0302468 JOHNSON SCREW, Ground lead


0302468 SCREW, Ground lead JOHNSON 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25R71S, 40E69R, 40E70A, 40ES69R, 40ES70A, J25ECIB, J25ECNE, J25ECTD, J25RSA, J25RSLS, J35ECIG, J35ECND, J35ECTS, RDS-30A, RK-30A SCREW
0302468 SCREW, Ground lead JOHNSON
Rating:
73

Buy SCREW, Ground lead 0302468 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 8
 

BRP JOHNSON entire parts catalog list:

20R71S, 20RL71S 1971
20R72R, 20RL72R 1972
20R73A, 20RL73A 1973
25E72R, 25EL72R, 25R72R, 25RL72R 1972
25E73A, 25EL73A, 25R73A, 25RL73A 1973
25R71S, 25RL71S 1971
40E69R, 40EL69R 1969
40E70A, 40EL70A 1970
40ES69R, 40ESL69R 1969
40ES70A, 40ESL70A 1970
J25ECIB, J25ECIM, J25ELCIB, J25ELCIM, J25RCIM, J25RLCIM, J25TECIM, J25TELCIM 1981
J25ECNE, J25ELCNE, J25RCNB, J25RELCNB, J25RLCNB, J25TECNB 1982
J25ECTD, J25ELCTD, J25RCTE, J25RLCTE, J25TECTE, J25TELCTE 1983
J25RSA, J25RSLA, J25RWCIM, J25RWLCIM 1981
J25RSLS, J25RSS, J25RWCTE, J25RWLCTE 1983
J35ECIG, J35ELCIG, J35RCIG, J35RLCIG 1981
J35ECND, J35ELCND, J35RCND, J35RLCND, J35TELCNB 1982
J35ECTS, J35ELCTS, J35RCTS, J35RLCTS, J35TELCTS 1983
RDS-30A, RDS-30C, RDS-30D, RDS-30S, RDSL-30A, RDSL-30C, RDSL-30D, RDSL-30S 1968
RK-30A, RK-30C, RK-30D, RKL-30A, RKL-30C, RKL-30D 1968

Information:


Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
M8 by 50 mm 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the wiring harness is correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness convoluting.
Illustration 1 g02191814
If necessary, follow Step 1.a through Step 1.d in order to assembly the engine oil cooler.
Ensure that engine oil cooler matrix (19) is clean, free from damage and restriction. Replace engine oil cooler matrix (19) if damaged or restricted.
Ensure that spacer plate (17) is clean and free from damage. Replace spacer plate (17) if damaged.
Position a new gasket (18) onto spacer plate (17). Install engine oil cooler matrix (19) to the spacer plate.
Install bolts (16) finger tight.
Illustration 2 g02192853
Illustration 3 g02192893
Tightening sequence for an engine oil cooler with a blanking plate or with a low mounted oil filter base
Clean the gasket surfaces of the cylinder block.
Install Tooling (A) into Position (B).
Position a new gasket (15) (not shown) onto Tooling (A).
Install the assembly of engine oil cooler (14) to the cylinder block.
Install bolts (13) to engine oil cooler (14). Note: Ensure that the bolts of different lengths are installed in the correct position. Ensure that any brackets for the tube assemblies are location and correctly orientated.
Tighten bolts (13) and bolts (16) to a torque of 22 N m (195 lb in) in the sequence that is shown in Illustration 3.
Remove Tooling (A).
Illustration 4 g02191813
If the engine has a low mounted oil filter on the left-hand side, install the oil filter base. Refer to Disassembly and Assembly, "Oil Filter Base - Remove and Install" for the correct procedure. If the engine has a right-hand side oil filter, follow Step 9.a through Step 9.d in order to install blanking plate (8).
Install bolts (10) to blanking plate (8).
Position a new gasket (9) (not shown) onto blanking plate (8).
Install the assembly of blanking plate (8) to the assembly of the engine oil cooler.
Tighten bolts (10) to a torque of 22 N m (195 lb in).
Position bracket (6) onto engine oil cooler. Install bolt (7). Tighten bolts (7) to a torque of 22 N m (195 lb in). Note: Ensure that locating pin for the bracket is correctly located into the engine oil cooler.
Install bolt (1) to fuel injection line clamp (2). Tighten bolts (1) to a torque of 10 N m (88 lb in).
Install new cable straps (3) to the engine wiring harness assembly.
Install plastic tube assembly (4) to crankcase breather canister (5) and to the plastic tube assembly clips.
Install plastic tube assembly (12) to crankcase breather canister (5) and crankcase breather valve (11).
Fill the cooling system to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Check the level of the engine lubricating oil. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check" for the correct procedure. End By:
Install the Electronic Control Module (ECM). Refer to Disassembly and Assembly, "Electronic Control Module - Remove and Install" for the correct procedure.


