0321218 JOHNSON CLAMP,Choke solenoid


0321218 CLAMP,Choke solenoid JOHNSON 150TL78S, 150TL79C, 175TL77S, 175TL78C, 175TL79R, 200TL76S, 200TL77C, 200TL78R, 200TL79A, 235TL70A, 235TL78R, J100MLCSC, J115MLCIH, J115MLCNB, J115MLCSA, J115MLCTE, J140MLCIH, J140MLCNB, J140MLCSA, J140MLCTE, J150STLCTE, J150TLCIA, J150TLCNM, J150TLC CLAMP
0321218 CLAMP,Choke solenoid JOHNSON
Rating:
53

Buy CLAMP,Choke solenoid 0321218 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 44
 

BRP JOHNSON entire parts catalog list:

150TL78S, 150TXL78S 1978
150TL79C, 150TXL79C 1979
175TL77S, 175TXL77S 1977
175TL78C, 175TX78C 1978
175TL79R, 175TXL79R 1979
200TL76S, 200TXL76S 1976
200TL77C, 200TXL77C 1977
200TL78R, 200TX78R 1978
200TL79A, 200TXL79A 1979
235TL70A, 235TXL79A 1979
235TL78R, 235TX78R 1978
J100MLCSC, J100TRLCSC, J100TRXCSC 1980
J115MLCIH, J115MLCIM, J115TLCIH, J115TLCIM, J115TXCIH, J115TXCIM 1981
J115MLCNB, J115TLCNB, J115TXCNB 1982
J115MLCSA, J115TLCSA, J115TXCSA 1980
J115MLCTE, J115TLCTE, J115TXCTE 1983
J140MLCIH, J140MLCIM, J140TLCIH, J140TLCIM, J140TXCIH, J140TXCIM 1981
J140MLCNB, J140TLCNB, J140TXCNB 1982
J140MLCSA, J140TLCSA, J140TXCSA 1980
J140MLCTE, J140TLCTE, J140TXCTE 1983
J150STLCTE 1983
J150TLCIA, J150TLCIH, J150TXCIA, J150TXCIH 1981
J150TLCNM, J150TXCNM 1982
J150TLCSF, J150TLCSR, J150TXCSF, J150TXCSR 1980
J150TLCTB, J150TLCTE, J150TXCTB, J150TXCTE 1983
J175TLCIH, J175TLCIM, J175TXCIH, J175TXCIM 1981
J175TLCNB, J175TXCNB 1982
J175TLCSA, J175TLCSF, J175TXCSA, J175TXCSF 1980
J175TLCTD, J175TLCTE, J175TXCTD, J175TXCTE 1983
J200TLCIH, J200TXCIB, J200TXCIH 1981
J200TLCNE, J200TXCNE 1982
J200TLCSF, J200TLCSM, J200TXCSF, J200TXCSM 1980
J200TLCTD, J200TLCTS, J200TXCTD, J200TXCTS 1983
J235STLCTS 1983
J235TLCIB, J235TLCIH, J235TXCIB, J235TXCIH 1981
J235TLCNE, J235TXCNE 1982
J235TLCSM, J235TXCSM 1980
J235TLCTD, J235TLCTS, J235TXCTD, J235TXCTS 1983
J50BECTA, J50BELCTA, J50TELCTA 1983
J60ECTB, J60ELCTB, J60TLCTB 1983
J85MLCSA, J85TLCSA, J85TXCSA 1980
J90MLCIH, J90MLCIM, J90TLCIH, J90TLCIM, J90TXCIH, J90TXCIM 1981
J90MLCNB, J90TLCNB, J90TXCNB 1982
J90MLCTE, J90TLCTE, J90TXCTE 1983

Information:


