0432412 JOHNSON ENGINE COVER ASSY.


0432412 ENGINE COVER ASSY. JOHNSON J20ECEM, J20EESB, J25ECEB, J25EESE, J25TECEM, J25TEESB, J30ECED, J30EESS, J30TECED, J30TEESS, TJ30ELESS ENGINE
0432412 ENGINE COVER ASSY. JOHNSON
Rating:
23

Buy ENGINE COVER ASSY. 0432412 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 1
 

BRP JOHNSON entire parts catalog list:

J20ECEM, J20ELCEM 1989
J20EESB, J20ELESB 1990
J25ECEB, J25ELCEB, TJ25ELCEB, TJ25ELESF 1989
J25EESE, J25ELESE, TJ25ELESE, VJ25ELESE 1990
J25TECEM, J25TELCEM 1989
J25TEESB, J25TELESB 1990
J30ECED, J30ELCED, TJ30ELCED, TJ30ELESF 1989
J30EESS, J30ELESS 1990
J30TECED, J30TELCED 1989
J30TEESS, J30TELESS 1990
TJ30ELESS, VJ30EESS, VJ30ELESS 1990

Information:


Table 1
J1939 Code and Description CDL Code and Description Comments
677-5
Engine Starter Motor Relay : Current Below Normal 444-5
Starter Motor Relay : Current Below Normal This code indicates that there is a problem with the engine starter motor relay and/or the electrical circuit on the ECM.
677-6
Engine Starter Motor Relay : Current Above Normal 444-6
Starter Motor Relay : Current Above Normal This code indicates that there is a problem with the engine starter motor relay and/or the electrical circuit on the ECM.
4210-5
Engine Pre-lube Drive : Current Below Normal 338-5
Engine Pre-Lube Pump Relay : Current Below Normal This code indicates that there is a problem with the prelubrication solenoid and/or the electrical circuit on the ECM.
4210-6
Engine Pre-lube Drive : Current Above Normal 338-6
Engine Pre-Lube Pump Relay : Current Above Normal This code indicates that there is a problem with the prelubrication solenoid and/or the electrical circuit on the ECM. Electrical Checkouts on the Cat® Electronic Technician (ET)
Table 2
Component Electrical Checkout
Engine Starter Motor Relay Attempt to start the engine. Once the ECM attempts to energize the solenoid, the code will become active. Refer to the application-specific schematic for the "Engine Starter Motor Relay" wiring circuit.
Prelubrication System Relay Prelubrication Relay Override
Table 3
Troubleshooting Test Steps Values Results
1. Check for Codes
A. Connect Cat® Electronic Technician (ET) to the service tool connector.
B. Determine if a code is active or logged.
Codes
Result: A -5 code is active or logged.
Proceed to Test Step 2.
Result: A -6 code is active or logged.
Proceed to Test Step 3.
2. Check the Wiring for an Open Circuit
A. Verify that the harness connector is free of debris, free of corrosion, and securely connected.
B. Disconnect the relay from the harness.
C. Connect a jumper wire between the terminals of the harness connector for the affected coil. The coil is replaced with a short circuit.
Create a Short
Result: A -5 code became active during the electrical checkout. The Electronic Control Module (ECM) did not detect the jumper wire. There is an open circuit in the wiring between the coil and the ECM connector. There may be a problem with a connector.
Repair: Repair or replace the connectors or the wiring.
Verify that the repair eliminated the problem.
Result: A -6 code is activated during the electrical checkout. The ECM detected the jumper wire. There is a problem with the solenoid.
Repair: Replace the solenoid.
Verify that the repair eliminated the problem.
3. Check the Wiring for a Short Circuit
A. Disconnect the relay from the harness.
Create an Open
Result: A -6 code became active during the electrical checkout. The ECM did not detect the open circuit. There is a short circuit in the wiring between the coil and the ECM connector. There may be a problem with a connector.
Repair: Repair or replace the connectors or the wiring.
Verify that the repair eliminated the problem.
Result: A -5 code is activated during the electrical checkout. The ECM detected the open circuit. There is a problem with the solenoid.
Repair: Replace the solenoid.
Verify that the repair eliminated the problem.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).


Parts engine JOHNSON:

0283610
 
0283610 ENGINE COVER ASSY.
J20ECEM, J20EEIE, J20EESB, J25ECEB, J25EEID, J25EESE, J30ECED, J30EEIC, J30EESS, TJ30ELESS
0283776
 
0283776 ENGINE COVER ASSY.
J20ECEM, J25ECEB, J30ECED
0283777
 
0283777 ENGINE COVER ASSY.
J20ECEM, J20EESB, J25ECEB, J25EESE, J30ECED, J30EESS, TJ30ELESS
0283611
 
0283611 ENGINE COVER ASSY.
J20ECEM, J20EEIE, J20EESB, J25ECEB, J25EEID, J25EESE, J25TECEM, J25TEEIE, J25TEESB, J30ECED, J30EEIC, J30EESS, J30TECED, J30TEEIC, J30TEESS, TJ30ELESS
0283609
 
0283609 ENGINE COVER ASSY.
J20ECEM, J20EEIE, J20EESB, J25ECEB, J25EEID, J25EESE, J25TECEM, J25TEEIE, J25TEESB, J30ECED, J30EEIC, J30EESS, J30TECED, J30TEEIC, J30TEESS, TJ30ELESS
0433137
 
0433137 ENGINE COVER ASSY.
J20ECEM, J20EESB, J25ECEB, J25EESE, J30ECED, J30EESS, TJ30ELESS
0432410
ENGINE COVER ASSY.
0432410 ENGINE COVER ASSY.
J20ECEM, J20EESB, J25ECEB, J25EESE, J25TECEM, J25TEESB, J30ECED, J30EESS, J30TECED, J30TEESS, TJ30ELESS
0433392
ENGINE COVER, Lower
0433392 ENGINE COVER, Lower
BJ20SEECB, BJ20SEEDA, BJ20SEEUM, BJ20SRECB, BJ20SREDA, BJ20SREUM, BJ25BAECM, BJ25BAEDR, BJ25BAEUA, BJ25EECE, BJ25EEDM, BJ25EEED, BJ25EEUB, BJ25ELSIC, BJ25ELSSS, BJ30BAECS, BJ30BAEDE, BJ30BAEEC, BJ30BAEUD, BJ30EECS, BJ30EEDE, BJ30EEEC, BJ30EEUD, BJ30E
Back to top