90116-ZV1-000 Honda BOLT, RECESSED (5X8) (Honda Code 1986165).

Indicators and Gauges
The instrument panel may look like the instrument panel that is pictured in illustration 1 or the instrument panel may look like the instrument panel that is pictured in illustration 2. The instrument panel may not include all of the instruments that are shown in the illustration.
Illustration 1 g01233007
Illustration 2 g01459611
Warning Lamp (1) - There is a general fault in the engine. Refer to the Messenger display for any additional information that may be available.
Resetting the circuit breakers in a flammable atmosphere or a combustible atmosphere may lead to fire hazards or explosion hazards which may result in personal injury or death. DO NOT reset the circuit breaker when a flammable atmosphere or a combustible atmosphere is present and the power has not been removed from the equipment.
Circuit Breaker (2) - Reset the circuit breaker if a circuit breaker trips. Press the button in order to reset the circuit breaker. If the electrical system is working properly, the button will remain pressed. If the button does not remain pressed or if the circuit breaker trips soon after being reset, check the appropriate electrical circuit. Repair the electrical circuit, if necessary.
Diagnostic Lamp (3) - The diagnostic lamp is used to indicate the existence of a fault by flashing a fault code. For a more detailed discussion of the diagnostic lamp, please see this Operation and Maintenance Manual, "Diagnostic Lamp" topic.
Start Switch (4) - The start switch has three positions: OFF, RUN and START. When the start switch is turned clockwise to the RUN position, the lamps will flash for five seconds during the system test. The lamps will then shut off. In the RUN position, the ECM and electronic systems are powered up.
Idle Speed Switch (5) - When the switch is in the up position, the engine speed increases to HIGH IDLE. When the switch is in the down position, the engine speed decreases to LOW IDLE.
Service Meter (6) - This display indicates the total operating hours of the engine. Use the display in order to determine the service hour maintenance intervals. Hours of operation are logged in the ECM. A service tool is needed to retrieve the hours from the ECM.
Shutdown Switch (7) - Use the engine shutdown switch in order to stop the engine. Push the shutdown switch in order to put the switch in the OFF position. This will stop the engine. After the engine stops, turn the knob clockwise. This will reset the engine shutdown switch to the ON position.
Tachometer (8) - This gauge indicates engine speed (rpm). When the throttle control lever is moved to the full throttle position without load, the engine is running at high idle. The engine is running at the full load rpm when the throttle control lever is at the full throttle position with maximum rated load.
Voltmeter (9) - This gauge indicates the voltage of the electrical system. The needle in the red range indicates low voltage or high voltage.
Fuel Pressure (10) - This gauge indicates fuel pressure to the fuel injection pump from the fuel filter. A decrease in fuel pressure usually indicates a dirty fuel filter or a plugged fuel filter. As the fuel filter becomes plugged, there will be a noticeable reduction in the engine's performance.
Ammeter (11) - This gauge indicates the amount of electrical charge or of discharge in the battery charging circuit. Operation of the indicator should be to the right side of "0"(zero).