90604-ZY3-000 Honda SEE PART DETAILS - SUP; CLAMP, TUBE (D21)

operation or any maintenance procedures are performed.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments , using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption , service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions , fuel type , oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual , "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual , "Maintenance Recommendations" .When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Drive Shaft Universal Joints - Lubricate
Engine - Clean
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Heat Exchanger - Inspect
Maintenance Recommendations
Overhaul (Major)
Overhaul (Top End)
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fumes Disposal Filter Service Indicator - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every 50 Service Hours or Weekly
Aftercooler Condensate Drain Valve - Inspect/Clean
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Check
Injector Bolt Torque - Inspect
Every 250 Service Hours
Drive Shaft Slip Joint - Lubricate
Drive Shaft Universal Joints - Lubricate
Every 7100 L (1875 US gal) of Fuel or 250 Service Hours or 1 Year
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every Year
Coolant Sample (Level 2) - Obtain
Every 14 200 L (3750 US gal) of Fuel or 500 Service Hours
Coolant Sample (Level 1) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Valve Lash - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 21 300 L (5625 US gal) of Fuel or 750 Service Hours or 1 Year
Fumes Disposal Filter Element - Replace
Every 28 400 L (7500 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Engine Crankcase Breather - Clean