F660664 Force WIRE (IGN. SWITCH TO ACC. TERMINAL BLOCK)


F660664 WIRE (IGN. SWITCH TO ACC. TERMINAL BLOCK) Force H0257F88A, H0257F88B, H0352F90B, H0352F90C, H0353E91A, H0353E91B, H0355D89A, H0356F89B, H0357C88B, H0357F88A, H0357F89C, H0357G90A, H0407E92C, H0504H88C, H0504H88D, H0505C89B, H0507A89C, H0507A89D, H0507A90A, H0507A90B, H0507A90C, H0507A90D, H0507A91 WIRE
F660664 WIRE (IGN. SWITCH TO ACC. TERMINAL BLOCK) Force
Rating:
13

Buy WIRE (IGN. SWITCH TO ACC. TERMINAL BLOCK) F660664 Force genuine, new aftermarket parts with delivery
Number on catalog scheme: 27
 

Force entire parts catalog list:

H0257F88A 1988,1989
H0257F88B 1988,1989,1991
H0352F90B 1990
H0352F90C 1990
H0353E91A 1991
H0353E91B 1991
H0355D89A 1989
H0356F89B 1989
H0357C88B 1988
H0357F88A 1988
H0357F89C 1989
H0357G90A 1990
H0407E92C 1992,1993,1994
H0504H88C 1988
H0504H88D 1988
H0505C89B 1989
H0507A89C 1989
H0507A89D 1989
H0507A90A 1990
H0507A90B 1990
H0507A90C 1990
H0507A90D 1990
H0507A91A 1991
H0507A91C 1991
H0507A92A 1992
H0507C87C 1987
H0507C88B 1988
H0507E91B 1991
H0507F88A 1988
H0507Z89B 1989
H0706A91B 1991,1992,1993,1994,1995
H0851X88A 1988
H0853F88B 1988,1989
H0856C87B 1987
H0903E91D 1991
H0903E91H 1991,1992,1993,1994
H0903F90B 1990
H0903F90C 1990
H0903F91A 1991
H0903F91C 1991
H0906A90A 1990
H1201A90A 1990,1991,1992,1993,1994
H1251A88A 1988
H1251A88B 1988
H1251A88C 1988
H1251A89A 1989
H1251A89B 1989
H1251A89C 1989
H1251A89D 1989
H1251A89E 1989
H1251F87B 1987
H1501E89A 1989,1990,1991,1992,1993,1994

Information:


Starting fluid is volatile and must be stored away from heat and direct sunlight. If an aerosol container is used, follow the instructions on the container.
1. Place the transmission in NEUTRAL (and disengage the flywheel clutch, if so equipped).2. Move throttle to low idle.3. Turn the key switch to ON.4. Turn the HEAT-START switch to HEAT or START, as indicated by the chart.5. After the indicated heat time, move the switch to the START position, and if starting fluid is necessary, discharge the starting fluid capsule or spray starting fluid into the air cleaner inlet. (If the engine fails to start within 30 seconds, release the starter switch and wait 2 minutes to allow the starter motor to cool before using it again.)6. As soon as the engine starts, allow the engine to idle 3 to 5 minutes or until the water temperature gauge has begun to rise. In cold temperature, turn the HEAT-START switch to the HEAT position until the engine runs smoothly at low idle.7. Do not apply load to the engine or increase engine speed until the oil pressure registers on the gauge. (Oil pressure should raise to normal within 15 seconds after the engine starts.)8. Operate the engine at low load until all systems reach operating temperatures. Check all gauges during warm-up period.Engines Not Equipped With Glow Plug Starting Aid
Caterpillar truck engines with direct injection (DI) are designed to start at temperatures above 10°F (-12°C) without using starting aids. If the temperature is below 10°F (-12°C), a starting aid may be necessary and/or crankcase oil may need to be heated. Jacket water heaters are often used to assist starting in cold temperatures.1. Place the transmission in NEUTRAL (and disengage the flywheel clutch, if so equipped).2. Move the throttle to low idle.3. Turn the starter switch to START. (If the engine fails to start within 30 seconds, release the starter switch and wait 2 minutes to allow the starter motor to cool before using it again.)4. As soon as the engine starts, allow the engine to idle for 3 to 5 minutes, or until the water temperature gauge has begun to rise.5. Do not apply load to the engine or increase engine speed until the oil pressure gauge indicates normal. (Oil pressure should raise within 15 seconds after the engine starts.)6. Operate the engine at low load until all systems reach operating temperatures. Check all gauges during the warm-up period. Gauges
Gauges provide a "look" inside the engine. Be sure they are in good working order. You can determine what is "normal" operating range by observing the gauges over a period of time. The cause of any sudden or significant change in the readings should be determined and corrected. Indicates the level of fuel in the tank. Electrically operated, it registers only when the key switch is ON. Indicator should register in the NORMAL (green) range. When the filter element becomes clogged, the indicator moves to OUT (red) 20 psi (140 kPa). When indicator registers below 20 psi, wash the primary fuel filter and replace the secondary fuel filter element. Indicates the rate of battery charge or discharge. Indicates engine RPM. Registers between 45 and 70 psi (310 and 480 kPa) when the engine is running at rated engine speed, with SAE 30 oil, at operating temperature. A lower pressure is normal at low idling speeds. If no pressure is indicated, stop the engine immediately. Normally registers between 170°F and 195°F (70°C and 90°C). Somewhat higher temperatures may occur under certain conditions.


