0329390 JOHNSON GASKET, Impeller housing


0329390 GASKET, Impeller housing JOHNSON D25RWA, HJ25FPO, HJ25FPV, J25ECRS, J25RWCDC, J25RWCOS, J25RWCRD, J25RWCUR, J25RWEIM, J25RWENB, J25RWEOS, J25RWERD, J25RWESA, J25RWETE, J25RWK, J28ELCDS, J28ELCDS, J28ESLCCR, J28ESLCCR, J28ESLCEA, J28ESLCEA, J28ESLCUC, J28ESLCUC, J28ESLEDR, J28ESLEDR, GASKET
0329390 GASKET, Impeller housing JOHNSON
Rating:
38

Buy GASKET, Impeller housing 0329390 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 16
 

BRP JOHNSON entire parts catalog list:

D25RWA, D25RWLA 1988
HJ25FPO, HJ25RSLO, J25RWEDC, J25RWLEDC 1996
HJ25FPV, HJ25RLSV, J25RWEUR, J25RWLEUR, SJ25RPLV, SJ25RPV 1997
J25ECRS, J25ELCRS, J25RCRD, J25RLCRD, J25TECRD, J25TELCRD 1984
J25RWCDC, J25RWLCDC 1986
J25RWCOS, J25RWLCOS 1985
J25RWCRD, J25RWLCRD 1984
J25RWCUR, J25RWLCUR 1987
J25RWEIM, J25RWLEIM 1991
J25RWENB, J25RWLENB 1992
J25RWEOS, J25RWLEOS 1995
J25RWERD, J25RWLERD 1994
J25RWESA, J25RWLESA 1990
J25RWETE, J25RWLETE 1993
J25RWK, J25RWLK 1989
J28ELCDS 1986
J28ELCDS 1986
J28ESLCCR, VJ28ESLCCR 1988
J28ESLCCR, VJ28ESLCCR 1988
J28ESLCEA, VJ28ESLCEA 1989
J28ESLCEA, VJ28ESLCEA 1989
J28ESLCUC 1987
J28ESLCUC 1987
J28ESLEDR 1996
J28ESLEDR 1996
J28ESLEIB 1991
J28ESLEIB 1991
J28ESLENE 1992
J28ESLENE 1992
J28ESLEOC 1995
J28ESLEOC 1995
J28ESLERS 1994
J28ESLERS 1994
J28ESLESM, VJ28ESLESM 1990
J28ESLESM, VJ28ESLESM 1990
J28ESLETD 1993
J28ESLETD 1993
VJ14RCCS 1988
VJ14RCCS 1988
VJ14RCEC 1989
VJ14RCEC 1989

Information:

Note: Test the concentration of the Supplemental Coolant Additive (SCA) or test the SCA concentration as part of an S O S Coolant Analysis.Test for SCA Concentration
Coolant and SCA
Do not exceed the recommended six percent supplemental coolant additive concentration.
Use the 8T-5296 Coolant Conditioner Test Kit or use the 4C-9301 Coolant Conditioner Test Kit in order to check the concentration of the SCA. Refer to this Operation and Maintenance Manual, "Refill Capacities and Recommendations" for more information.Water and SCA
Do not exceed the recommended eight percent supplemental coolant additive concentration.
Test the concentration of the SCA with the 8T-5296 Coolant Conditioner Test Kit. Refer to the Special Publication, SEBU6251, "Caterpillar Commercial Diesel Engine Fluids Recommendations" for more information.S O S Coolant Analysis
S O S coolant samples can be analyzed at your Caterpillar dealer. S O S Coolant Analysis is a program that is based on periodic samples.Level 1
Level 1 is a basic analysis of the coolant. The following items are tested:
Glycol Concentration
Concentration of SCA
pH
ConductivityThe results are reported, and recommendations are made according to the results. Consult your Caterpillar dealer for information on the benefits of managing your equipment with an S O S Coolant Analysis.Level 2
This level coolant analysis is recommended when the engine is overhauled. Refer to this Operations and Maintenance Manual, "Overhaul Considerations" for further information.Add the SCA, If Necessary
Do not exceed the recommended amount of supplemental coolant additive concentration. Excessive supplemental coolant additive concentration can form deposits on the higher temperature surfaces of the cooling system, reducing the engine's heat transfer characteristics. Reduced heat transfer could cause cracking of the cylinder head and other high temperature components. Excessive supplemental coolant additive concentration could also result in radiator tube blockage, overheating, and/or accelerated water pump seal wear. Never use both liquid supplemental coolant additive and the spin-on element (if equipped) at the same time. The use of those additives together could result in supplemental coolant additive concentration exceeding the recommended maximum.
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure.
When any servicing or repair of the engine cooling system is performed the procedure must be performed with the engine on level ground. This will allow you to accurately check the coolant level. This will also help in avoiding the risk of introducing an air lock into the coolant system.
Slowly loosen the cooling system filler cap in order to relieve the pressure. Remove the cooling system filler cap. Note: Always discard drained fluids according to local regulations.
If necessary, drain some coolant from the cooling system into a suitable container in order to allow space for the extra SCA.
Add the proper amount of SCA. Refer to the Special Publication, SEBU6251, "Caterpillar Commercial Diesel Engines Fluids Recommendations" for more information on SCA requirements.
Clean the cooling system filler cap. Inspect the gaskets of the cooling system filler cap. If the gaskets are damaged, replace the old cooling system filler cap with a new cooling system filler cap. Install the cooling system filler cap.


