0307191 EVINRUDE SCREW, Choke shaft retaining clip

Illustration 1 g00578242
Upper Display With SP Fault Code "SP1" Showing
Illustration 2 g00578243
System Schematic For Spare Fault InputsA spare fault informs the operator of an undesirable condition (fault) that exists. The spare inputs are programmed into the GSC+ to meet the requirements of the customer or application. An active spare input causes an alarm fault or shutdown fault. For programming of the spare inputs, see System Operation, "Spare Input/Output Programming OP6". It is the responsibility of the programmer (customer, operator, or service personnel) to make a note of the actual conditions that cause an SP fault code to be shown on the upper display. The GSC+ does not diagnose the spare inputs. Spare faults are not recorded in the fault log.The GSC+ treats an active input state as a fault. The active state is programmable on the GSC+ to be either a high or low (factory default) voltage level. A high level is within the range of +5 DCV to battery positive. If the input is left floating (for example an open switch), the GSC+ pulls the input voltage up to 10.5 DCV and the input is treated as high level. A low level on the input is "B-" (ground).When a spare fault occurs (is active), the GSC+ determines the type of fault (alarm or shutdown) and FLASHES the corresponding fault alarm indicator or fault shutdown indicator. For a shutdown type of fault, the SP fault code is immediately shown on the upper display. For an alarm type of fault, the alarm codes key is pressed first and then the SP fault code is shown on the upper display. After a spare fault is corrected or is not present, the SP fault code is no longer shown on the upper display.
Table 1
Spare Fault Codes    
Spare
Fault Code    GSC+
Connector
Contact    Terminal
Strip    Related
Setpoints (1)    
SP1
Spare Fault 1     23     SP1     SP01, SP02, SP03    
SP2
Spare Fault 2     24     SP2     SP04, SP05, SP06    
SP3
Spare Fault 3     25     SP3     SP07, SP08, SP09    
SP4
Spare Fault 4     29     SP4     SP10, SP11, SP12    
( 1 ) See System Operation, "Spare Input/Output Programming OP6".SP fault codes are associated with the spare inputs. The SP fault code shown on the upper display, identifies the spare input that caused the alarm fault or shutdown fault. The spare inputs are accessed on the terminal strip within the control panel on the rear wall.When an SP fault code is showing on the upper display, check the programming notes (made by the customer, operator, or service personnel) to determine the cause.The spare fault inputs can be used with factory and/or customer installed options. The factory options for the spare fault input are: ground fault, low fuel level, high fuel level, high generator winding temperature and high generator bearing temperature. Each of these options will include a dedicated indicator and a label on the custom alarm module.Troubleshooting Procedure
In order to troubleshoot spare faults, use the following general procedure.
Check for obvious causes which are related to the device that is responsible for the spare fault.
Verify that the programming of the spare fault (alarm or shutdown) is appropriate for the application.
Check the function of the responsible device. Reset the fault by turning the engine control switch (ECS) to the OFF/RESET position. Verify that the fault is still present.
Disconnect the responsible device from the spare fault input and verify if the fault still exists.
Check the wiring to the corresponding spare fault input for an unwanted short to either battery negative ("B-") or battery positive ("B+").