Parts screw JOHNSON:

0510185
 
0510185 SCREW,Eccentric
1R69C, 1R70R, 20R69B, 20R70C, 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25E74M, 25E75B, 25E76E, 25R69B, 25R70C, 25R71S, 2R71A, 2R72M, 2R73B, 2R74E, 2R75D, 2R76S, 2R77C, 2R78R, 2R79A, 33E69A, 33E69A, 33E70M, 33E70M, 40E69R, 40E70A, 40E71B, 40E72E, 40E73
0308742
 
0308742 SCREW,Thermostat cap
100ESL71A, 100ESL72R, 100ML79S, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 150TL78S, 150TL79C, 175TL77S, 175TL7
0551517
 
0551517 SCREW,Cam follower
33E69A, 33E69A, 33E70M, 33E70M, 40E69R, 40E70A, 40E71B, 40ES69R, 40ES70A, 40R69R, 40R70A, 9R69S, 9R70A, 9R71R, 9R72M, 9R73B, MQ-14D, RD-30A, RDS-30A, RK-30A, RX-16M, V4A-20A, V4S-20A, VX-14B
0301858
 
0301858 SCREW
20R69B, 20R70C, 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25E74M, 25E75B, 25E76E, 25E77S, 25E78C, 25E79R, 25R69B, 25R70C, 25R71S, 33E69A, 33E69A, 33E70M, 33E70M, 35E76G, 35E77C, 35E78R, 35E79A, 40E69R, 40E70A, 40E71B, 40E72E, 40E73D, 40E74S, 40E75C, 40
0314417
 
0314417 SCREW,Pump mounting
100ML79S, 10E77A, 10E78M, 10EL79B, 115EL77S, 115ETZ78C, 115ML79R, 115TXL77S, 140ML77S, 140ML78C, 140ML79R, 15E77M, 15E78B, 15E79E, 25E77S, 25E78C, 33E69A, 33E69A, 33E70M, 33E70M, 35E76G, 35E77C, 35E78R, 40E69R, 40E70A, 40E71B, 40E72E, 40E73D, 40E74S,
0305745
 
0305745 SCREW, Extension covers 5 INCH LONGER PARTS
100ESL71A, 100ESL72R, 115ESL69E, 115ESL70D, 125ESL72R, 40E69R, 40E70A, 40ES69R, 40ES70A, 40R69R, 40R70A, 55ES69A, 60ES71C, 65ES72S, 65ES73R, 85ESL69E, 85ESL70B, 85ESL71A, 85ESL72R, RD-30A, RDS-30A, RK-30A, TR-10R, V4A-20A, V4S-20A, VX-14B
0306416
 
0306416 SCREW, Housing to cylinder
175TL77S, 200TL76S, 200TL77C, 40E69R, 40E70A, 40ES69R, 40ES70A, 40R69R, 40R70A, 50ES71S, 50ES72C, 50ES73R, 50ES74M, 50ES75B, 50R79C, 55E76E, 55E77D, 55E79C, J65RWLCDR, J65RWLCOC, RD-30A, RDS-30A, RK-30A
0308211
 
0308211 SCREW ASSY.
40ES69R, 40ES70A, RK-30A, V4A-20A
Back to top