0317793 JOHNSON SPACER


0317793 SPACER JOHNSON 115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 135ESL73M, 135ESL74B, 135ESL75E, 65ES73R, 70EL76D, 70EL77S, 70ES74M, 70ES75B, 75ELR76D, 75ELR77S, 75ESLR75B, 85EL76D, 85EL77S, 85ESL73M, 85ESL74B, 85ESL75E SPACER
0317793 SPACER JOHNSON
Rating:
68

Buy SPACER 0317793 JOHNSON genuine, new aftermarket parts with delivery
Number on catalog scheme: 69
 

BRP JOHNSON entire parts catalog list:

115EL77S, 115ETL77 1977
115ESL73M 1973
115ESL74B, 115ETL74B 1974
115ESL75E, 115ETL75E 1975
135ESL73M 1973
135ESL74B, 135ETL74B 1974
135ESL75E, 135ETL75E 1975
65ES73R, 65ESL73R 1973
70EL76D 1976
70EL77S 1977
70ES74M, 70ESL74M, 70ESLR74M 1974
70ES75B, 70ES75E, 70ESL75B, 70ESL75E 1975
75ELR76D, 75ER76D 1976
75ELR77S, 75ER77S 1977
75ESLR75B, 75ESR75B 1975
85EL76D, 85EL76G, 85ETLR76D, 85ETLR76G 1976
85EL77S, 85ETLR77S 1977
85ESL73M 1973
85ESL74B 1974
85ESL75E 1975

Information:


Personal injury can result from improper engine operation.Deviation from these installation instructions can result in improper engine operation which could cause personal injury.Follow the installation instructions before engine operation.
Ignition Module Timing Switch, LED Indicators, And Computer Serial Port
A rotary switch with 16 positions is installed inside the CIS Ignition. This switch is used in the "Mag-Cal" mode of the Caterpillar TCM in order to adjust the retarding effect from the Cam Position (Hall Effect's) signal. This is done in order to stimulate the timing that was formerly provided by the Altronic III at low engine rpm. Adjustment of this switch simulates rotating the Altronic III mechanical position. The timing range is from 0 degrees to 15 degrees with a 1 degree resolution.
Five LED indicators are provided inside the Ignition Module for troubleshooting purposes.
The red "Power LED" is continuously illuminated when the unit is powered and the microprocessor is running.
The red "Power LED" flashes when the "Power LED" is not operating correctly and the unit has power.
The red "Power LED" is off when the unit has no power.
The red "TX LED" flashes when the unit is transmitting on the RS-485 serial link.
The red "RX LED" flashes when the unit has received a transmission on the RS-485 serial link.
The red "ALARM LED" illuminates in order to indicate a warning or a fault is present.
The green "H.E. PICKUP LED" illuminates when a magnet turns on the Hall Effect sensor.
One RS-485 serial communications port is provided within the Ignition Module. This port is normally used for communication to the optional Display Module .The Display Module
The Display Module serves as the customer interface module for the CIS system. A RS-485 serial communications port is used in order to connect the Display Module to the Ignition Module .
An alphanumeric LCD display is used in order to provide an output to the user. A keypad with a sealed membrane is used in order to input the user's data. The LCD display and the keypad function together in order to provide an interactive customer interface module. The interface prompts the user as different functions are selected.
All actions and adjustments are immediate. The actions and adjustments are performed on an incremental basis by using the up arrow and the down arrow. All of the entries from the keypad are performed in the Electronically Erasable Programmable Read Only Memory (EEPROM). This EEPROM retains previous settings even after an engine shutdown or an ignition power shutdown.
Large letters are used on the display screen in order to designate an active selection. Small letters are used in order to indicate other possible options.Understanding The Home Screen
A series of home screens are used in order to describe the current status of the ignition system. The LCD always reverts to one of the home screens after an operation is completed. The LCD will also revert to one of the home screens if an operation takes too much time. The home screen is designed in order to display the most critical operating parameters on one screen.
All of the home screens show the status of the ignition in the upper left hand corner. The engine speed is displayed in the upper right corner. The status of the TCM is displayed on the lower portion of the screen.
Illustration 1 g00329085
The "READY" message is displayed in the upper left hand corner when the ignition is ready to begin cranking the engine. The TCM would normally be in the Manual Mode.
Illustration 2 g00329096
Once the engine begins turning, the "SYNCING" message is displayed while the engine verifies signals from the engine pickups. The proper signals can be identified in as few as two engine revolutions.
Illustration 3 g00329097
The "FIRING" message is displayed when the ignition begins firing. Additional data is provided on this screen in order to describe the selected mode of operation for the ignition. The level of energy (E1, E2, E3 ) is in the middle of the upper screen in small characters. The type of striking is positioned next to the level of energy. The TCM is displayed in the AUTO Mode.
Illustr


Parts spacer JOHNSON:

0316741
 
0316741 SPACER, Stop gear
100ML79S, 115EL77S, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 25E77S, 25E78C, 25E79R, 35E76G, 35E77C, 35E78R, 35E79A, 50ES72C, 50ES73R, 50ES74M, 50ES75B, 50R79C, 55
0315810
 
0315810 SPACER, Propeller nut
100ESL71A, 100ESL72R, 100ML79S, 115EL77S, 115ESL70D, 115ESL73M, 115ESL74B, 115ESL75E, 115ETZ78C, 115ML79R, 115TXL77S, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 135ESL75E, 140ML77S, 140ML78C, 140ML79R, 50ES71S, 50ES72C, 50ES73R, 50ES74M, 50ES75B, 50
0316208
 
0316208 SPACER, Line reverse lock
100ESL71A, 100ESL72R, 115ESL70D, 115ESL73M, 115ESL74B, 125ESL71C, 125ESL72R, 135ESL73M, 135ESL74B, 65ES73R, 85ESL70B, 85ESL71A, 85ESL72R, 85ESL73M, 85ESL74B
0320008
 
0320008 SPACER, Link reverse lock
115EL77S, 115ESL75E, 135ESL75E, 70EL76D, 70EL77S, 70ES74M, 70ES75B, 75ELR76D, 75ELR77S, 75ESLR75B, 85EL76D, 85EL77S, 85ESL75E
0122656
 
0122656 SPACER
115EL77S, 115ESL74B, 115ESL75E, 135ESL74B, 135ESL75E, 85EL76D, 85EL77S
Back to top