0341961 JOHNSON SCREW, Cylinder head, M8


0341961 SCREW, Cylinder head, M8 JOHNSON BJ25ARECA, BJ25AREDC, BJ25AREUR, BJ25PL3EEM, BJ25PL3SIE, BJ25PL3SSB, BJ35ARECR, BJ35AREDS, BJ35AREEA, BJ35AREUC, BJ35E3SIE, BJ35E3SSB, SJ35RWECS SCREW
0341961 SCREW, Cylinder head, M8 JOHNSON
Rating:
28

Buy SCREW, Cylinder head, M8 0341961 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 30
 

BRP JOHNSON entire parts catalog list:

BJ25ARECA, BJ25ARLECA, BJ25KECA, BJ25KLECA, BJ25QLECA, J25KLECA, J25QLECA, J25RMECA, J25RMLECA, J25TKECA, J25TKLECA 1998
BJ25AREDC, BJ25ARLEDC, BJ25KEDC, BJ25KLEDC, BJ25QLEDC, J25KLEDC, J25QLEDC, J25RMEDC, J25RMLEDC, J25TKEDC, J25TKLEDC 1996
BJ25AREUR, BJ25ARLEUR, BJ25KEUR, BJ25KLEUR, BJ25QLEUR, J25KLEUR, J25QLEUR, J25RMEUR, J25RMLEUR, J25TKEUR, J25TKLEUR 1997
BJ25PL3EEM, J25PL3EEM, J25R3EEM, J25RL3EEM, J25TEL3EEM 1999
BJ25PL3SIE, BJ25VL3SIE, J25PL3SIE, J25R3SIE, J25RL3SIE, J25RV3SIE, J25RVL3SIE, J25TEL3SIE, J25TVL3SIE, J25VL3SIE 2001
BJ25PL3SSB, J25PL3SSB, J25R3SSB, J25RL3SSB, J25TEL3SSB 2000
BJ35ARECR, BJ35ARLECR, BJ35KECA, BJ35KLECA, BJ35QLECA, J35KLECA, J35QLECA, J35TKLECA 1998
BJ35AREDS, BJ35ARLEDS, BJ35KEDC, BJ35KLEDC, BJ35QLEDC, HJ35RMLEDC, J35KLEDC, J35QLEDC, J35RMLEDC, J35TKLEDC 1996
BJ35AREEA, BJ35E3EEM, BJ35EL3EEM, BJ35KEEM, BJ35PL3EEM, J35E3EEM, J35EL3EEM, J35PL3EEM, J35R3EEM, J35RL3EEM, J35TEL3EEM 1999
BJ35AREUC, BJ35ARLEUC, BJ35KEUR, BJ35KLEUR, BJ35QLEUR, HJ35RMLEUR, J35KLEUR, J35QLEUR, J35RMLEUR, J35TKLEUR 1997
BJ35E3SIE, BJ35EL3SIE, BJ35EV3SIE, BJ35EVL3SIE, BJ35PL3SIE, BJ35VL3SIE, J35PL3SIE, J35R3SIE, J35RL3SIE, J35RV3SIE, J35RVL3SIE, J35TEL3SIE, J35TVL3SIE, J35VL3SIE 2001
BJ35E3SSB, BJ35EL3SSB, BJ35PL3SSB, J35PL3SSB, J35R3SSB, J35RL3SSB, J35TEL3SSB 2000
SJ35RWECS, SJ35RWLECS 1998

Information:


Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 1 Start By:
Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Position a suitable container under the radiator drain valves in order to contain the coolant for storage or disposal. Drain approximately 265 L (70 US gal) of coolant from the left side of the radiator. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct procedure.
Install caps and plugs on all openings in order to prevent dirt or debris from entering the system. Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Raise the front hood assembly and the rear hood assembly.
Illustration 1 g00567078
Disconnect hose assembly (1) from elbow (5). Loosen two hose clamps (3) that hold hose (4) to elbow (5) and tube assembly (2).
Illustration 2 g00567079
Put identification marks on four bolts (6) for installation purposes. Remove four bolts (6) that hold elbow (5) to auxiliary water pump (7). Remove elbow (5) from auxiliary water pump (7).
Illustration 3 g00567080
Remove O-ring seal (8) from auxiliary water pump (7).
Illustration 4 g00567081
Disconnect hose assembly (12) from elbow (11). Remove two bolts (10), the washers, and the retainers that hold tube (9) to elbow (11).
Illustration 5 g00567082
Put identification marks on four bolts (14) for installation purposes. Remove four bolts (14), the washers, and the nuts that hold elbow (11) to auxiliary water pump (7). Remove elbow (11) and gasket (13) from auxiliary water pump (7).
Illustration 6 g00567084
Remove O-ring seal (15) and the retaining ring from tube (9).
Illustration 7 g00567086
Disconnect hose assembly (16) from auxiliary water pump (7).
Illustration 8 g00567087
Disconnect hose assembly (18) from the front housing. Loosen bolt (20) that holds idler pulley assembly (19) to the bracket. Remove V-belt (17).
Illustration 9 g00567088
Remove eight bolts (21) and the washers that hold pulley assembly (22) to the auxiliary drive shaft (not shown). Remove pulley assembly (22) from the auxiliary drive shaft (not shown).


