0320780 JOHNSON SCREW,Motor & reservoir to manifold

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     439-3940     Bracket As     2    
B     439-3942     Bracket As     4    Start By:
Connect the steering frame lock.
Release the hydraulic system pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Personal injury can result from contact with refrigerant.Contact with refrigerant can cause frost bite. Keep face and hands away to help prevent injury.Protective goggles must always be worn when refrigerant lines are opened, even if the gauges indicate the system is empty of refrigerant.Always use precaution when a fitting is removed. Slowly loosen the fitting. If the system is still under pressure, release it slowly in a well ventilated area.Personal injury or death can result from inhaling refrigerant through a lit cigarette.Inhaling air conditioner refrigerant gas through a lit cigarette or other smoking method or inhaling fumes released from a flame contacting air conditioner refrigerant gas, can cause bodily harm or death.Do not smoke when servicing air conditioners or wherever refrigerant gas may be present.Use a certified recovery and recycling cart to properly remove the refrigerant from the air conditioning system.
Recover/Charge the air conditioning system. Refer to Service Manual, SENR5664, " All Products Air Conditioning and Heating R134a for All Caterpillar Machines" for the recovery and charging procedure. Refer to Special Publication, NENG2500, "Air Conditioning Tools" for the correct tools.
Illustration 1 g03705354
Disconnect hose assembly (1) and hose assembly (5) .
Loosen clamps (2) and disconnect elbow (4) from tube (3) .
Illustration 2 g03705383
Disconnect hose assembly (6) .
Remove panel assembly (7) .
Illustration 3 g03705397
Remove panel assembly (8) .
Illustration 4 g03705437
Loosen clamp (10) and disconnect tube (11) .
Disconnect harness assembly (12) .
Remove panel assembly (9) .
Illustration 5 g03705471
Disconnect hose assembly (13) .
Illustration