Parts wire Force:

F345683
 
F345683 WIRE GROUND
H0356H75F, H0456B78J, H0456B79K, H0456B80L, H0457H82N, H0457H83P, H0503B83A, H0503H84B, H0507B85A, H0507C86A, H0507C87A, H0507F87B, H0507H81A, H0507H82B, H0555H74G, H0700H79A, H0709B79A, H0750H79A, H0756H80F, H0756H81G, H0756H82H, H0757B79E, H0757H75
F307683
 
F307683 WIRE, CIRCUIT BREAKER
H0356H75F, H0456B78J, H0456B79K, H0456B80L, H0457H82N, H0457H83P, H0503B83A, H0503H84B, H0504H88C, H0504H88D, H0504P89B, H0505C89B, H0507A89C, H0507A89D, H0507A90A, H0507A90B, H0507A90C, H0507A90D, H0507A91A, H0507A91C, H0507A92A, H0507B85A, H0507C86
F319908
 
F319908 WIRE, GROUND
H0504H88D, H0504P89B, H0505C89B, H0507A89C, H0507A89D, H0507A90A, H0507A90B, H0507A90C, H0507A90D, H0507A91A, H0507A91C, H0507A92A, H0507E91B, H0507Z89B, H0700H79A, H0709B79A, H0750H79A, H0756H80F, H0756H81G, H0756H82H, H0757B79E, H0758H80B, H0758H82
F640583-1
 
F640583-1 WIRE, RED
H0856C87B, H1251F87B
F684908-1
 
F684908-1 WIRE STARTER
H0504H88C, H0504H88D
F660908
 
F660908 WIRE, RED
H0851X88A, H0853F88B, H0903E91D, H0903E91H, H0903F90B, H0903F90C, H0903F91A, H0903F91C, H0906A90A, H1201A90A, H1251A88A, H1251A88B, H1251A88C, H1251A89A, H1251A89B, H1251A89C, H1251A89D, H1251A89E, H1501E89A
F684908-3
 
F684908-3 WIRE STARTER
H0352F90B, H0352F90C, H0353E91A, H0353E91B, H0504P89B, H0505C89B, H0507A89C, H0507A89D, H0507A90A, H0507A90B, H0507A90C, H0507A90D, H0507A91A, H0507A91C, H0507A92A, H0507E91B, H0507Z89B, H085LD89A, H085LD89B, H085LD89C, H090LD90B, H090LD90C, H090LD91
Back to top