5035191 JOHNSON LEVER, HOOK RR STBD

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the engine oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Illustration 1 g01048207
Remove bolts (3).
Remove engine oil pan (2) and gasket (1).
If necessary, remove bolts (4) and remove engine oil pan (6) and gasket (5) from engine oil pan (2).
Illustration 2 g02478074
Remove bolts (7) and remove tube assembly (8). Remove the O-ring seal from the tube assembly.
Remove bolts (10) and remove the screen assembly and tube assembly (9). Remove the O-ring seal from the tube assembly.
Remove the bolts, spacer plate (11), and the gasket.Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite Blue RTV Silicone -
B 1Y-3904 Adhesive -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Use new gaskets for installation. Do not reuse the gaskets.
Thoroughly clean the mating surface of the engine oil pan, the spacer plate, and the cylinder block.
Illustration 3 g02478074
Illustration 4 g02479538
Illustration 5 g02478095
Apply Tooling (A) to the joints between the cylinder block, the front housing, and the flywheel housing.
Apply Tooling (B) to Areas (W) on spacer plate (11). Position the gasket on spacer plate (11).
Apply Tooling (A) to Areas (X) on the gasket. Install the gasket, spacer plate (11), and the bolts. Install spacer plate (11) within 10 minutes of applying Tooling (A).
Install the O-ring seal on tube assembly (9). Lubricate the O-ring seal with clean engine oil and install tube assembly (9) in the engine oil pump. Install bolts (10).
Install the O-ring seal on tube assembly (8). Lubricate the O-ring seal with clean engine oil and install tube assembly (8) in the engine oil pump. Install bolts (7).
Illustration 6 g02480276
Illustration 7 g02479658
Illustration 8 g02478139
Illustration 9 g02463392
Install gasket (5) between engine oil pan (2) and engine oil pan (6). Install bolts (4). Tighten bolts (4) in a numerical sequence. Tighten bolts (4) again in a numerical sequence. Refer to Illustration 6. After assembling the engine oil pans, trim excess gasket (5) from the face of the engine oil pan.
Apply Tooling (A) to the joint area where engine oil pan (2) and engine oil pan (6) meet.
Apply Tooling (B) to Areas (Y) on engine oil pan (2). Install gasket (1) on engine oil pan (2).
Apply Tooling (A) to Areas (Z) on gasket (1). Install gasket (1), engine oil pan (2), and bolts (3). Install engine oil pan (2) within 10 minutes of applying Tooling (A).
Tighten bolts (3) in a numerical sequence to a torque of 40 5 N m (30 4 lb ft) according to Sequence (A) in Illustration 9. Tighten bolts (3) in a numerical sequence to a torque of 47 5 N m