5036756 ARM, CLUTCH ROD JOHNSON
J10BL4SUM, J10EL4SDA, J10R4SDM, J10R4SUB, J10RL4SDM, J10TBL4SDE, J10TBL4SUD, J10TE4SDM, J15EL4SDC, J15EL4SUR, J15R4SDM, J15R4SUB, J15RL4SDM, J15TE4SDM, J15TE4SUB
ARM
Price: query
Rating:
Compatible models:
BRP JOHNSON entire parts catalog list:
- SHIFT LINKAGE » 5036756
J10R4SDM 2006
J10R4SUB, J10RL4SUB 2007
J10RL4SDM 2006
J10TBL4SDE 2006
J10TBL4SUD, J10TE4SUB, J10TEL4SUB 2007
J10TE4SDM, J10TEL4SDM 2006
J15EL4SDC 2006
J15EL4SUR 2007
J15R4SDM 2006
J15R4SUB, J15RL4SUB 2007
J15RL4SDM 2006
J15TE4SDM, J15TEL4SDM 2006
J15TE4SUB, J15TEL4SUB 2007
Information:
Table 1
J1939 Code and Description CDL Code and Description System Response
101-0
Engine Crankcase Pressure : High - most severe (3) E101 (3)
High Crankcase Pressure Warning The engine crankcase pressure is higher than a threshold.
101-15
Engine Crankcase Pressure : High - least severe (1) E101 (1)
High Crankcase Pressure Warning The engine crankcase pressure is higher than a threshold.
101-16
Engine Crankcase Pressure : High - moderate severity (2) E101 (2)
High Crankcase Pressure Warning The engine crankcase pressure is higher than a threshold. Probable Causes
Engine oil
Plugged CCV system
Clogged CCV filter
Sensor
Engine componentsRecommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in the order of the listed test steps.
Table 2
Troubleshooting Test Steps Values Results
1. Check the Engine Oil Level
Oil Level
Result: The engine oil level is OK.
Proceed to Test Step 2.
Result: The engine oil level is high.
Repair: Troubleshoot and repair the cause of the incorrect oil level.
If the problem is not resolved, proceed to Test Step 2.
2. Check for Plugged CCV System or Clogged Filters
A plugged CCV system or clogged filter will cause excessive crankcase pressure.
Plugged Crankcase Breather
Result: The crankcase breathers are NOT OK.
Repair: Replace the fumes disposal filter according to the Operation and Maintenance Manual, "Engine Crankcase Breather - Clean".
Result: The crankcase breathers are OK.
Proceed to Test Step 3.
3. Check for a Faulty Pressure Sensor
A. Connect Cat® Electronic Technician (ET) to the service tool connector.
B. Turn the keyswitch to the ON position. Do not start the engine.
C. Remove the oil filler cap.
D. Monitor the crankcase pressure and the atmospheric pressure in Cat ET.
Crankcase Pressure Sensor
Result: The crankcase pressure is within 3.5 kPa (0.5 psi) of the atmospheric pressure.
Proceed to Test Step 4.
Result: The crankcase pressure is not within 3.5 kPa (0.5 psi) of the atmospheric pressure.
Repair: Replace the crankcase pressure sensor.
If the problem is not resolved, proceed to Test Step 4.
4. Internal Engine Problem
Damaged pistons or rings can cause too much pressure in the crankcase. This condition will cause the engine to run rough. There will be more than the normal quantity of fumes (blowby) entering the crankcase breathers. The crankcase breathers can then more quickly become restricted, causing oil leakage at gaskets and seals that would not normally have leakage. Blowby can also be caused by worn valve guides or by a failed turbocharger seal.
A. To determine whether the piston rings leak, measure the crankcase blowby.
B. Perform the Compression Test using Cat ET. Refer to Testing and Adjusting, "Compression - Test" for additional information.
Damaged or Worn Engine Parts
Result: There are worn or damaged engine parts.
Repair: Repair or replace the worn or damaged parts.
Result: At least one cylinder has been identified as having low compression.
Repair: Identify the cause of the low compression. Possible causes of low compression include the following:
- Faulty piston
- Faulty piston rings
- Worn cylinder bores
- Worn valves
- Faulty cylinder head gasket
- Damaged cylinder head
Perform the necessary repairs.
Result: The compression for each cylinder is OK.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).
Parts arm JOHNSON:
5033071
5033071 ARM ASSY, ROCKER
J10BL4SUM, J10EL4SDA, J10EL4SOR, J10EL4SRC, J10R4SDM, J10R4SNF, J10R4SR, J10R4STC, J10R4SUB, J10RL4SDM, J10TBL4SDE, J10TBL4SUD, J10TE4SDM, J15EL4SDC, J15EL4SOS, J15EL4SUR, J15R4SDM, J15R4SNF, J15R4SR, J15R4STC, J15R4SUB, J15RL4SDM, J15RL4SR, J15TE4SD
5036298
5036298 ARM, REVERSE LOCK
J10BL4SUM, J10EL4SDA, J10EL4SOR, J10R4SDM, J10R4SUB, J10RL4SDM, J10TBL4SDE, J10TBL4SUD, J10TE4SDM, J15EL4SDC, J15EL4SOS, J15EL4SUR, J15R4SDM, J15R4SUB, J15RL4SDM, J15TE4SDM, J15TE4SUB
5036306
5036306 ARM, SHALLOW DRIVE
J10BL4SUM, J10EL4SDA, J10EL4SOR, J10R4SDM, J10R4SUB, J10RL4SDM, J10TBL4SDE, J10TBL4SUD, J10TE4SDM, J15EL4SDC, J15EL4SOS, J15EL4SUR, J15R4SDM, J15R4SUB, J15RL4SDM, J15TE4SDM, J15TE4SUB