53338 Mercruiser FILTER VALVE ASSEMBLY


53338 FILTER VALVE ASSEMBLY Mercruiser 00014332, 02287333, 02602347, 02607333, 02608427, 03302336, 03307332, 07711346, 08986342, 08987343, 228801, 257B021JS, 260801, 40500006T, 4332087N1, 4350100KS, 4350104JS, 4350104KS, 4350111HS, 4350118JS, 4350118KS, 4441027LE, 444106AM1, 444106LPS, 44 FILTER
53338 FILTER VALVE ASSEMBLY Mercruiser
Rating:
78

Buy FILTER VALVE ASSEMBLY 53338 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 31
 

Mercruiser entire parts catalog list:

00014332 1982
02287333 1983
02602347 1987,1988,1989,1990,1991,1992,1993,1994,1995
02607333 1983
02608427 1987
03302336 1986
03307332 1982
07711346 1986,1987
08986342 1982,1983
08987343 1983,1984,1985,1986,1987
228801 1981,1982
257B021JS 1996,1997
260801 1981,1982,1987
40500006T 1998
4332087N1 1998
4350100KS 1997
4350104JS 1996
4350104KS 1997
4350111HS 1995
4350118JS 1996
4350118KS 1997
4441027LE 1998
444106AM1 1998
444106LPS 1998
444236HRS 1998
457B100KS 1997
457B101JS 1996
457B101KS 1997
457B111GS 1994,1995
457L101JS 1996
4M11025LS 1998
4M11025RS 1998
4M11025TS 1998
4M11025TT 1998
4M31027LS 1998
4M4102LPS 1998
4M4102LRS 1998
4M4102LTS 1998
4R42027N1 1998

Information:


Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 575 Sealant 1
B - Guide Studs
M8 by 40 mm 2
C - Alignment Tool 1
- Bolts
M10 by 50 mm 3
D - Delphi Lockheed Rubber Grease 1
E - Loctite 609 Bearing Mount Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that wiring harness are correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness convoluting.
Ensure that the front housing is clean and free from damage. If necessary, replace the front housing.If necessary, install blanking plugs to a new front housing. Use Tooling (A) to seal all D-plugs.
Clean all the gasket surfaces of the cylinder block.
Illustration 1 g02201113
Illustration 2 g02201114
Inspect dowel (13) and dowel (14) for damage. If necessary, replace the dowels in the cylinder block.
Install thrust washer (12) into the recess in the cylinder block. Refer to Disassembly and Assembly, "Camshaft - Install" for more information.
Install Tooling (B) to the cylinder block. Refer to Illustration 2.
Align a new gasket (11) with Tooling (B). Install the gasket to the cylinder block.Note: Ensure that two circular Tabs (X) on the gasket are engaged in two Holes (Y) in the cylinder block. Ensure that dowel (14) in the cylinder block is engaged on the gasket.
Install Tooling (C) to the cylinder block.
Illustration 3 g02201115
If necessary, follow Step 8a through Step 8c to install bearing (7) to housing (4).
Apply a small continuous bead of Tooling (E) to outer Surface (Z) of bearing (7).
Place housing (4) onto a suitable support.
Use a suitable tool to press bearing (7) into housing (3) until the bearing is in the correct position within the housing. Remove any excess bearing mount compound.
Install the front housing over Tooling (B) and Tooling (C) onto the cylinder block.
Illustration 4 g02201116
(8) M8 by 20 mm
(9) M8 by 35 mm
(10) M8 by 25 mm
Install new bolts (10) to front housing (3) hand tight.
Remove Tooling (B).
Loosely install bolts (8) and bolts (9) finger tight. Refer to Illustration 4 for the correct position of the bolts.
Illustration 5 g02058297
Tighten bolts (8), bolts (9) and bolts (10) in the sequence that is shown in Illustration 5 to a torque of 28 N m (248 lb in).
Remove Tooling (C) from the cylinder block.
Illustration 6 g02198874
Install new O-ring seal (5) and O-ring seal (6) to bypass tube (1). Use Tooling (D) to lubricate the O-ring seals.
Install bypass tube (1) to the cylinder head. Install bolts (1). Tighten the bolts to a torque of 9 N m (80 lb in).
Install a new cable strap (2) to wiring harness assembly.End By:
Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install" for the correct procedure.
Install the timing gears. Refer to Disassembly and Assembly, "Gear Group (Front) - Install" for the correct procedure.
If the engine has an accessory drive, install the accessory drive. Refer to Disassembly and Assembly, "Accessory Drive - Remove and Install" for the correct procedure.
Install the engine oil pan plate. Refer to Disassembly and Assembly, "Engine Oil Pan Plate - Remove" for the correct procedure.
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Install" for the correct procedure.
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install" for the correct procedure.
Install the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Fill" for the correct procedure.


Parts filter Mercruiser:

53336
 
53336 FILTER, FUEL INLET-AIR HORN
01206002, 01207333, 01326013, 01406002, 01407333, 02287333, 02602347, 02607333, 02608427, 03302336, 03307332, 04706002, 04707333, 04708004, 04856332, 08986342, 2165203, 2165208, 228801, 257B021JS, 260801, 2888203, 30001854, 37011856, 4111021L1, 430B0
807172
 
807172 FILTER, Fuel/Water Separator
02602347, 02608427, 257B021JS, 4231017L1, 4262C01JT, 4350100KS, 4350104JS, 4350104KS, 4350111HS, 4350118JS, 4350118KS, 443B100JS, 443HC00JT, 4441027LE, 444106AM1, 44541101S, 4454110JT, 4454118JT, 45021102S, 4502111FE, 457B100KS, 457B101JS, 457B101KS,
53336Q
FILTER-FUEL
53336Q FILTER-FUEL
4111021L1, 4111021TS, 4111021UT, 4111021UU, 411102KN2, 4211015L1, 4211025RS, 4211025TS, 4211025TT, 4211025US, 4211025UU, 474H110AR, 4M11025LS, 4M11025RS, 4M11025TS, 4M11025TT, 4M11025US
17422
 
17422 FILTER
4350118KS, 4454118JT, 4502111FE, 4652027LE, 4652027M1, 474L118JS, 474L118JT
807288
 
807288 FILTER
4350111HS, 4350118JS
802885Q
 
802885Q FILTER, Oil
40430002S, 40500006T, 4111021L1, 4111021TS, 411102KN2, 4211015L1, 4211025RS, 4211025TS, 4211025TT, 4231017L1, 424106LRS, 424106LTT, 4332087N1, 4441027LE, 444106LPS, 444236HRS, 4542067LS, 4652027LE, 4652027M1, 4652227MW, 4M11025LS, 4M11025RS, 4M11025T
802885T
 
802885T FILTER, Oil
40430002S, 40500006T, 4111021L1, 4111021TS, 411102KN2, 4211025RS, 4211025TS, 4211025TT, 424106LRS, 424106LTT, 444106LPS, 444236HRS, 4M11025RS, 4M11025TS, 4M11025TT, 4M4102LPS, 4M4102LRS, 4M4102LTS, 4S42028N1, 4S42028TS, 4S42028TT
864572T
 
864572T FILTER, Inline, Fuel ( INLINE )
444236HRS, 4M4102LRS, 4S42028N1
Back to top