56936 Mercruiser FRAME ASSEMBLY, SLIP RING END


56936 FRAME ASSEMBLY, SLIP RING END Mercruiser 08986342 FRAME
56936 FRAME ASSEMBLY, SLIP RING END Mercruiser
Rating:
33

Buy FRAME ASSEMBLY, SLIP RING END 56936 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 41
 

Compatible models:

08986342   Mercruiser

Mercruiser entire parts catalog list:

08986342 1982,1983

Information:


Table 1
Diagnostic Codes for the EPP Relay
J1939 Code Code Description Comments
1075-5 Engine Electric Lift Pump for Engine Fuel Supply : Current Below Normal The Electronic Control Module (ECM) detects a low current condition in the EPP relay circuit.
The warning light will come on. The diagnostic code will be logged.
The ECM is unable to activate the relay for the EPP. The EPP will not operate or the EPP will operate all the time. The engine will not operate.
1075-6 Engine Electric Lift Pump for Engine Fuel Supply : Current Above Normal The ECM detects a high current condition in the EPP relay circuit.
There is a high current condition in the EPP relay circuit for more than 2 seconds.
The warning light will come on. The diagnostic code will be logged.
The ECM is unable to activate the relay for the EPP. The EPP will not operate or the EPP will operate all the time. The engine will not operate. The following background information is related to this procedure:The EPP is used to provide positive fuel pressure to the high-pressure fuel pump. When the keyswitch is turned to the ON position, the ECM will activate the EPP. If the engine is not running, the ECM will deactivate the EPP after 2 minutes.Not all engines are equipped with an EPP. Ensure that the ECM parameters for the EPP are correctly configured for the hardware equipped.There are three different installation configurations:Engines equipped with a single fuel filter and a manual fuel priming pump An EPP is not installed in this system. Set the "Engine Fuel Lift Pump Installation Status" to "Not Installed".Engines equipped with a single fuel filter and an EPP Set the "Engine Fuel Lift Pump Installation Status" to "Installed". Set the "Periodic Fuel Priming Enable Status" to "Enabled".Engines equipped with two fuel filters and an EPP Set the "Engine Fuel Lift Pump Installation Status" to "Installed". Set the "Periodic Fuel Priming Enable Status" to "Disabled".Refer to Systems Operation, Testing and Adjusting for more information on the different types of fuel system installation configurations.
Illustration 1 g06497975
Schematic for the Electric Priming Pump (EPP) relay
During the following procedure, refer to the electrical schematic for the application.Complete the procedure in the order in which the steps are listed.
Table 2
Troubleshooting Test Steps Values Results
1. Inspect Electrical Connectors and Wiring
A. Turn the


Parts frame Mercruiser:

33295
 
33295 FRAME, COMMUTATOR END - LOWER
01206002, 01207333, 01326013, 01406002, 01407333, 02287333, 02607333, 03302336, 03307332, 08986342, 228801, 260801
79211
 
79211 FRAME, COMMUTATOR END - LOWER
00014332, 01206002, 01207333, 01326013, 01402414, 01406002, 01407333, 01701335, 01751347, 01851333, 01854335, 02287333, 02297343, 02602347, 02607333, 02608427, 03302336, 03307332, 03308333, 04544347, 04707333, 04708004, 04881333, 06661346, 07711346,
56954
 
56954 FRAME, DRIVE END
01206002, 01207333, 01326013, 01402414, 01406002, 01407333, 08986342
71704
 
71704 FRAME, DRIVE END
01206002, 01207333, 01326013, 01406002, 01407333, 08986342
60689
 
60689 FRAME ASSEMBLY, SLIP RING END
01206002, 01207333, 01326013, 01406002, 01407333, 08986342
Back to top