0350241 *DECAL, "JOHNSON", Port/Stbd JOHNSON
J150CXSNF, J150CXSTA, J150GLSDE, J150GLSOB, J150GLSRM, J150GLSTA, J150GLSTF, J175CXSNF, J175CXSTA, J175GLSDE, J175GLSOB, J175GLSRM, J175GLSTA, J175GLSTF, J175MXSRC
DECAL
Price: query
Compatible models:
BRP JOHNSON entire parts catalog list:
- ENGINE COVER » 0350241
J150GLSDE 2006
J150GLSOB 2004,2005
J150GLSRM 2004
J150GLSTA, J150PLSTM, J150PXSTM 2003
J150GLSTF 2003
J175CXSNF, J175PLSNF, J175PXSNF, J175VLSNF 2002
J175CXSTA 2003
J175GLSDE 2006
J175GLSOB 2004,2005
J175GLSRM 2004
J175GLSTA, J175PLSTM, J175PXSTM 2003
J175GLSTF 2003
J175MXSRC 2004
Information:
Service or repair of the engine cooling system must be performed on level ground. The engine must be level in order to check the coolant level. The engine must be level in order to avoid the risk of introducing an air lock into the coolant system.
Drain
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure.
Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap.
Illustration 1 g02513896
Typical example
Remove the drain plug (1) on the engine. Open the drain cock or remove the drain plug on the radiator. Allow the coolant to drain.
Illustration 2 g03732615
For radiators installed by the engine manufacturer, remove the drain plug (2) from radiator (3) and allow coolant to drain. After the system has been flushed, install the drain plug to a torque of 6 N m (53 lb in).
Dispose of used engine coolant properly or recycle. Various methods have been proposed to reclaim used coolant for reuse in engine cooling systems. The full distillation procedure is the only method acceptable by Caterpillar to reclaim the used coolant.
For information regarding the disposal and the recycling of used coolant, consult your Cat dealer.Flush
Flush the cooling system with clean water in order to remove any debris.
Clean the drain plugs. Install the drain plugs. Refer to Torque Specifications, SENR3130 for more information on the correct torques.
Do not fill the cooling system faster than 5 L (1.3 US gal) per minute to avoid air locks.Cooling system air locks may result in engine damage.
Fill the cooling system with clean water. Install the cooling system filler cap.
Start and run the engine at low idle until the temperature reaches 49 to 66 °C (120 to 150 °F).
Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. Remove the cooling system drain plugs. Allow the water to drain. Flush the cooling system with clean water. Clean the drain plugs. Install the drain plugs. Refer to Torque Specifications, SENR3130 for more information on the correct torques. Fill
Do not fill the cooling system faster than 5 L (1.3 US gal) per minute to avoid air locks.Cooling system air locks may result in engine damage.
Fill the cooling system with Extended Life Coolant (ELC). Refer to this Operation and Maintenance Manual, "Refill Capacities and Recommendations" topic (Maintenance Section) for more information on cooling system specifications. Do not install the cooling system filler cap.
Start and run the engine at low idle. Increase the engine rpm to high idle. Operate the engine in order to open the engine thermostat. An open thermostat will allow any air in the system to be purged. Decrease the engine speed to low idle. Stop the engine.
Maintain the coolant level at the maximum mark that is correct for your application.
Clean the cooling system filler cap. Inspect the gasket that is on the cooling system filler cap. If the gasket that is on the cooling system filler cap is damaged, discard the old cooling system filler cap and install a new cooling system filler cap. If the gasket that is on the cooling system filler cap is not damaged, use a 9S-8140 Pressurizing Pump in order to pressure test the cooling system filler cap. The correct pressure for the cooling system filler cap is stamped on the face of the cooling system filler cap. If the cooling system filler cap does not retain the correct pressure, install a new cooling system filler cap.
Start the engine. Inspect the cooling system for leaks and for proper operating temperature.
Parts decal JOHNSON:
0350165
0350165 *DECAL, "BOMBARDIER", F/R
J115GLSTA, J115PLSNF, J115PLSOR, J115PLSRC, J115PXSOR, J115PXSRM, J150CXSNF, J150CXSOB, J150CXSRM, J150CXSTA, J150GLSTA, J150PLSOE, J150PLSRB, J150PLSTF, J150PXSOE, J150PXSRB, J175CXSNF, J175CXSOB, J175CXSRM, J175CXSTA, J175GLSTA, J175PLSOE, J175PLSR
0350231
0350231 *DECAL, "BOMBARDIER", F/R
J105WPLSTM, J115GLSOB, J115GLSRC, J115GLSTA, J115PLSNF, J115WPLSOC, J115WPLSRS, J150CXSNF, J150CXSTA, J150GLSOB, J150GLSRM, J150GLSTA, J150GLSTF, J175CXSNF, J175CXSTA, J175GLSOB, J175GLSRM, J175GLSTA, J175GLSTF, J175MXSRC, J90GLSOB, J90GLSRM, J90GLST
0350189
0350189 *DECAL, "JOHNSON", Front/Rear
J115GLSTA, J115PLSDA, J115PLSNF, J115PLSOR, J115PLSRC, J115PXSDA, J115PXSOR, J115PXSRM, J150CXSDE, J150CXSNF, J150CXSOB, J150CXSRM, J150CXSTA, J150GLSTA, J150PLSDD, J150PLSOE, J150PLSRB, J150PLSTF, J150PXSDD, J150PXSOE, J150PXSRB, J175CXSDE, J175CXSN
0350184
0350184 *DECAL, "JOHNSON", Port/Stbd
J150CXSDE, J150CXSNF, J150CXSOB, J150CXSRM, J150CXSTA, J150GLSTA, J150PLSDD, J150PLSOE, J150PLSRB, J150PLSTF, J150PXSDD, J150PXSOE, J150PXSRB, J175CXSDE, J175CXSNF, J175CXSOB, J175CXSRM, J175CXSTA, J175GLSTA, J175PLSDD, J175PLSOE, J175PLSRB, J175PLST
0350380
0350380 DECAL, "175"
J150CXSTA, J150GLSTA, J150MLSOR, J150MLSRC, J150MLSTS, J175CXSTA, J175GLSTA, J175MXSOR, J175MXSRC, J175MXSTS
0350396
0350396 DECAL, "150"
J150CXSTA, J150GLSTA, J150MLSOR, J150MLSRC, J150MLSTS, J175CXSTA, J175GLSTA, J175MXSOR, J175MXSRC, J175MXSTS
0350393
0350393 DECAL, "BOMBARDIER", Rear
J150CXSTA, J150GLSTA, J150MLSOR, J150MLSRC, J150MLSTS, J175CXSTA, J175GLSTA, J175MXSOR, J175MXSRC, J175MXSTS
0350957
0350957 DECAL, Spark advance
J150CXSOB, J150CXSRM, J150CXSTA, J150GLSOB, J150GLSRM, J150GLSTA, J150GLSTF, J150MLSRC, J150MLSTS, J150PLSOE, J150PLSRB, J150PLSTF, J150PXSOE, J150PXSRB, J175CXSOB, J175CXSRM, J175CXSTA, J175GLSOB, J175GLSRM, J175GLSTA, J175GLSTF, J175MXSRC, J175MXST