9065M Mariner CLAMP BRACKET (STARBOARD)

Electronic Controls
Electronic Control Module
The ECM consists of two main components, the control computer (hardware) and the flash file (software). The ECM consists of a microprocessor and electronic circuitry. The flash file is the software for the control computer which contains operating maps that define power and torque curves. The ECM monitors the engine parameters during operation. The ECM supplies signals to the injector solenoids.The ECM governs engine speed. Desired engine speed is determined by the throttle signal and by certain sensor readings. Actual engine speed is supplied to the ECM by the engine speed/timing sensor.Fuel Injection
The ECM controls the timing of the engine by varying the signals to the electronic solenoids that control fuel injection. Fuel is injected only while an injector solenoid is energized by a 105 V signal from the ECM. By controlling the timing and duration of the 105 V signal, the ECM controls the fuel injection timing, the quantity of fuel and the desired engine speed. Injection timing depends on desired engine speed, load, and other operational factors.The ECM limits engine power during cold mode operation. The ECM may modify the injection timing and the ECM may cut out certain engine cylinders in cold mode operation. Will increase startability and will reduce warm-up time. Cold mode is activated whenever the engine coolant temperature falls below a predetermined value. Cold mode remains active until the engine coolant temperature has risen above a set temperature. The ECM is programmed at the factory to limit the quantity of fuel that can be injected. The position of the Fuel Ratio Control (FRC) controls the fuel limit for exhaust smoke. The FRC is based on the maximum allowable ratio of fuel to air. The FRC fuel position is increased when the ECM senses a higher turbocharger compressor outlet pressure. Will allow more fuel into the cylinder.The rated fuel position is a limit that is based on the engine power rating. Similar to the rack stops and the torque spring on a mechanically governed engine. The rated fuel position limits the power curve and the torque curve for a specific engine family.Illustration 1 is a block diagram of the engine electrical system.
Illustration 1 g00955722
Location of the Engine Components
Illustration 2 g00955647
Left side view (1) Fuel injector connector (2) Left air shutoff (3) Left exhaust temperature sensor (4) Left turbocharger compressor inlet pressure sensor (5) Secondary engine speed/timing sensor (6) Primary engine speed/timing sensor (7) Separate circuit water pump (8) Electric starting motorsLocation of the Engine Components
Illustration 3 g00715556
Left side exploded view (typical example) (9) Unfiltered fuel pressure sensor (10) Filtered fuel pressure sensor (11) Filtered engine oil pressure sensor (12) Unfiltered engine oil pressure sensor (13) Coolant temperature sensor (14) Atmospheric pressure sensor (15) Aftercooler temperature sensorLocation of the Engine Components
Illustration 4 g00955649
Right side view (typical example) (16) Right turbocharger compressor inlet pressure sensor (17) Right exhaust temperature sensor (18) Right air shutoff (19) Fuel injector connector (20) Electronic instrument panel (21) Permanent timing calibration sensor (22) Solenoid for the air starting motor (23) Air starting motor (24) Prelubrication motor (25) Crankcase pressure sensor (26) AlternatorLocation of the Engine Components
Illustration 5 g00955651
Front view (typical example) (27) Unfiltered engine oil pressure sensor (28) Turbocharger compressor outlet pressure sensor (14) Atmospheric pressure sensor (29) Emergency stop push button (30) Secondary Electronic Control Module (ECM) (31) Instrument panel (32) Primary Electronic Control Module (ECM)Location of the Engine Components
Illustration 6 g00955660
Rear view (typical example) (4) Left turbocharger compressor inlet pressure sensor (16) Right turbocharger compressor inlet pressure sensor (29) Emergency stop push button (5) Secondary engine speed/timing sensor (6) Primary engine speed/timing sensor (30) Instrument panel