18333-ZY3-000 Honda SEE PART DETAILS - SUP; GASKET, EX. PIPE (Honda Code 6990766).


18333-ZY3-000 SEE PART DETAILS - SUP; GASKET, EX. PIPE (Honda Code 6990766). Honda BF200A2 LA, BF200A2 XA, BF200A2 XCA, BF200A2 XXA, BF200A2 XXCA, BF225A2 LA, BF225A2 XA, BF225A2 XCA, BF225A2 XXA, BF225A2 XXCA SEE
18333-ZY3-000 SEE PART DETAILS - SUP; GASKET, EX. PIPE (Honda Code 6990766). Honda
Rating:
83

Buy SEE PART DETAILS - SUP; GASKET, EX. PIPE (Honda Code 6990766). 18333-ZY3-000 Honda genuine, new aftermarket parts with delivery
Number on catalog scheme: 4
 

Honda entire parts catalog list:

BF200A2 LA 2002
BF200A2 XA 2002
BF200A2 XCA 2002
BF200A2 XXA 2002
BF200A2 XXCA 2002
BF225A2 LA 2002
BF225A2 XA 2002
BF225A2 XCA 2002
BF225A2 XXA 2002
BF225A2 XXCA 2002

Information:


Table 1
Description Conditions which Generate this Code System Response
E540(1) Low Engine Oil Refill Tank Level The switch closes when no fluid is present. The code is active. The low oil level switch signals the Electronic Control Module (ECM) if the oil level falls below a predetermined level in the oil pan. The ECM warns the operator of possible engine damage. The float closes a switch when the oil level is above a predetermined level.The ECM may modify the operation of the engine in the event of low oil level. The ECM cannot determine if the low oil level switch or associated components have failed.
Table 2
Troubleshooting Test Steps Values Results
1. Inspect the Electrical Connectors and the Wiring
A. Remove electrical power from the ECM.
B. Thoroughly inspect the connector for sensor. Also, thoroughly inspect ECM connector and all the connectors in the circuit. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
C. Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit for the oil level sensor.
Electrical Connectors and Wiring
Result: The harnesses and the wiring appear to be OK.
Proceed to Test Step 2.
Result: There is a problem with the connectors and/or the wiring.
Repair: Repair the wiring and connectors or replace the wiring or the connectors. Ensure that all the seals are properly connected. Verify that the repair eliminates the problem.
If the repair does not eliminate the problem, proceed to Test Step 2.
2. Check the Level of the Engine Oil
A. Ensure that the correct engine oil dipstick is installed.
B. Check the engine oil level.
Oil Level
Result: The engine oil level is correct.
Proceed to Test Step 3.
Result: The engine oil level is low.
Repair: Add oil to the engine.
If the repair does not eliminate the problem, proceed to Test Step 3.
3. Check the Engine Oil Level on Cat Electronic Technician (ET)
A. Connect Cat ET to the service tool connector.
B. Turn the keyswitch to the ON position.
C. Observe the "Engine Oil Level" reading on Cat ET.
Level
Result: The "Engine Oil Level" reads "OK".
Repair: The switch signal is correct.
Result: The "Engine Oil Level" does not read "OK".
The switch signal is not correct.
Repair: Repair or replace the switch.
If the repair does not eliminate the problem, proceed to Test Step 4.
4. Short the Wires at the Low Oil Level Switch
A. Turn the keyswitch to the OFF position.
B. Disconnect the connector for the low oil level switch.
C. Use a wire to short terminal 1 to terminal 2. Install the wire jumper on the harness side of the connector.
D. Turn the keyswitch to the ON position.
E. Observe the status of the "Engine Oil Level" on Cat ET.
F. Remove the wire short.
G. Observe the status of the "Engine Oil Level" on Cat ET.
H. Turn the keyswitch to the OFF position.
Short
Result: Cat ET indicates "OK", when the wire short is in place. Cat ET indicates "LOW", when the wire short is removed. Cat ET recognized the input from the switch.
Repair: Temporarily replace the switch. Verify that a new switch solves the problem before you permanently install the new switch.
Result: Cat ET does not indicate "OK", when the wire short is in place. Cat ET does not indicate "LOW", when the wire short is removed. Cat ET does not recognize the input from the switch.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).