Parts gasket JOHNSON:

0304764
GASKET,Bushing
0304764 GASKET,Bushing
20R69B, 20R70C, 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25E74M, 25E75B, 25E76E, 25E77S, 25E78C, 25E79R, 25R69B, 25R70C, 25R71S, 33E69A, 33E69A, 33E70M, 33E70M, 35E77C, 35E78R, 35E79A, 40E69R, 40E70A, 40E71B, 40E72E, 40E73D, 40E74S, 40E75C, 40E76A, 40
0316332
 
0316332 GASKET, Nozzle
20R70C, 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25E74M, 25E75B, 25E76E, 25E77S, 25E78C, 25E79R, 25R70C, 25R71S, 35E76G, 35E77C, 35E78R, 35E79A, 50ES71S, 50ES72C, 50ES73R, 50ES74M, 50ES75B, 50R79C, 55E76E, 55E77D, 55E78S, 55E79C, 60ES70B, 60ES71C, 65E
0318932
GASKET, Carburetor to manifold
0318932 GASKET, Carburetor to manifold
10E74G, 10E75C, 10E76G, 10E77A, 10E78M, 10EL79B, 15E74G, 15E75C, 15E76A, 15E77M, 15E78B, 15E79E, BJ10FAEDC, BJ10FAEUR, BJ10FDLECM, BJ10FDLEDR, BJ10FDLEUA, BJ15FAEDR, BJ15FAEUA, BJ15FDLECM, BJ20SREUM, BJ25BAEUA, BJ30BAEUD, BJ5DREDS, BJ5DREUC, BJ5FRBEC
0321573
GASKET, Manifold
0321573 GASKET, Manifold
25E77S, 25E78C, 25E79R, 35E76G, 35E77C, 35E78R, 35E79A, J20CRCDC, J20CRCOS, J25ECDR, J25ECIB, J25ECNE, J25ECOC, J25ECRS, J25ECTD, J25RCSA, J25RSA, J25RSLS, J25RWCDC, J25RWCOS, J25RWCRD, J28ELCDS, J28ELCDS, J30ECRR, J35ECIG, J35ECND, J35ECRR, J35ECSM,
0325092
GASKET,Carb to manifold
0325092 GASKET,Carb to manifold
25E79R, 35E79A, 50R79C, 55E79C, 70EL79R, 75ELR79R, AM55RSLD, BJ20SEECB, BJ20SEEDA, BJ20SEEUM, BJ20SRECB, BJ20SREDA, BJ20SREUM, BJ25BAECM, BJ25BAEDR, BJ25BAEUA, BJ25EECE, BJ25EEDM, BJ25EEED, BJ25EEUB, BJ25ELSIC, BJ25ELSSS, BJ30BAECS, BJ30BAEDE, BJ30BA
0324449
 
0324449 GASKET,Impeller housing plate
25E79R, 35E79A, D25RWA, HJ25FPO, HJ25FPV, J25ECIB, J25ECNE, J25ECRS, J25ECTD, J25RCSA, J25RSA, J25RSLS, J25RWCDC, J25RWCOS, J25RWCRD, J25RWCUR, J25RWEIM, J25RWENB, J25RWEOS, J25RWERD, J25RWESA, J25RWETE, J25RWK, J28ELCDS, J28ELCDS, J28ESLCCR, J28ESLC
0325260
 
0325260 GASKET, Leaf plate
BJ10EEDD, BJ10RELEUS, BJ10RHLSDA, BJ10RHLSOR, BJ10RHLSRC, BJ10RHLSTS, BJ15EEDS, BJ15RELEUC, HJ15KCF, HJ15KCLN, HJ15KCLO, J10ECCD, J10ECDB, J10ECES, J10ECOM, J10ECUE, J10EECC, J10EEIR, J10EENA, J10EEOE, J10EERB, J10EESC, J10EETM, J10ELCID, J10ELCNS, J
0326260
GASKET, Manifold
0326260 GASKET, Manifold
BJ20SEECB, BJ20SEEDA, BJ20SEEUM, BJ20SRECB, BJ20SREDA, BJ20SREUM, BJ25BAECM, BJ25BAEDR, BJ25BAEUA, BJ25EECE, BJ25EEDM, BJ25EEED, BJ25EEUB, BJ25ELSIC, BJ25ELSSS, BJ30BAECS, BJ30BAEDE, BJ30BAEEC, BJ30BAEUD, BJ30EECS, BJ30EEDE, BJ30EEEC, BJ30EEUD, BJ30E
Back to top