Parts screw JOHNSON:

0305513
 
0305513 SCREW, Throttle lever
100ESL71A, 100ESL72R, 115ESL69E, 115ESL70D, 125ESL71C, 125ESL72R, 40E71B, 50ES71S, 50ES75B, 50R79C, 55E76E, 55E77D, 55E78S, 55E79C, 55ES69A, 60ES71C, 65ES72S, 85ESL69E, 85ESL70B, 85ESL71A, 85ESL72R, BJ25ARECA, BJ25AREDC, BJ25AREUR, BJ25PL3EEM, BJ25PL
0314136
 
0314136 SCREW, Throttle cam
100ESL71A, 100ESL72R, 100ML79S, 115EL77S, 115ESL69E, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 55ES69A, 60ES70B, 60ES71C, 65ES72S,
0331578
 
0331578 SCREW, Brkt. to transom, 5"
BJ115ELEDR, BJ115ELEUA, BJ115GLECM, BJ115PLEEM, BJ115PLSIE, BJ115PLSSB, BJ115TLEDA, BJ130PLEED, BJ130PLSSS, BJ130TLECE, BJ130TLEDM, BJ130TLEUB, BJ135PLSIF, BJ150ELECD, BJ150ELEDB, BJ150ELEUC, BJ175EXECD, BJ175EXEDB, BJ175EXEUC, BJ175PLEES, BJ175PLSIF
0908045
 
0908045 SCREW
AM55RSLD, BJ10EEDD, BJ10FAEDC, BJ10FAEUR, BJ10FDLECM, BJ10FDLEDR, BJ10FDLEUA, BJ10RELEUS, BJ10RHLSDA, BJ10RHLSOR, BJ10RHLSRC, BJ10RHLSTS, BJ15EEDS, BJ15FAEDR, BJ15FAEUA, BJ15FDLECM, BJ15RELEUC, BJ20SEECB, BJ20SEEDA, BJ20SEEUM, BJ20SRECB, BJ20SREDA, B
0334884
 
0334884 SCREW
BJ25ARECA, BJ25AREDC, BJ25AREUR, BJ25PL3EEM, BJ25PL3SIE, BJ25PL3SSB, BJ35ARECR, BJ35AREDS, BJ35AREEA, BJ35AREUC, BJ35E3SIE, BJ35E3SSB, BJ40EECR, BJ40EEDS, BJ40EEEA, BJ40EEUC, BJ40ELSIF, BJ40ELSSM, BJ50BEEDS, BJ50EEER, BJ50ELSIF, BJ50ELSSA, BJ50ESECC,
0336165
 
0336165 SCREW, Fuel connector
AM55RSLD, BJ10EEDD, BJ10FAEDC, BJ10FAEUR, BJ10FDLECM, BJ10FDLEDR, BJ10FDLEUA, BJ10RELEUS, BJ10RHLSDA, BJ10RHLSOR, BJ10RHLSRC, BJ10RHLSTS, BJ15EEDS, BJ15FAEDR, BJ15FAEUA, BJ15FDLECM, BJ15RELEUC, BJ20SEECB, BJ20SEEUM, BJ20SRECB, BJ20SREUM, BJ25ARECA, B
0337147
 
0337147 SCREW, Cylinder head cover
BJ10FDLECM, BJ10FDLEDR, BJ10FDLEUA, BJ15FAEDR, BJ15FAEUA, BJ15FDLECM, BJ25ARECA, BJ25AREDC, BJ25AREUR, BJ25PL3EEM, BJ25PL3SIE, BJ25PL3SSB, BJ35ARECR, BJ35AREDS, BJ35AREEA, BJ35AREUC, BJ35E3SIE, BJ35E3SSB, J10FEXEO, J15DLEOC, SJ35RWECS
0341555
 
0341555 SCREW, Throttle adjustment
BJ25ARECA, BJ25AREDC, BJ25AREUR, BJ25PL3EEM, BJ25PL3SIE, BJ25PL3SSB, BJ35ARECR, BJ35AREDS, BJ35AREEA, BJ35AREUC, BJ35E3SIE, BJ35E3SSB, SJ35RWECS
Back to top