16622-ZV4-000 Honda ROD, CHOKE (Honda Code 2795219).

Introduction
The following procedure provides the needed information to install circuit protection for the engine prelubrication pump system on 797F Off-Highway Trucks. Completing the following procedure will help to protect the system against shorts to ground.For (S/N: LAJ1-230), refer to ""Procedure for (S/N: LAJ1-230)"".For (S/N: LAJ231-491; WSP1-124), refer to ""Procedure for (S/N: LAJ231-491; WSP1-124)"".Safety
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
When it is necessary to work under the machine with the body (bed) raised, attach the body (bed) retaining cable to the rear tow point. Install the rear tow point pin through the end of the retaining cable.Failure to properly secure the body (bed) may result in personal injury or death.
Falling Hazard. May cause personal injury or death. Always attach safety lanyard to appropriate fixing point.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Prepare the Machine
Note: Permit only one operator on the machine. Either keep other personnel away from the machine, or keep other personnel in the sight of the operator.
Refer to Operation and Maintenance Manual, SEBU8417, "Prepare the Machine for Maintenance".Procedure for (S/N: LAJ1-230)
Table 1
Required Parts for (S/N: LAJ1-230)    
Item     Qty     Part Number     Description    
1     1     263-6726     Seal Plug    
2     1     5P-6264     Grommet    
3     1     446-9282     Cable As    
4     1     7X-2544     Bolt    
5     5     7X-7729     Washer    
6     1     347-9210     Spacer    
7     2     8T-1889     Clip    
8     2     8T-1890     Clip    
9     2     177-4562     Grommet    
10     3     7K-1181     Cable Strap    
11     1     328-9944     Terminal Cover    
12     1     326-8116     Fuse    
13     2     264-3617     Lockwasher    
14     2     7X-0608     Hard Washer    
15     2     5C-7261     Nut    
16     1     267-2746     Cover As    
17     1     446-9281     Bracket As    
18     2     5C-9553     Bolt    
19     2     9X-8256     Washer    
20     3     8T-4136     Bolt    
21     3     344-5675     Nut    
22     2     8T-4121     Hard Washer    
23     1     144-6302     Bracket    
24     1     204-2281     Cable Strap    
Illustration 1 g03882110
View of the breaker box assembly
Remove the cover from the breaker box assembly. Retain the cover and all mounting hardware.