89212 Mercruiser COTTER PIN, CLUTCH ACTUATING SHAFT

Operating Information
There are three modes of display for the engine data: Analog, digital and bar graph. The following parameters are displayed:
Battery Voltage
Boost Pressure
Coolant Temperature
Engine Hours
Engine Speed
Fuel Rate
Fuel Temperature
Inlet Manifold Temperature
Oil Pressure
Oil Temperature
Percent LoadNote: The Oil Temperature and the Inlet Manifold Temperature will be displayed if the engine is equipped with the appropriate sensors.Display Modes
Illustration 1 g03673778
(1) Cat Marine Power Display (CMPD)
(2) "ALARM ACKNOWLEDGEMENT"
(3) "SCREEN" display
(4) "ARROW" keys Day Mode - The normal display is a white background with black letters and gauges. Press and hold down screen display (3) in order to display the slide bar that adjusts the contrast. Use arrow keys (4) to adjust the contrast.Night Mode - Press screen display (3) in order to change the display. The display will have a black background with red letters and gauges. Press and hold down screen display (3) again in order to display the slide bar that adjusts the brightness. Use arrow keys (4) to adjust the brightness. Press screen display (3) again in order to display the slide bar that adjusts the contrast while the Backlight is on. Use arrow keys (4) to adjust the contrast. Press screen display (3) in order to exit the bar that adjusts the contrast.Diagnostic Data
All diagnostic messages from the engine Electronic Control Module (ECM) are indicated by both a visual alarm and an audible alarm. Diagnostic indicators will not be shown when there are no active diagnostic codes. The diagnostic indicator will appear in the upper left corner of the screen. A window that describes the diagnostic code will appear in the center of the screen, and the audible alarm will sound. Press alarm acknowledgment (1) in order to silence the alarm. Press alarm acknowledgment (1) again in order to scroll through the diagnostic codes or remove the diagnostic codes. The diagnostic code indicator will remain on the screen until the fault is corrected.Note: The loss of signal to the display will result in a Diagnostic Code with the description “"NO DATA LINK"”.Marine Power Display Configuration And Operation
The Cat Marine Power Display can be programmed for three users with five screens for each user. Three users can set up the Cat Marine Power Display for the preferences of each user.The buttons have multiple functions that are dependent on the screen that is displayed.Reference: See Operator Manual, LEBM0189, "Marine Power Display" for the functions of the buttons."System Information"
When power is first applied, scroll through the screens until the “System Information” screen is shown. This screen allows the following parameters to be configured: "User Name", "Unit Location", "Display Units" and "Vessel Speed". A menu driven screen is located in the upper right corner of the Marine Power Display screen. Press alarm acknowledgment (1) in order to display the functions of the buttons.Reference: See Operator Manual, LEBM0189, "Marine Power Display" in order to configure the parameters.Gauge Screens
The gauge screens can be configured with three different sizes of three types of gauges. Each user can configure the screens to display the engine data according to individual preferences. Each user can configure the screens to display the engine data in the following formats: analog, digital and bar graph.Note: Consult your Cat Dealer in order to customize the screens of the Cat Marine Power Display.