Parts see Honda:

36187-ZV4-651
SEE PART DETAILS - SUP; CLIP, EMERGENCY LOCK (Honda Code 3749231).
36187-ZV4-651 SEE PART DETAILS - SUP; CLIP, EMERGENCY LOCK (Honda Code 3749231).
BF115A1 LA, BF115A1 LCA, BF115A1 XA, BF115A1 XCA, BF115A2 LA, BF115A2 LCA, BF115A2 XA, BF115A2 XCA, BF115A3 LA, BF115A3 LCA, BF115A3 XA, BF115A3 XCA, BF115A4 LA, BF115A4 LCA, BF115A4 XA, BF115A4 XCA, BF115A5 LA, BF115A5 LCA, BF115A5 XA, BF115A5 XCA,
94301-08140
SEE PART DETAILS - PRI;  PIN A, DOWEL (8X14) (Honda Code 0069310).
94301-08140 SEE PART DETAILS - PRI; PIN A, DOWEL (8X14) (Honda Code 0069310).
BF115A1 LA, BF115A1 LCA, BF115A1 XA, BF115A1 XCA, BF115A2 LA, BF115A2 LCA, BF115A2 XA, BF115A2 XCA, BF115A3 LA, BF115A3 LCA, BF115A3 XA, BF115A3 XCA, BF115A4 LA, BF115A4 LCA, BF115A4 XA, BF115A4 XCA, BF115A5 LA, BF115A5 LCA, BF115A5 XA, BF115A5 XCA,
36182-ZV4-651
SEE PART DETAILS - PRI; WIRE, EMERGENCY (Honda Code 8576969).
36182-ZV4-651 SEE PART DETAILS - PRI; WIRE, EMERGENCY (Honda Code 8576969).
BF115A1 LA, BF115A1 LCA, BF115A1 XA, BF115A1 XCA, BF115A2 LA, BF115A2 LCA, BF115A2 XA, BF115A2 XCA, BF115A3 LA, BF115A3 LCA, BF115A3 XA, BF115A3 XCA, BF115A4 LA, BF115A4 LCA, BF115A4 XA, BF115A4 XCA, BF115A5 LA, BF115A5 LCA, BF115A5 XA, BF115A5 XCA,
35370-ZW7-U02
SEE PART DETAILS - PRI; SWITCH ASSY., POWER TRIM-TILT (Honda Code 7207046).
35370-ZW7-U02 SEE PART DETAILS - PRI; SWITCH ASSY., POWER TRIM-TILT (Honda Code 7207046).
BF115A1 LA, BF115A1 LCA, BF115A1 XA, BF115A1 XCA, BF115A2 LA, BF115A2 LCA, BF115A2 XA, BF115A2 XCA, BF115A3 LA, BF115A3 LCA, BF115A3 XA, BF115A3 XCA, BF115A4 LA, BF115A4 LCA, BF115A4 XA, BF115A4 XCA, BF115A5 LA, BF115A5 LCA, BF115A5 XA, BF115A5 XCA,
90017-ZY3-000
SEE PART DETAILS - PRI; BOLT, FLANGE (6X16)
90017-ZY3-000 SEE PART DETAILS - PRI; BOLT, FLANGE (6X16)
BF115A2 LA, BF115A2 LCA, BF115A2 XA, BF115A2 XCA, BF115A3 LA, BF115A3 LCA, BF115A3 XA, BF115A3 XCA, BF115A4 LA, BF115A4 LCA, BF115A4 XA, BF115A4 XCA, BF115A5 LA, BF115A5 LCA, BF115A5 XA, BF115A5 XCA, BF115A6 LA, BF115A6 LCA, BF115A6 XA, BF115A6 XCA,
11381-ZY3-013
 
11381-ZY3-013 SEE PART DETAILS - PRI; GASKET, OIL PAN (Honda Code 8567380).
BF175AK1 LA, BF175AK1 XA, BF175AK1 XCA, BF175AK2 LA, BF175AK2 XA, BF175AK2 XCA, BF200A2 LA, BF200A2 XA, BF200A2 XCA, BF200A2 XXA, BF200A2 XXCA, BF200A3 LA, BF200A3 XA, BF200A3 XCA, BF200A3 XXA, BF200A3 XXCA, BF200A4 LA, BF200A4 XA, BF200A4 XCA, BF200
17374-ZY3-010
SEE PART DETAILS - PRI; GROMMET, MUFFLER
17374-ZY3-010 SEE PART DETAILS - PRI; GROMMET, MUFFLER
BF175AK1 LA, BF175AK1 XA, BF175AK1 XCA, BF175AK2 LA, BF175AK2 XA, BF175AK2 XCA, BF200A2 LA, BF200A2 XA, BF200A2 XCA, BF200A2 XXA, BF200A2 XXCA, BF200A3 LA, BF200A3 XA, BF200A3 XCA, BF200A3 XXA, BF200A3 XXCA, BF200A4 LA, BF200A4 XA, BF200A4 XCA, BF200
41112-ZY3-010
SEE PART DETAILS - PRI; SHAFT, VERTICAL (L)
41112-ZY3-010 SEE PART DETAILS - PRI; SHAFT, VERTICAL (L)
BF175AK1 LA, BF175AK2 LA, BF200A2 LA, BF200A2 XCA, BF200A3 LA, BF200A3 XCA, BF200A4 LA, BF200A5 LA, BF200AK1 LA, BF200AK2 LA, BF225A2 LA, BF225A2 XCA, BF225A3 LA, BF225A3 XCA, BF225A4 LA, BF225A5 LA, BF225AK1 LA, BF225AK2 LA
Back to top