81047M Mariner RETAINER, MAGNETO BASE...


81047M RETAINER, MAGNETO BASE... Mariner 7008208, 7008238, 7008247, 7008248, 7015207 RETAINER
81047M RETAINER, MAGNETO BASE... Mariner
Rating:
48

Buy RETAINER, MAGNETO BASE... 81047M Mariner genuine, new aftermarket parts with delivery

You can buy parts:

As an associate, we earn commssions on qualifying purchases through the links below
$16.49
 

03-07-2023

-: -
Mercury Marine/Mercruiser New OEM Magneto Base Retainer, 81047M
Number on catalog scheme: 19
 

Compatible models:

Mariner entire parts catalog list:

7008208 1978
7008238 1978
7008247 1977,1987
7008248 1978
7015207 1977

Information:


Table 1
Table For The PTO Kickout Status Screen On ET    
ET    Meaning or Possible Cause    Troubleshooting    
No Engine Speed     Intermittent engine speed signal or lost engine speed signal.     Refer to Troubleshooting, "Speed/Timing Circuit - Test".    
Switch Turned Off     The PTO On/Off switch is turned OFF or the switch circuit has an open circuit condition.     Proceed with the test procedure.    
"Cruise Control PAUSE Switch"     The cruise pause switch is depressed or there is an illegal message on the J1939 data link.     Refer to Troubleshooting, "Powertrain Data Link Circuit - Test".    
"Brake Pedal Depressed"     The service brake pedal is depressed or the service brake switch circuit has an open circuit condition.     Refer to Troubleshooting, "Service Brake Pedal Position Switch 1 Circuit - Test".    
"Clutch Pedal Depressed"     The clutch pedal is depressed or the clutch pedal switch circuit has an open circuit condition. Also, the switch could be incorrectly adjusted.     Refer to Troubleshooting, "Cutch Pedal Position Switch Circuit - Test".    
Vehicle Speed ? Limit     The vehicle speed has exceeded the PTO Vehicle Speed Limit or the vehicle speed signal is erratic or intermittent.     Refer to Troubleshooting, "Vehicle Speed Circuit - Test" if a problem with the signal exists.    
Neutral     The transmission is not in neutral or the transmission neutral switch circuit has an open circuit condition.     Refer to Troubleshooting, "Neutral Switch Circuit - Test".    
"No Occurrence"
or
"Not Kicked Out"     The PTO has not been enabled since the ECM has been powered up.     Operate the vehicle in the PTO mode in order to create the problem again.    
Illustration 1 g00644420
This illustration is for the schematic for "cab switches" for "PTO configuration".
Illustration 2 g00644427
This illustration is for the schematic for "remote switches" for "PTO configuration".
Illustration 3 g00644448
This illustration is for the schematic for "remote throttle" for "PTO configuration".Test Step 1. Check the Programming of the Dedicated PTO Customer Parameter.
Connect ET to the cab data link connector.
Turn the ignition key switch to the ON position.
Access the Dedicated PTO Customer Parameters on ET. Note the programming of the PTO Configuration Parameter.Expected Result:The "PTO Configuration" is programmed to "Cab Switches", "Remote Switches", or "Remote Throttle".Results:
Yes - Proceed to Test Step 2.
No - The Dedicated PTO features are not programmed for this engine. If PTO operation is desired, the "PTO Configuration" must be programmed to "Cab Switches", "Remote Switches", or "Remote Throttle". Stop.Test Step 2. Determine the PTO Installation Setup.
From the programming of the PTO Configuration Parameter, review the truck wiring in order to determine the method of installation of the wiring. Talk to the driver about the use of the PTO.
Check the cab glove box for any information regarding the installation of the PTO. It is important to understand the location and the function of the PTO Interlocks that are used in the installation.
Contact the installer of the PTO component, if necessary.
Determine the schematic that most closely matches the installation. Review the schematics in this procedure for each of the options for the specific "PTO Configuration "of the truck.
Record the "PTO Configuration".Expected Resu


Parts retainer Mariner:

20430
 
20430 RETAINER
7005201, 7005207, 7005227, 7008204, 7008208, 7008226, 7008238, 7008247, 7008248, 7008305, 7010209, 7015207, 7015307, 7015327, 7015529, 7020201, 7025200, 7025207NW, 7025500, 7026226, 7028207, 7028527, 7030200, 7030205, 7030301, 7040202, 7040206, 70402
82608M
81048M
 
81048M RETAINER, MAGNETO BASE...
7008208, 7008238, 7008247, 7008248, 7015207
80609M
 
80609M RETAINER, CHECK VALVE
7015207, 7015307, 7015327, 7028207, 7028527, 7040207, 7040507, 7048207, 7048227, 7048321, 7055324, 7055524, 7060507, 7060522, 7060528
80228M
 
80228M RETAINER, SHIFT DETENT
7015207, 7015307, 7015327
11443M
 
11443M RETAINER, MAGNETO BASE
7008204, 7008208, 7008226
Back to top