0323516 EVINRUDE THRUST WASHER, Forward gear


0323516 THRUST WASHER, Forward gear EVINRUDE 150840S THRUST
0323516 THRUST WASHER, Forward gear EVINRUDE
Rating:
33

Buy THRUST WASHER, Forward gear 0323516 EVINRUDE genuine, new aftermarket parts with delivery
Number on catalog scheme: 62
 

Compatible models:

150840S   EVINRUDE

BRP EVINRUDE entire parts catalog list:

150840S, 150849S, 175840C, 175840S, 200840R, 200849R, 235840R, 235849R 1978

Information:


Illustration 1 g03838252
Speed/timing sensor locations
(1) Primary speed/timing sensor
(2) Secondary speed/timing sensor
Illustration 2 g03838253
Speed/timing sensors
(1) Primary speed/timing sensor
(2) Secondary speed/timing sensorThe engine uses two engine speed/timing sensors. The primary speed/timing sensor is on the right-hand side of the flywheel housing. The primary speed/timing sensor generates a signal by detecting the movement of the holes around the rim of the flywheel. The signal that is generated by the speed/timing sensor is transmitted to the ECM. The ECM uses the signal from the speed/timing sensor to calculate the position of the crankshaft. The signal is also used to determine the engine speed.The secondary speed/timing sensor is on the front of the timing case. The secondary speed/timing sensor generates a signal that is related to the camshaft position. The secondary speed/timing sensor detects the movement of fingers on the front of the fuel pump gear. The signal that is generated by the speed/timing sensor is transmitted to the ECM. The ECM calculates the speed and the rotational position of the engine by using the signal. The secondary speed/timing sensor is required for starting purposes.During normal operation, the secondary speed/timing sensor is used to determine the cycle that the engine is on. When the timing has been established, the primary speed/timing sensor is then used to determine the engine speed and the angular position.The loss of signal to the primary sensor and/or the secondary sensor will result in one of the following faults:
The engine will continue to run when only one sensor signal is present from either the primary sensor or the secondary sensor.
Loss of signal both sensors during operation of the engine will cause fuel injection to be terminated and the engine will stop.
Illustration 3 g06010030
Schematic for the speed/timing sensors
Illustration 4 g03838321
Pinouts for the primary speed/timing sensor
(1) Primary speed signal -
(2) Primary speed signal +
Illustration 5 g03838413
Pinouts for the secondary speed/timing sensor
(1) Secondary speed signal +
(2) Sensor ground
(3) +5 VDCComplete the procedure in the order in which the steps are listed.
Table 2
Troubleshooting Test Steps Values Results
1. Inspect Electrical Connectors and Wiring
A. Turn the keyswitch to the OFF position.
B. Inspect the connectors for the speed/timing sensors. Refer to Troubleshooting, "Electrical Connectors - Inspect".
C. Perform a 45 N (10 lb) pull test on each of the wires in the suspect sensor connector and the sensor connections at the ECM.
D. Check the ground connection on the ECM for abrasions and pinch points.
E. Check the harness for abrasion and pinch points from the suspect sensor to the ECM.
F. Check that the suspect sensor is installed correctly. Check that the suspect sensor is fully seated into the engine.
Loose connection or damaged wire
Result: There is a fault in a connector or the wiring.
Repair: Repair any faulty connectors or replace the wiring harness. Ensure that all the seals are properly in place and ensure that the connectors are correctly coupled.
Use the electronic service tool to clear all logged diagnostic codes and verify that the repair eliminates the fault.
Result: All connectors, pins, and sockets are correctly coupled and/or inserted. The harness is free of corrosion, abrasion, and pinch points.
Proceed to Test Step 2.
2. Check For Active Diagnostic Codes
A. Turn the keyswitch to the OFF position.
B. Connect the electronic service tool to the diagnostic connector.
C. Turn the keyswitch to


Parts thrust EVINRUDE:

0314731
THRUST WASHER FORWARD AND REVERSE GEAR
0314731 THRUST WASHER FORWARD AND REVERSE GEAR
100193A, 100293R, 100990S, 115083D, 115393M, 115493B, 115593, 115693D, 115790S, 115793S, 115890C, 115983E, 125183C, 125283R, 135383M, 135443B, 135543E, 135643D, 150840S, 150940C, 175740S, 200640S, 85093B, 85193A, 85293R, 85393M, 85493B, 85593E, 85693
0384306
 
0384306 THRUST WASHER PACKAGE ASSEMBLY
100193A, 100293R, 100990S, 115083D, 115393M, 115493B, 115593, 115693D, 115790S, 115793S, 115890C, 125183C, 125283R, 135383M, 135443B, 150840S, 150940C, 50172S, 50202C, 50302R, 50442M, 50542B, 50902C, 55642E, 55772D, 55874S, 60072B, 60172C, 65272S, 65
0387656
THRUST BEARING,Pinion
0387656 THRUST BEARING,Pinion
100990S, 115693D, 115790S, 115793S, 115890C, 135643D, 150840S, 150940C, 175740S, 200640S, 85693D, BE115ELEDR, BE115ELEUA, BE115GLECM, BE115TLEDA, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE175EXECD, BE175EXEDB, BE175EXE
0320866
 
0320866 THRUST WASHER,Pivot shaft
100990S, 115790S, 115890C, 150840S, 150940C, 175740S, 200640S, 70873C, 70973R, BE115ELEDR, BE115ELEUA, BE115GLECM, BE115TLEDA, BE130TLECE, BE130TLEDM, BE130TLEUB, BE150ELECD, BE150ELEDB, BE150ELEUC, BE175EXECD, BE175EXEDB, BE175EXEUC, BE200CXECM, BE2
0320865
 
0320865 THRUST WASHER
100990S, 115790S, 115890C, 150840S, 150940C, 175740S, 200640S, 70873C, 70973R, E100MLCSC, E115MLCIH, E115MLCSA, E140MLCIH, E140MLCSA, E150TRLCIA, E150TRLCSF, E175TRLCIM, E175TRLCSA, E200TRLCIB, E200TRLCSF, E235TRLCIB, E235TRLCSM, E70ELCIH, E70ELCSA,
0321036
 
0321036 THRUST WASHER,Stern brkt.
100990S, 115790S, 115890C, 150840S, 150940C, 175740S, 200640S, 70873C, 70973R, E100MLCSC, E115MLCIH, E115MLCSA, E140MLCIH, E140MLCSA, E150TRLCIA, E150TRLCSF, E175TRLCIM, E175TRLCSA, E200TRLCIB, E200TRLCSF, E235TRLCIB, E235TRLCSM, E70ELCIH, E70ELCSA,
0387278
 
0387278 THRUST ROD ASSY.
100990S, 115790S, 115890C, 150840S, 150940C, 175740S, 200640S, 70873C, 70973R, C155WTLM, E100MLCSC, E100STLCCA, E100STLCEM, E100STLEIE, E100STLEND, E100STLESB, E100STLETS, E100WMLCDR, E100WMLCOC, E100WMLCRS, E100WTLCUA, E100WTLEIB, E100WTLENE, E100WT
0321499
 
0321499 THRUST PAD
100990S, 115790S, 115890C, 150840S, 150940C, 175740S, BE250CXECB, BE250CXEDA, BE250CXEUM, C155WTLM, CE275TLCDC, CE275TLCOS, CE300TLCDC, CE300TLCOS, E100MLCSC, E100STLCCA, E100STLCEM, E100STLESB, E100WMLCDR, E100WMLCOC, E100WMLCRS, E100WTLCUA, E100WTL
Back to top