0309627 JOHNSON LINK,Choke to bellcrank

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     Loctite 271     -    
Open the hood.
Turn the fuel supply and the power disconnect switch to the OFF position.
Illustration 1 g02478098
Remove primary fuel filter assembly (2) from the fuel filter base. Refer to Operation and Maintenance Manual, "Fuel System Primary Filter (Water Separator) Element - Replace".Note: Remove the fuel line that runs from filter base (1) to the ARD manifold.
Disconnect hose assemblies and harness assemblies from the primary filter assembly. Remove filter base (1) .
Illustration 2 g02206253
Remove bolts (4) and manifold (5) .
Remove plug (3) .
Illustration 3 g02206259
Remove nuts (7) and disconnect harness assemblies (6) .
Illustration 4 g02206256
Remove pump assembly (12) from the housing assembly.
Remove seal (8), backup ring (9), seal (10), and backup ring (11) from pump assembly (12). Remove harness assembly (6) from the housing assembly.
Illustration 5 g02206260
Remove fitting (14) from pump assembly (12). Remove O-ring seal (16) and backup ring (15). Remove O-ring seal (13) from inside fitting (14) .
Illustration 6 g02206258
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove plug (17), O-ring seal (18), spring (19), check valve (21), and O-ring seal (22). Repeat with plug (20) .
Remove stud (23) .
Illustration 7 g02206257
Note: Note the orientation of solenoid (26) for installation purposes.
Remove nut (24), solenoid assembly (26), and cartridge assembly (27). Remove check valve (25) .
Illustration 8 g02206261
Remove O-ring seal (28), O-ring seal (29), and backup ring (30) from cartridge assembly (27) .
Illustration 9 g02206254
Remove O-ring seal (31), backup ring (32), and O-ring seal (33) from check valve (25) .Installation Procedure
Install the fuel priming pump in the reverse order.
Tighten check valve (25) to a torque of 28 3 N m (21 2 lb ft).
Tighten cartridge assembly (27) to a torque of 28 3 N m (21 2 lb ft).
Tighten nut (24) to a torque of 6.5 0.5 N m (58 4 lb in).
Tighten plug (17) and plug (20) to a torque of 95 10 N m (70 7 lb ft).
Apply Tooling (A) to the threads of stud (23) before installation. Tighten stud (23) to a torque of 50 5 N m (37 4 lb ft).
Tighten plug (3) to a torque of 11 2 N m (97 18 lb in).
Use two people in order to flush the fuel pump and fuel line (1) into a suitable container for disposal. The fuel pump can be activated by turning on the key or pressing the manual switch. The manual switch, if available, is located on the primary fuel filter base. Connect the fuel line to the ARD manifold.
After reassembly, prime the engine by turning on the key or pressing the manual switch. The manual switch, if available, is located on the primary fuel filter base. Visually check for leaks around the pump and around the connections on the ARD manifold. If leaks are observed, resolve the leak issue before proceeding further.