852151A 1 Mariner TOOL KIT

Introduction
This Special Instruction will guide the user through graphing snapshots that records Engine Diagnostics.Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person must also have the necessary training, skills, and tools to perform these functions properly. Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance of a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Avoid using a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar. If used, ensure the safety of the operating personnel and others.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, turn the battery disconnect switch to the OFF position. Remove the key for the battery disconnect switch. Use a secure padlock in order to lock the battery compartment access door.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Graphing Snapshot Using Excel
Opening a Snapshot
Follow the below steps for opening a snapshot:
Find and open the zipped Snapshot archive, then open the ".slk" snapshot file.
Illustration 1 g06046064
Select and open a recorded snapshot .zip.
Illustration 2 g06048479
After opening the zip file, select the ".slk" file (if necessary, extract file from archive).
Illustration 3 g06046704
The Snapshot should open with Excel.Preparing Excel for Graphing
Note: If this procedure is not performed correctly, the graph will not turn out as required. Once completed on the (or each) laptop, all snapshots will graph without needing to repeat the procedure.
To prepare Excel for graphing in Excel 2010 and Older, follow the below steps:
Illustration 4 g06046711
In the (already open) snapshot, select the "Insert" tab (A).
Illustration 5 g06046706
Under "Charts" , click the bottom right corner arrow, "Create Chart" (B).
A new window will appear, select "X Y (Scatter)" (C).
Select "Scatter with Smooth Lines" (D) .
Once highlighted, select "Set as Default Chart" (E).
Click "Cancel" when done (F).
To prepare Excel for graphing in Excel 2013, follow the below steps:
Illustration 6 g06047262
In the (already open) snapshot, select (any consecutive) multiple cells (A).
Select the "Insert" tab (B).
Illustration 7 g06046724
Under "Charts", click the bottom right corner arrow, "See All Charts" (C).
Select the "All Charts" tab (D).
In the Charts Pane, select "X Y (Scatter)" (E).
Select "Scatter with Smooth Lines" then right-click on it and select "