68026 Mariner PLATE, RETAINING - DISCONNECT PLUG


68026 PLATE, RETAINING - DISCONNECT PLUG Mariner 7090529, 7115528, 7115529, 7140528, 7140629 PLATE
68026 PLATE, RETAINING - DISCONNECT PLUG Mariner
Rating:
63

Buy PLATE, RETAINING - DISCONNECT PLUG 68026 Mariner genuine, new aftermarket parts with delivery
Number on catalog scheme: 17
 

Compatible models:

Information:


Illustration 1 g01325630
Schematic of the 4 to 20 mA desired speed input
Test Step 1. Inspect the Electrical Connectors and Wiring
Remove the electrical power from the engine. Note: For the following steps, refer to Troubleshooting, "Electrical Connectors - Inspect".
Thoroughly inspect the following components:
J1/P1 connectors
J6/P6 connectors
Wiring and the connections between the terminal box and the device that supplies the 4 to 20 mA signal
Check the torque of the allen head screw for the ECM connectors.
Check the harness and wiring for abrasion and for pinch points between the device that supplies the 4 to 20 mA signal and the ECM. Expected Result:All connectors, pins, and sockets are connected properly. The connectors and the wiring do not have corrosion, abrasion, or pinch points.Results:
OK - The components are in good condition with proper connections. If you are troubleshooting a 524-3 diagnostic code, proceed to Test Step 2. If you are troubleshooting a 524-4 diagnostic code, proceed to Test Step 5.
Not OK - The components are not in good condition and/or at least one connection is improper.Repair: Perform the necessary repairs and/or replace parts, if necessary.STOPTest Step 2. Check for an Open Circuit
Remove the two wires (+ and −) for the 4 to 20 mA signal from the device that supplies the 4 to 20 mA signal.
Install a jumper wire between the two wires (+ and −) that were removed from the device that supplies the 4 to 20 mA signal.
Disconnect the P1 connector from the ECM.
Measure the resistance between terminals P1-36 and P1-37 on the ECM side of the P1 connector. Expected Result:The resistance is less than 5 Ohms.Results:
OK - The resistance is less than 5 Ohms. The circuit is not open.Repair: Remove the jumper wire. Insulate the wire leads with electrical tape in order to ensure that the leads do not create a short circuit.Proceed to Test Step 3.
Not OK - The resistance is greater than 5 Ohms. There is a problem with a connector and/or the wiring from the P1 connector.Repair: The problem may be between the P1 connector and the J6 connector. Alternatively, the problem may be between the J6 connector and the device that provides the 4 to 20 mA signal.Repair the connection and/or the wire, when possible. Replace parts, if necessary. Verify that the problem is resolved.STOPTest Step 3. Check for a Short Circuit to the +Battery at Terminal P1-36
Verify that the electrical power is removed from the engine.
Make sure that there is no electrical power to the device that provides the 4 to 20 mA signal.
Measure the resistance between terminals P1-36 and P1-57 on the ECM side of the P1 connector. Expected Result:The resistance is


Parts plate Mariner:

45336
 
45336 PLATE, MANIFOLD
7045217, 7050200, 7050716, 7060312PC, 7060507, 7060524, 7060528, 7070520, 7080629, 7090520, 7090529, 7115520, 7115528, 7115529, 7140528, 7140629
66096A 1
 
66096A 1 PLATE ASSEMBLY, EXHAUST EXTENSION
7080508, 7085507, 7090529, 7115528, 7115529, 7140528, 7140629
74257A 3
 
74257A 3 PLATE ASSEMBLY, DRIVE SHAFT HOUSING
7080508, 7085507, 7090529, 7115528, 7115529, 7140528, 7140629
32435
 
32435 PLATE, FACE - WATER PUMP BASE TO WATER PUMP BODY
7002201DK, 7075524, 7080508, 7080629, 7085507, 7090520, 7090524, 7090529, 7115473JD, 7115520, 7115528, 7115529, 71354120D, 7135412AD, 7135412ED, 7135412HD, 7135412JD, 7135417PD, 7135473GD, 7135473HD, 7135473KD, 7135826, 7140528, 7140629, 7150413ED, 7
38051
 
38051 PLATE, SUPPORT - EXHAUST TUBE SEAL
7080508, 7080629, 7085507, 7090520, 7090529, 7115520, 7115528, 7115529, 7140528, 7140629
48671
 
48671 PLATE, THROTTLE ACTUATOR
7115528, 7115529, 7140528, 7140629
75778
 
75778 PLATE, BAFFLE - EXHAUST MANIFOLD
7090520, 7115520, 7115528, 7115529, 7140528, 7140629
79479
 
79479 PLATE, ELECTRICAL MOUNTING
7090529, 7115529, 7140629
Back to top