8212M Mariner CRANKCASE

Illustration 1 g02072237
(1) Generator lifting eyes
(2) Engine lifting eyes
(3) Lifting eyes for the generator set package
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the entire package. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted.Some removals require lifting fixtures to obtain proper balance. Lifting fixtures also help to provide safety.Lifting eyes are designed and installed for each package. Alterations to the lifting eyes and/or the package make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Cat dealer for information regarding fixtures for proper lifting.For package dimensions, refer to table 1.
Table 1
C175-16 Package Dimensions(1)
Length 6903 mm 271.8 in
Width 2155 mm 84.8 in
Height 2811 mm 110.7 in
Weight (1200RPM Engine)(2) 24312 kg 53599 lb
Weight (1500RPM and 1800RPM Engines)(2) 26014 kg 57300 lb
(1) Dimensions depend on generator and options. See general dimension drawings for details.
(2) Weight includes engine, generator, bases, and coupling.Lifting the Entire Package
Illustration 2 g02072138
Illustration 3 g02072213
C175 generator set spreader bars
(4) Spreader bar 5500 mm (216.5 inch)
(5) Front spreader bar 1829 mm (72 inch)
(6) Rear spreader bar 1532 mm (60 inch)Do NOT use the engine lifting eyes or the generator lifting eyes to lift the entire package. Lifting points (3) have been provided on the base rails of the generator set for lifting the entire package. However, lifting the engine and the generator together requires special equipment and procedures. The spreader bars that are illustrated in figure 2 are used with the standard configuration of the generator set and using one crane. If two cranes are used to lift the package, use the front spreader bar and the rear spreader bar only. Consult your Caterpillar dealer for information regarding fixtures for proper lifting of your complete package.Lifting the Engine Only
Illustration 4 g01231042Engine lifting groups (2) are not meant to lift the engine without the installation of the lifting shackles that are shipped with the engine. The lifting groups have a protective cover that prevents using the lifting groups for lifting the package. Follow these steps to lift the engine ONLY:
Remove the protective covers.
Install the shackles onto the lifting groups.
Use a properly rated spreader bar with the shackles to lift the engine ONLY.When you are through lifting the engine, reverse the above procedure to return the engine to the original condition.Lifting the Generator Only
Note: The control panel and the terminal box will need to be removed before attempting to lift the generator.To remove the generator ONLY, use lifting eyes (1) that are on the generator.