0332030 JOHNSON GROMMET, Primer pump knob


0332030 GROMMET, Primer pump knob JOHNSON J3RCCM, J3RCUA, J4RCCS, J4RCUD GROMMET
0332030 GROMMET, Primer pump knob JOHNSON
Rating:
28

Buy GROMMET, Primer pump knob 0332030 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 4
 

Compatible models:

BRP JOHNSON entire parts catalog list:

J3RCCM 1988
J3RCUA 1987
J4RCCS, J4RLCCS 1988
J4RCUD, J4RLCUD 1987

Information:


Table 1
J1939 Code and Description CDL Code and Description Comments
98-1
Engine Oil Level : Low - most severe (3) E171 (3)
Low Engine Oil Level The ECM may derate the engine or shutdown the engine.
The code is logged.
98-17
Engine Oil Level : Low - least severe (1) E171 (1)
Low Engine Oil Level The ECM may derate the engine or shutdown the engine.
The code is logged.
98-18
Engine Oil Level : Low - moderate severity (2) E171 (2)
Low Engine Oil Level The ECM may derate the engine or shutdown the engine.
The code is logged.
Illustration 1 g06309502
Table 2
Troubleshooting Test Steps Values Results
1. Check for Codes
A. Connect Cat® Electronic Technician (ET) to the service tool connector.
B. Look for active codes that are associated with the system for the event code.
Codes
Result: An associated code is active.
Repair: Troubleshoot any associated codes before continuing with this test.
Result: A code is active or logged.
Proceed to Test Step 2.
2. Check the Engine Oil Level
Oil Level
Result: The engine oil is at the proper level.
Proceed to Test Step 3.
Result: The engine oil level is low.
Repair: Add engine oil in order to obtain the correct engine oil level. Refer to Operation and Maintenance Manual, "Engine Oil" for the recommendations of engine oil.
Start the engine. Inspect the exterior of the engine for oil leaks. Repair any oil leaks.
If the problem is not resolved, proceed to Test Step 3.
3. Check the Supply Voltage at the Oil Level Sensor Connector
A. Disconnect the oil level sensor at the sensor connector.
B. Restore electrical power to the ECM.
C. Measure the voltage between the following wiring harness connector terminals for the oil level sensor:
- Terminal A (sensor supply) and Terminal B (sensor return)
D. Remove electrical power from the ECM.
5.0 0.2 VDC
Result: The voltage measurement is 5.0 0.2 VDC. The supply voltage is reaching the sensor.
Proceed to Test Step 4.
Result: The voltage measurement is not 5.0 0.2 VDC.
Repair: The sensor supply voltage is not reaching the sensor. There is a problem in the circuit for the sensor supply. Repair the wiring harness between the sensor and the ECM.
If the problem is not resolved, proceed to Test Step 4.
4. Short the Signal Wire to Ground on the Oil Level Sensor
A. Fabricate a jumper wire that is long enough to create a short circuit between two terminals at the oil level sensor harness connector. Crimp connector pins to each end of the jumper wire.
B. Install the jumper wire between the following wiring harness connector terminals for the oil level sensor:
- Terminal B (sensor return) and Terminal C (sensor signal)
C. Connect Cat ET.
D. Use Cat ET to monitor the status of the "Oil Level".
E. Remove the jumper wire. Connect the harness connector for the oil level sensor.
5 VDC
Result: The status changes when the jumper wire is installed.
Repair: Replace the failed oil level sensor.
Verify that the repair eliminated the problem.
Result: The status does not change when the jumper wire is installed.
Repair: The problem is between the ECM and the sensor connector. Repair the wiring harness.
Verify that the repair eliminated the problem.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).


Parts grommet JOHNSON:

0321129
 
0321129 GROMMET,Water tube
4R76M, 4R77B, 4R78E, 4R79D, BJ3REDS, BJ4BREDS, BJ4BREUC, BJ4RDHEDS, J2RCOC, J3BRCEC, J3BRESR, J3RCCM, J3RCUA, J3REIA, J3RENM, J3REOD, J3RERE, J3RETB, J3REUC, J4BRCIC, J4BRECRJ, J4BRHCCS, J4BRHCDE, J4BRHCNR, J4BRHCOB, J4BRHCRM, J4BRHCTA, J4BRHCUD, J4R
0317462
 
0317462 GROMMET, Water tube
J3BRCEC, J3BRESR, J3RCCM, J3RCUA, J4BRCIC, J4BRHCCS, J4BRHCDE, J4BRHCNR, J4BRHCOB, J4BRHCRM, J4BRHCTA, J4BRHCUD, J4RCCS, J4RCEC, J4RCUD, J4RESR
0331375
 
0331375 GROMMET, Slow speed adj. knob
J3RCCM, J3RCUA, J4RCCS, J4RCEC, J4RCUD, J4RESR
0333022
 
0333022 GROMMET, Air silencer shut-off valve
J3RCCM, J3RCUA, J4RCCS, J4RCUD
0332021
 
0332021 GROMMET, Engine cover, port & stbd.
J3RCCM, J3RCUA, J4RCCS, J4RCEC, J4RCUD, J4RESR
0332564
 
0332564 GROMMET, Shorting switch leads to exhaust housing
J3RCCM, J3RCUA, J4RCCS, J4RCEC, J4RCUD, J4RESR
0332532
 
0332532 GROMMET, Shorting switch leads to exhaust housing
J3RCCM, J3RCUA, J4RCCS, J4RCEC, J4RCUD, J4RESR
Back to top