AVS Marine

7035 Mercruiser CONDENSOR


  1. Home
  2. Parts
  3. Mercruiser
  4. Condensor
  5. 7035
7035 CONDENSOR Mercruiser 00014332, 01206002, 01207333, 01326013, 01402414, 01406002, 01407333, 01751347, 01851333, 01854335, 02287333, 02297343, 02607333, 02608427, 03302336, 03307332, 03308333, 04544347, 06661346, 07711346, 08986342, 08987343, 228801, 260801, 30001854, 3200 CONDENSOR
7035 CONDENSOR Mercruiser
Price: query
Rating:
93

Buy CONDENSOR 7035 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 23
Scheme 7035
 

Compatible models:

00014332   01206002   01207333   01326013   01402414   01406002   01407333   01751347   01851333   01854335   02287333   02297343   02607333   02608427   03302336   03307332   03308333   04544347   06661346   07711346   08986342   08987343   228801   260801   30001854   32001876   37011856   44031854   4454110AS   474H110AR   Mercruiser

Mercruiser entire parts catalog list:

00014332 1982
01206002 1982,1983
01207333 1983
01326013 1983
01402414 1984,1985,1986,1987,1988,1989
01406002 1982
01407333 1983
01751347 1987,1988,1989,1990,1991,1992
01851333 1983,1984
01854335 1985,1986
02287333 1983
02297343 1983,1985,1986
02607333 1983
02608427 1987
03302336 1986
03307332 1982
03308333 1983,1984,1985,1987
04544347 1987
06661346 1986,1987,1988,1989
07711346 1986,1987
08986342 1982,1983
08987343 1983,1984,1985,1986,1987
228801 1981,1982
260801 1981,1982,1987
30001854 1984,1986
32001876 1986,1987
37011856 1986,1987
44031854 1984
4454110AS 1988,1989,1991,1992
474H110AR 1988,1989,1990,1991

Information:

If the application is equipped with two throttles, the engine will use the second throttle until the fault is repaired.If a second throttle is not installed or if the second throttle has a fault, the following conditions will occur:
The engine will default to limp home mode.
If the engine speed is higher than the speed in limp home mode, the engine will decelerate to limp home mode.
If the engine speed is lower than the speed in limp home mode, the engine speed will remain at the current speed.
The engine will remain at this speed while the diagnostic code remains active.
All inputs from the faulty throttle are ignored by the ECM until the fault is repaired.
All inputs from the repaired throttle will be ignored by the ECM until the keyswitch has been cycled.The IVS may be installed. The IVS is required for mobile applications. The IVS is part of the throttle position sensor. The IVS is CLOSED when the low idle is set.The configuration parameters for the throttle and for the IVS thresholds are programmed into the ECM. Use the electronic service tool in order to display the configuration parameters for the throttle and for the IVS.If the IVS operates outside of the programmed range, then the engine speed may not respond to changes in the throttle position.The electronic service tool may be used for the following:
If necessary, reset the IVS threshold for an existing IVS.
If necessary, view the IVS change point and reset the IVS thresholds when a new throttle assembly is installed.
Illustration 1 g03771038
Schematic diagram for the Idle Validation Switch (IVS) switch circuit
Illustration 2 g03771057
View of the pin locations on the P1 connector for the IVS circuit
(42) IVS 2
(76) IVS 1
Table 2
Troubleshooting Test Steps Values Results
1. Check for Active Diagnostic Codes
A. Establish communication between the electronic service tool and the ECM. Refer to Troubleshooting, "Electronic Service Tools"
B. Check for active or logged codes.
Diagnostic Trouble Codes
Result: There is an active or logged , 558-2 or 2970-2 diagnostic code.
Proceed to Test Step 2.
2. Check the Operation of the IVS
A. Turn the keyswitch to the OFF position.
B. Connect the electronic


Back to top