Illustration 1 g00809892
Note: The Engine Control Switch (ECS) is mounted within an instrument panel that is located on the right side of the engine. The ECS is locked into the AUTO position with a pin. The pin must be removed in order to perform this test. After performing this test, ensure that the ECS is placed in the AUTO position and that the locking pin has been reinstalled.Test Step 1. Check for Connector Damage.
Disconnect the main power.
Thoroughly inspect the ECM connectors J1/P1 and J2/P2. Inspect all of the other connectors. Refer to the diagnostic functional test Troubleshooting, "Inspecting Electrical Connectors" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the circuit.
Check the ECM connector (allen head screw) for the proper torque of 6.0 N m (55 lb in).
Check the customer connector (allen head screw) for the proper torque of 2.25 0.25 N m (20 2 lb in).
Check the harness and the wiring for abrasion and pinch points.Expected Result:All connectors, pins, and sockets are completely coupled and/or inserted, and the harness and wiring should be free of corrosion, of abrasion or of pinch points.Results:
OK - The connectors and wiring are okay. Proceed to test step 2.
Not OK - The connectors and/or wiring need repair.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Stop.Test Step 2. Attempt to Start the Engine
Turn the circuit breaker for the battery to the ON position.
Connect the Cat ET to the service tool connector.
Turn the ECS to the STOP position.
Observe the "startup mode" parameters on the Cat ET status screen.
Turn the ECS to the START position. Continue monitoring engine parameters as the engine cranks.
The crank cycle will continue for the time that is equal to the cycle crank time that has been programmed or the crank cycle will continue until the engine speed reaches the crank terminate speed.Expected Result:The status screen for the "startup mode" parameter should display "CRANK". The engine cranks.Results:
OK - The "startup mode" parameter on the status screen on the Cat ET displays "CRANK". The engine cranks.Repair: The circuit is working properly. Check for active diagnostic codes. Stop.
Not OK-Engine Doesn't Crank - The "startup mode" parameter on the status screen on the Cat ET displays "CRANK". The engine will not crank. Proceed to test step 3.
Not OK-Status Screen - The "startup mode" parameter on the status screen on the Cat ET does not display "CRANK".Repair: Perform the diagnostic functional test Troubleshooting, "Engine Control Switch (ECS)". Stop.Test Step 3. Manually Crank the Engine.
Turn the ECS to the STOP position.
Open the electronic instrument panel.
Connect one end of a voltmeter to - Battery terminal. Connect the other end of the voltmeter to wire 304-WH on terminal 2 of


Parts clamp JOHNSON:

0309041
 
0309041 CLAMP
100ESL71A, 100ESL72R, 115EL77S, 115ESL69E, 115ESL70D, 115ESL74B, 115ESL75E, 115ETZ78C, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 150TL78S, 175TL77S, 175TL78C, 200TL76S, 200TL77C, 200TL78R, 235TL78R, 25E72R, 25E73A, 25
0311218
 
0311218 CLAMP,Solenoid
100ESL71A, 100ESL72R, 100ML79S, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 150TL78S, 150TL79C, 175TL77S, 175TL7
0310440
 
0310440 CLAMP
100ESL71A, 100ML79S, 10E77A, 10E78M, 10EL79B, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 150TL78S, 150TL79C, 15E77M, 15E78
0318607
 
0318607 CLAMP,Cable casing guide
115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115TXL77S, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 150TL78S, 175TL77S, 175TL78C, 200TL76S, 200TL77C, 200TL78R, 235TL78R, 50ES73R, 50ES74M, 50ES75B, 55E76E, 55E77D, 55E78S, 65ES73R, 70
0318294
 
0318294 CLAMP,Instrument cable
115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115TXL77S, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 150TL78S, 175TL77S, 175TL78C, 200TL76S, 200TL77C, 200TL78R, 235TL78R, 50ES73R, 50ES74M, 50ES75B, 55E76E, 55E77D, 55E78S, 65ES73R, 70
0318319
 
0318319 CLAMP,Cable
115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 115TXL77S, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 150TL78S, 175TL77S, 175TL78C, 200TL76S, 200TL77C, 200TL78R, 235TL78R, 50ES73R, 50ES74M, 50ES75B, 55E76E, 55E77D, 55E78S, 65ES73R, 70EL76D, 70EL77S, 70EL7
0324825
 
0324825 CLAMP, Cylinder head hose
100ML79S, 115ML79R, 140ML79R, 85ML79R, BJ250CXECB, D100WTLM, J100MLCSC, J100STLCCA, J100STLCEM, J100STLEIE, J100STLEND, J100STLESB, J100WMLCDR, J100WMLCOC, J100WMLCRS, J100WTLCUA, J100WTLEIB, J100WTLENE, J100WTLESM, J100WTLZ, J110MLCCA, J110MLCDC, J1
0511741
 
0511741 CLAMP, Timer leads
100ML79S, 115ML79R, 140ML79R, 85ML79R, J100MLCSC, J115MLCIH, J115MLCNB, J115MLCSA, J140MLCIH, J140MLCNB, J140MLCSA, J85MLCSA, J90MLCIH, J90MLCNB
Back to top