5032898 JOHNSON GASKET, Throttle body


5032898 GASKET, Throttle body JOHNSON BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70PL4SNF GASKET
5032898 GASKET, Throttle body JOHNSON
Rating:
103

Buy GASKET, Throttle body 5032898 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 1
 

BRP JOHNSON entire parts catalog list:

BJ60PL4SDM, J60PL4SDM 2006
BJ60PL4SOA, J60PL4SOA 2005
BJ60PL4SRR, J60PL4SRR 2004
BJ60PL4STC, J60PL4STC 2003
BJ70PL4SDM, J70PL4SDM 2006
BJ70PL4SOA, J70PL4SOA 2005
BJ70PL4SRR, J70PL4SRR 2004
BJ70PL4STC, J70PL4STC 2003
J60PL4SNF 2002
J70PL4SNF 2002

Information:


Illustration 1 g00763721
The particle detector warns the engine when metal particles are detected in the lubricating oil. The particle shuts down the engine when metal particles are detected in the engine oil. The sensor consists of a grid that has parallel copper traces on a circuit board. Alternate traces are connected to +24 VDC and to the I:2.0/1 input of the PLC. When an electrically conductive particle bridges the gap between the parallel traces, current flows. The I:2.0/1 input of the PLC becomes active. This triggers an alarm. If the condition exists after a time delay, the engine will shut down.Jacket Water Detector Switch
The switch is an electronic sensor that detects the presence of coolant. If coolant is present, the output of the switch is OFF. If coolant is not present, the relay "JWDAR" is energized. An alarm is generated.Start Oil Switch
The start oil switch is used in order to determine if the engine is lubricated prior to starting. The control panel supports both the intermittent prelube system and the continuous prelube system. A pressure switch is used with intermittent prelube systems. A detector is used with continuous prelube systems.Liquid Detector Gp
Illustration 2 g00763726
The switch is an electronic sensor that detects the presence of oil. If oil is present, the output of the switch is ON. When there is a presence of engine oil and a presence of generator oil pressure the "SOSR" relay is energized. The "Starting Oil Pressure Lamp" turns on and the engine is allowed to start.Pressure Sender
Illustration 3 g00763715
The pressure sender varies resistance with pressure. The variable resistance is used in order to drive the "Air Start Gauge".Oil Level Switch
The switch provides an alarm signal if the oil level is too low in the oil pan. The switch is wired in the normally open position. A normal water level in the expansion tank holds the contacts of the switch closed. If the oil level falls and the contacts break, the I:2.0/0 input of the PLC becomes inactive. An alarm is then generated.Speed Sensor for the Turbocharger
The turbocharger speed sensor is used in order to measure the rotational speed of the turbocharger in RPM. The speed is monitored and an alarm is generated when the speed of the turbocharger exceeds 35000 RPM.
Table 1
Model     Number of Pulses per Revolution    
VTC254 90° inlet     2    Speed Sensor
Illustration 4 g00763729
The turbocharger has a speed sensor that is installed. The PLC will convert the pulse that is generated by the blade pass into the RPM for the turbocharger.Speed Sensor with 90° Inlet
Illustration 5 g00763728
This sensor is optional. The sensor detects the speed of the turbocharger from a slot on a bolt that is mounted on the turbocharger.Rotary Sensor
Illustration 6 g00763722
The sensor is tied to the fuel control housing through a linkage. Movement of the fuel control linkage is converted into an electrical signal. The signal is amplified to a 4-20 mA signal that is proportional to the position of the rack of the engine. Refer to Special Instruction, REHS0923 for information on calibration and adjustment.


Parts gasket JOHNSON:

5030071
GASKET, Drain & fill plug
5030071 GASKET, Drain & fill plug
BJ115L4SDA, BJ115L4SRC, BJ115L4STS, BJ140CX4DR, BJ140CX4SRS, BJ140L4SDR, BJ140PL4SRS, BJ25E4SDS, BJ25E4SUC, BJ25R4SDS, BJ25R4SUC, BJ25TE4SDS, BJ25TE4SUC, BJ40PL4SDR, BJ40PL4SOC, BJ40PL4SRS, BJ50PL4SDR, BJ50PL4SOC, BJ50PL4SRS, BJ60PL4SDM, BJ60PL4SOA,
5030611
 
5030611 GASKET, Cylinder head
BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70FLTLECS, J70PL4SNF
5030615
 
5030615 GASKET, Cylinder head cover
BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70FLTLECS, J70PL4SNF
5030725
 
5030725 GASKET, Impeller housing
BJ115L4SDA, BJ115L4SRC, BJ115L4STS, BJ140CX4DR, BJ140CX4SRS, BJ140L4SDR, BJ140PL4SRS, BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, BJ90PL4SDA, BJ90PL4SRC, BJ90PL4STS, J115PL4SOR, J140CX4SOR, J140CX4S
5030882
GASKET, Engine holder
5030882 GASKET, Engine holder
BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70FLTLECS, J70PL4SNF
5030736
 
5030736 GASKET, Pressure valve cover
BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70FLTLECS, J70PL4SNF
5030745
 
5030745 GASKET, Thermostat cover
BJ60PL4SDM, BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SDM, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70FLTLECS, J70PL4SNF
5032850
 
5032850 GASKET SET
BJ60PL4SOA, BJ60PL4SRR, BJ60PL4STC, BJ70PL4SOA, BJ70PL4SRR, BJ70PL4STC, J60PL4SNF, J70PL4SNF
Back to top