23567 Mercruiser CLIP


23567 CLIP Mercruiser 40420001D, 4111021L1, 411102KN2, 428B116KD, 442B115KD, 4A72040ND, 4C8204DLD, 4CJ2040ND, 5000147JS, 5000150DP, 5000165CE, 5111200LP, 5120136JS, 5120150AR, 5120150R1, 5220200AS, 5231100LP, 5232100N1, 5C30150FS, 5E31200N1, 6020006JS, 6211001N1, 6311002N CLIP
23567 CLIP Mercruiser
Rating:
83

Buy CLIP 23567 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 10
 

Mercruiser entire parts catalog list:

40420001D 1998
4111021L1 1998
411102KN2 1998
428B116KD 1997,1998
442B115KD 1997
4A72040ND 1998
4C8204DLD 1998
4CJ2040ND 1998
5000147JS 1996,1997
5000150DP 1991,1992,1993,1994,1995
5000165CE 1990,1991
5111200LP 1998
5120136JS 1996,1997,1998
5120150AR 1988,1989,1990,1991,1992,1993,1994,1995
5120150R1 1998
5220200AS 1988
5231100LP 1998
5232100N1 1998
5C30150FS 1993,1994,1995,1996,1997,1998
5E31200N1 1998
6020006JS 1996,1997
6211001N1 1998
6311002NZ 1998
6315001N1 1998
6315002NZ 1998
6416003N2 1998
6511102N1 1998
6811001N1 1998

Information:

Recommended Actions
ECM Personality module
If a new ECM has been installed on the engine, the Engine will not start. Also, the ECM will not communicate with the ET until the correct personality module has been flashed into the ECM.
Verify that the following diagnostic is not active.
CID 253-FMI 02, SPN 234-FMI 02, Flash Code 56, Personality Module mismatchIf the code is active, access the "Winflash" and flash the correct version of the software.Electrical power to ECM
Turn the keyswitch OFF.
Check the positive battery and negative battery connections to the ECM.
Perform a pull test on positive battery wires and negative battery wires.
Check the negative battery connection on the Ground Stud.
Turn the keyswitch ON.
The warning lamps should come on for 2 - 4 seconds.If the warning lamp comes on for 2 to 4 seconds, continue to follow this procedure.If the warning lamp does not come on for 2 to 4 seconds, refer to Troubleshooting, "Electrical Power Supply Circuit - Test".Remote shutdown switch
Access the ET screen that displays the Remote Shutdown Switch status. The Remote Shutdown Switch status on the ET is called "User Shutdown".
Table 1
"User Shutdown Status"     Switch Status     Measured Voltage at P61:27    
ON     Negative battery     <0.9 VDC    
OFF     Open Circuit     >10 VDC    If the voltage is not in the proper range, refer to Troubleshooting, "Remote Shutdown Switch Circuit - Test".Starting Motor Solenoid or Starting Circuit
Test the operation of the starting motor solenoid.
Check the engine wiring to the starting motor solenoid.
Test the operation of the starting motor.
Inspect the starter motor pinion and the flywheel ring gear for damage.Engine speed/timing sensors
Observe the engine speed on the ET while the engine is being cranked.This situation may require a direct hookup to the batteries in order to power the ET while the engine is cranking. Refer to illustration 1 for the wiring diagram.
Illustration 1 g00748412
If the engine is cranking and the ET displays 0 rpm, a problem exists in the circuits for the engine speed/timing sensors. The problem is in the circuit for the engine speed/timing sensor (crankshaft) or the circuit for the engine speed/timing sensor (camshaft). Refer to Troubleshooting, "Engine Speed/Timing Sensor Circuit - Test".If an engine speed is present, check the sensor installation. If the sensor is not properly installed, the ECM may read engine speed, but the ECM cannot determine the tooth pattern. The ability for the ECM to read the tooth pattern is necessary to determine the cylinder position. Engine speed is present when engine speed is greater than 50 rpm. Refer to Troubleshooting, "Engine Speed/Timing Sensor Circuit - Test".Electrical connections to the electronic unit injector
Ensure that the electronic unit injector connector (J300/P300) is fully connected and ensure that the electronic unit injector connector (J300/P300) is free of corrosion.
Check for logged diagnostic codes that are related to the cylinder. Go to Troubleshooting, "Injector Solenoid Circuit - Test" if diagnostic codes that are related to the cylinder are present.Check the Fuel Supply
Monitor the exhaust for smoke while the engine is being cranked.If no smoke is present, there may be a problem with the fuel quality or there may be a problem with the fuel supply.
Check the fuel pressure. Refer to Testing and Adjusting, "Fuel System Pressure - Test".
Ensure that the fuel system has been primed. Refer to Testing and Adjusting, "Fuel System - Prime".
Check for fuel supply lines that are restricted.
Check the fuel filters.
If the temperature is below 0 °C (32 °F), check for solidified fuel (wax).Check for Combustion Problems
Examples of combustion problems are shown in the following list:
Outside temperatures are too cold.
Mechanical problem


Parts clip Mercruiser:

20233
 
20233 CLIP, RETAINING - SHIFT SHAFT
00014332, 2140208, 2165208, 2250507, 5220200AS, 91331015
86049
 
86049 CLIP, Grounding, BELLOWS
00014332, 00019003, 01321017, 01326013, 03301310, 2140208, 2165208, 5000147JS, 5000150DP, 5000165CE, 5111200LP, 5120136JS, 5120150AR, 5120150R1, 5220200AS, 5231100LP, 5231100TP, 5232100N1, 5232100TP, 5C30150FS, 5E31200N1, 5E31200TP, 5E31200TS, 5E3121
24836
 
24836 CLIP, CUT-OUT SWITCH LEAD TO TRANSOM PLATE
44031854, 5220200AS, 5P4AB04HH, 5P4AB04IH, 91331015
808675
CLIP, Spring
808675 CLIP, Spring
02602347, 02608427, 257B021JS, 4111021L1, 4111021TS, 4111021UT, 4111021UU, 411102KN2, 4211015L1, 4211025RS, 4211025TS, 4211025TT, 4211025US, 4211025UU, 430B00001, 430L000JS, 4350100KS, 443B1003S, 443B100JS, 443HC00JT, 457B100KS, 4M11025LS, 4M11025RS,
805625
 
805625 CLIP, Dipstick Tube
02602347, 02608427, 257B021JS, 40430002S, 40500006T, 40500010T, 40500010U, 40500120U, 4211015L1, 4231017L1, 4332087N1, 4350100KS, 4350104JS, 4350104KS, 4350111HS, 4350118JS, 4350118KS, 442B110GD, 442B115KD, 443B1003S, 443B100JS, 4441027LE, 444106AM1,
12994
 
12994 CLIP
5000147JS, 5000150DP, 5000165CE, 5111200LP, 5120136JS, 5120150AR, 5120150R1, 5220200AS, 5231100LP, 5231100TP, 5232100N1, 5232100TP, 5C30150FS, 5E31200N1, 5E31200TP, 5E31200TS, 5E31210TP, 5E31210TS, 5E31800TP, 5E31800TS, 5E31810TP, 5E31810TS, 5E31900T
18904
 
18904 CLIP
40420001D, 428B116KD, 4350111HS, 4350118JS, 442B110GD, 442B115KD, 4A72040ND, 4C72040TD, 4C8204DLD, 4CJ2040ND
801333424
 
801333424 CLIP
40420001D, 40420002D, 428B116KD, 442B110GD, 442B115KD, 4A72040ND, 4C72040TD, 4C8204DLD, 4CJ2040ND
Back to top