0329736 JOHNSON LOUVER,Engine cover,stbd.


0329736 LOUVER,Engine cover,stbd. JOHNSON J150CXCCA, J150CXEIE, J150GTLCUR, J150STLACA, J150STLCDC, J150STLCOH, J150STLCRD, J150STLCTE, J150STLEIE, J175STLACM, J175STLEID, J185ESERK, J200CXARC, J200CXCCR, J200STLCDR, J200STLCUA, J225CLCUB, J225CXARC, J225CXCCE, J225PTLCDA, J235STLCOR, J235ST LOUVER
0329736 LOUVER,Engine cover,stbd. JOHNSON
Rating:
98

Buy LOUVER,Engine cover,stbd. 0329736 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 23
 

BRP JOHNSON entire parts catalog list:

J150CXCCA, J150TLCCA, J150TXCCA 1988
J150CXEIE, J150JLEIE, J150TLAIE, J150TLEIE, J150TXEIE, VJ150TLEIE, VJ150TXEIE 1991
J150GTLCUR, J150STLCUR 1987
J150STLACA, J150STLCCA 1988
J150STLCDC 1986
J150STLCOH, J150STLCOS 1985
J150STLCRD 1984
J150STLCTE 1983
J150STLEIE, TJ150SLEIE, VJ150SLEIE 1991
J175STLACM, J175STLCCM, J175TLCCM, J175TXCCM 1988
J175STLEID, J175TXEID, VJ175SLEID, VJ175TXEID 1991
J185ESERK 1994
J200CXARC, J200CXARK, J200CXERK, J200CXERS, J200CZARK, J200CZERK, J200CZERS, J200STLERK, J200STLERR, J200TXARC, J200TXARK, J200TXERK, J200TXERS, J200TZARK, J200TZERK, J200TZERS 1994
J200CXCCR, J200STLACM, J200STLCCM, J200TXCCR 1988
J200STLCDR, J200TXCDS 1986
J200STLCUA, J200TXCUC 1987
J225CLCUB, J225CXCUB, J225PLCUB, J225PXCUB, J225TLCUB, J225TXCUB 1987
J225CXARC, J225CXARK, J225CXERK, J225CXERM, J225CZARK, J225CZERK, J225CZERM, J225PLERK, J225PLERM, J225PXARC, J225PXARK, J225PXERK, J225PXERM, J225PZARK, J225PZERK, J225PZERM, J225STLERC, J225STLERK, J225TLERK, J225TLERM, J225TXARC, J225TXARK, J225TXERK, J225TXERM, J225TZARK, J225TZERK, J225TZERM 1994
J225CXCCE, J225PLCCE, J225PXCCE, J225TLCCE, J225TXCCE 1988
J225PTLCDA, J225PTXCDA, J225TLCDA, J225TXCDA 1986
J235STLCOR 1985
J235STLCRC 1984
J235STLCTS 1983

Information:

Probable Causes
Fuel injector O-ring seals
Fuel injector tip
Fuel transfer pump seal
High-pressure fuel pump
Cracked cylinder headRecommended Actions
Table 1
Troubleshooting Test Steps     Values     Results    
1. Leaking Seals
A. Remove the injector from the affected cylinder and visually inspect the injector O-ring seals for damage.
If leakage is found and the O-rings are in good repair, there may be a problem with the injector. Replace the injector. Ensure that the new trim files are installed. Refer to Troubleshooting, "Injector Trim File - Install" for details. Use Caterpillar Electronic Technician (ET) to perform a "Fuel System Verification Test". Refer to Troubleshooting, "Injector Solenoid - Test" for details.
If the leakage is not located, add the appropriate dye to the fuel tanks. Run the engine at high idle for several minutes. Shut down the engine and remove the valve covers. Use a black light to check for traces of dye around each injector.
   
