install fuel transfer pump