0329682 EVINRUDE ROD, Spark advance

Introduction
This Special Instruction provides the procedure and the required parts to update rear engine mounts on the machines listed above. Improved rear engine mounts are used to obtain longer service life.Note: D11R machines that have been through the C32 repower program and are equipped with a C32 engine, can also utilize these improved rear engine mounts.Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Reference Section
Reference: Refer to the following:
Torque Specifications, SENR3130
D10T Track-Type Tractor Operation and Maintenance Manual, SEBU7764
D10T Track-Type Tractor Engine Supplement Disassembly and Assembly, RENR7544
D10T Track-Type Tractor Operation and Maintenance Manual, SEBU8708
D10T Track-Type Tractor Engine Supplement Disassembly and Assembly, UENR0088 and KENR5629
D11T Track-Type Tractor Operation and Maintenance Manual, SEBU8135 and SEBU8499
D11T Track-Type Tractor Engine Supplement Disassembly and Assembly, RENR8223, , KENR5617, and , UENR0080Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Failure to follow all safety guidelines prescribed in this document and by governing authorities and regulatory agencies may result in severe injury or death of personnel or machine damage.
When removing a major component or attachment, ensure that it is properly blocked or secured before removing mounting hardware. An assembly that is disconnected without proper blocking may shift or fall, resulting in serious injury or death of personnel or machine damage.
Personal injury or death can result from improper maintenance procedures. To avoid injury or death, follow the procedures exactly as stated below.
Personal injury can result from improper handling of chemicals.Make sure you use all the necessary protective equipment required to do the job.Make sure that you read and understand all directions and hazards described on the labels and material safety data sheet of any chemical that is used.Observe all safety precautions recommended by the chemical manufacturer for handling, storage, and disposal of chemicals.
Access to this service point may require climbing on the equipment. Slipping or falling while climbing on the equipment could result in personal injury or death. Refer to the Operation and Maintenance Manual, Mounting and Dismounting topic for safety information.
Personal injury or death can result from sudden movement.Prevent possible injury by performing the following procedures before work begins:Move the product or equipment to a smooth, level surface.When applicable, lower equipment/work tools to the ground.Engage the parking brake, system brakes and/or hydraulic lockout control. When applicable, stop the engine and remove the ignition key.Release system pressure from pressurized systems.If applicable, block the wheels/tracks.Turn the battery disconnect switch to the OFF position and if applicable, remove the battery disconnect key. If not equipped with a battery disconnect switch, disconnect the battery cables from the battery and tape the battery clamps. Attach a “Do Not Operate” or similar warning tag at the battery disconnect switch location and as defined by site rules and/or local regulations.
Illustration 1 g06276183
Do not operate the machine if any guards or covers are missing or inadequately secured. Personnel could be seriously injured or machine damage may occur.
Observe the safe working load limits of all lifting and blocking devices and keep a safe distance from suspended/blocked loads. Personnel may be seriously injured or killed by falling loads.
Required Parts
Table 1
Required Parts for D11T (S/N: GEB1-1021; TPB1-211; AMA1-920; JEL1-554; JNS1-135; MDG1-193) C32 Rear Engine Mount Update
Qty Part Number Part Name