O-ring Seal    
Result: The injector O-ring seal is damaged.
Repair: Replace the damaged seals. Install the injector onto the engine and confirm that the repair has resolved the problem.
Result: The injector O-ring seal is not damaged.
Proceed to Test Step 2.    
2. Fuel Injector Tip
A. Use Cat ET to perform the "Cylinder Cutout Test" in order to identify any cylinders that may be overfueled.
B. A fuel injector tip that is broken or fractured is a possible cause of a cylinder that is being overfueled. If a cylinder is identified by the test, Remove the injector and check the injector tip for damage. Check the fuel injector tip for cracks or breakage.
   
Injector Tip    
Result: The fuel injector tip is damaged.
Repair: Replace the suspect injector.
Result: The fuel injector tip is not damaged.
Proceed to Test Step 3.
   
3. Fuel Transfer Pump Seal
A. Check for fuel leakage around the shaft seal for the fuel transfer pump. Ensure that the weep hole is not plugged.
   
Pump Seal    
Result: There is fuel leakage around the shaft seal.
Repair: Replace the fuel transfer pump.
Result There is not fuel leakage around the shaft seal.
Proceed to Test Step 4.
   
4. High-pressure fuel pump
A. Remove the plug from the bottom of the high-pressure fuel pump. Remove the plug from the bottom of the fuel pump adapter. Expect that a small amount of engine oil will drain from the openings.
B. Use the manual override for the fuel priming pump to run the pump in order to pressurize the fuel system. Allow the pump to run for at least 5 minutes while you monitor the drain holes in the pump and the adapter for leakage.
   
Defective Pump    
Result A leak is detected.
Repair: Replace the high-pressure fuel pump.
Result No leak is detected.
Proceed to Test Step 5.
   
5. Cracked Cylinder Head
A. Look for signs of damage to the internal passages for the fuel supply to the injectors in the cylinder head. Check for pin hole leaks. Refer to Disassembly and Assembly.
   
Cracked Head    
Result The internal passages for the fuel supply to the injectors are damaged.
Repair: Repair or replace the cylinder head.
   If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).


Parts louver JOHNSON:

0209926
 
0209926 LOUVER,Port
J150STLCRD, J150STLCTE, J235STLCRC, J235STLCTS
0209927
 
0209927 LOUVER,Starboard
J150STLCRD, J150STLCTE, J235STLCRC, J235STLCTS
0329735
 
0329735 LOUVER,Engine cover,port
J150CXCCA, J150CXEIE, J150GTLCUR, J150STLACA, J150STLCDC, J150STLCOH, J150STLCRD, J150STLCTE, J150STLEIE, J175STLACM, J175STLEID, J185ESERK, J200CXARC, J200CXCCR, J200STLCDR, J200STLCUA, J225CLCUB, J225CXARC, J225CXCCE, J225PTLCDA, J235STLCOR, J235ST
0210270
 
0210270 LOUVER, Port
J150STLCRD, J235STLCRC
0210271
 
0210271 LOUVER, Starboard
J150STLCRD, J235STLCRC
0210174
 
0210174 LOUVER, Port
J150CXCCA, J150GTLCUR, J150STLACA, J150STLCDC, J150STLCOH, J175STLACM, J200CXCCR, J200STLCDR, J200STLCUA, J225CLCUB, J225CXCCE, J225PTLCDA, J235STLCOR
0210175
 
0210175 LOUVER, Starboard
J150CXCCA, J150GTLCUR, J150STLACA, J150STLCDC, J150STLCOH, J175STLACM, J200CXCCR, J200STLCDR, J200STLCUA, J225CLCUB, J225CXCCE, J225PTLCDA, J235STLCOR
0211262
 
0211262 LOUVER, Port, 175STL
J150CXCEM, J150CXEIE, J150CXESB, J150STLCEM, J150STLEIE, J150STLESB, J175STLCEB, J175STLEID, J175STLESE, J185ESXESS, J185ESXW, J200CXCEA, J200CXEIB, J200CXESM, J225CXCED, J225CXEIC, J225CXESS
Back to top