0322785 JOHNSON SCREW,Spark adj.


0322785 SCREW,Spark adj. JOHNSON 25E77S, 35E77C SCREW
0322785 SCREW,Spark adj. JOHNSON
Rating:
78

Buy SCREW,Spark adj. 0322785 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 17
 

Compatible models:

25E77S   35E77C   JOHNSON

BRP JOHNSON entire parts catalog list:

25E77S, 25EL77H, 25EL77S, 25R77H, 25R77S, 25RL77H, 25RL77S 1977
35E77C, 35E77H, 35EL77C, 35EL77H, 35R77C, 35R77H, 35RL77C, 35RL77H 1977

Information:


Illustration 1 g00530097
System Schematic For The Engine Speed SensorThe EMCP II+ monitors engine speed. The EMCP II+ uses engine speed in order to accomplish many tasks. These tasks are included in the following list.
Activating a shutdown for engine overspeed
Terminating engine cranking
Determining the oil step speed
Causing the air shutoff solenoid to engage during some fault shutdownsThe EMCP II+ does not control engine speed. The engine speed sensor is mounted on the flywheel housing of the engine.The sensor creates a sine wave signal. The signal is created from passing ring gear teeth. The rate of the signal is one pulse per tooth. The sensor sends the sine wave signal to the GSC+. The frequency of the signal is directly proportional to the speed of the engine.The GSC+ treats a CID 190 FMI 2 as a shutdown fault. The engine is not allowed to crank or the engine is not allowed to run when a CID 190 FMI 2 diagnostic code is active.Note: The Engine Speed Sensor is commonly referred to as magnetic pickup.Note: Engines that are equipped with an engine control module (ECM) or an Electronic Ignition System (EIS) have a separate speed sensor. The cable of the speed sensor that is used by the GSC is marked with one of the following numbers: 838-873, 838-973 and 973-938This troubleshooting procedure is for a CID 190 FMI 2 that is active or inactive.The possible causes of a CID 190 FMI 2 are listed below.
The frequency of the signal is beyond accepted limits. There is a short to the battery negative terminal.
The air gap of the speed sensor is too large.Clear the diagnostic code from the fault log after troubleshooting is complete.Test Step 1. CHECK THE HARNESS AND THE SPEED SENSOR.
Turn the engine control switch (ECS) to OFF/RESET.
Disconnect the harness connector from the GSC+.
At the GSC+ harness connector, measure the resistance from contact "1" to contact "2".Expected Result:The resistance should be from 100 to 350 ohms.Results:
OK - There is probably an intermittent problem. Proceed to Test Step 2.
NOT OK - The harness wiring or the speed sensor has failed. Proceed to Test Step 3.Test Step 2. CHECK FOR AN INTERMITTENT FAULT.
Turn


Parts screw JOHNSON:

0312852
 
0312852 SCREW,Throttle and choke valve
100ESL71A, 100ESL72R, 10E74G, 10E75C, 10E76G, 10E77A, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 15E74G, 15E75C, 15E76A, 15E77M, 175TL77S, 1R69C, 1R70R,
0302508
SCREW,Impeller housing
0302508 SCREW,Impeller housing
20R69B, 20R70C, 20R71S, 20R72R, 20R73A, 25E72R, 25E73A, 25E74M, 25E75B, 25E76E, 25E77S, 25E78C, 25R69B, 25R70C, 25R71S, 35E77C, 35E78R, FD-22A
0305027
 
0305027 SCREW
25E77S, 25E78C, 25E79R, 33E69A, 33E69A, 33E70M, 33E70M, 35E77C, 35E78R, 35E79A, 40E69R, 40E70A, 40E71B, 40E72E, 40E73D, 40E74S, 40E75C, 40E76A, 40ES69R, 40ES70A, 55ES69A, 60ES70B, 60ES71C, BJ20SEECB, BJ20SEEDA, BJ20SEEUM, BJ20SRECB, BJ20SREDA, BJ20SR
0311516
 
0311516 SCREW, Clip
100ESL71A, 100ESL72R, 100ML79S, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 150TL78S, 150TL79C, 175TL77S, 175TL7
0316101
 
0316101 SCREW, Spark adjust
100ESL71A, 100ESL72R, 115ESL70D, 125ESL71C, 125ESL72R, 25E77S, 25E78C, 25E79R, 35E76G, 35E77C, 35E78R, 35E79A, 50ES71S, 50ES72C, 50ES73R, 50ES74M, 50ES75B, 50R79C, 55E76E, 55E77D, 55E78S, 55E79C, 85ESL70B, 85ESL71A, 85ESL72R, D25RWA, J20CRCCA, J20CRC
0317753
 
0317753 SCREW, Clamp motor cable
115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 115TXL77S, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 25E77S, 25E78C, 25E79R, 35E76G, 35E77C, 35E78R, 35E79A, 50R79C, 55E78S, 55E79C, 85EL76D, 85EL77S, 85ESL73M, 85ESL74B, 85ESL75E, 85TXLR77S, J10EESC, J15EE
0313966
 
0313966 SCREW
25E77S, 25E78C, 25E79R, 35E76G, 35E77C, 35E78R, 35E79A, J10ECCD, J10ECDB, J10ECOM, J10ECUE, J10ELCRA, J10ELCTC, J15ECCS, J15ECDE, J15ECOB, J15ECRM, J15ECTR, J15ECUD, J20CRCDC, J20CRCOS, J20CRCUR, J25ECDR, J25ECIB, J25ECNE, J25ECOC, J25ECRS, J25ECTD,
0511460
 
0511460 SCREW,Retainer
10E77A, 10E78M, 10EL79B, 15E77M, 15E78B, 15E79E, 25E77S, 25E78C, 25E79R, 35E77C, 35E78R, 35E79A, 4R77B, 4R78E, 4R79D, 50R79C, 55E78S, 55E79C, 6R77M, 6R78B, 6R79E, AM55RSLD, BJ10EEDD, BJ10RELEUS, BJ10RHLSDA, BJ10RHLSOR, BJ10RHLSRC, BJ10RHLSTS, BJ15EED
Back to top