804912T01 Mercruiser PAN, Oil


804912T01 PAN, Oil Mercruiser 4211025US, 424106LUS PAN
804912T01 PAN, Oil Mercruiser
Rating:
58

Buy PAN, Oil 804912T01 Mercruiser genuine, new aftermarket parts with delivery

You can buy parts:

As an associate, we earn commssions on qualifying purchases through the links below
$199.95

30-01-2025
16.0[7.20] Pounds
US: Center State Marine
Marine Oil Pan - 4.3L Aluminum years 1997-2007, Mercruiser 804912T01, Volvo Penta 3858697
Marine Engines 4 Less For use on engines years 1997-2007. || OE replacement for Mercruiser 804912T01. || OE replacement for Volvo Penta 3858697. || Aluminum oil pan for engine block casting number 090 or 090M.
Number on catalog scheme: 9
 

Compatible models:

4211025US   424106LUS   Mercruiser

Mercruiser entire parts catalog list:

4211025US 1998
424106LUS 1998

Information:


Illustration 1 g00921815
Boiling point of water
Remember that temperature and pressure work together. When a diagnosis is made of a cooling system problem, temperature and pressure must be checked. Cooling system pressure will have an effect on the cooling system temperature. For an example, refer to Illustration 1. This will show the effect of pressure on the boiling point (steam) of water. This will also show the effect of height above sea level.
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand.Cooling System Conditioner contains alkali. Avoid contact with skin and eyes.
The coolant level must be to the correct level in order to check the coolant system. The engine must be cold and the engine must not be running. After the engine is cool, loosen the pressure cap in order to relieve the pressure out of the cooling system. Then remove the pressure cap.The level of the coolant should not be more than 13 mm (0.5 inch) from the bottom of the filler pipe. If the cooling system is equipped with a sight glass, the coolant should be to the proper level in the sight glass.Test Tools For Cooling System
Table 1
Tools Needed
Part Number Part Name Quantity
4C-6500 Digital Thermometer 1
285-0910 Multi-Tool Gp 1
285-0900 Blowby Tool Gp 1
NETG5044 Software license 1
9S-8140 Pressurizing Pump 1
9U-7400
or
1U-6602 Multitach Tool Gp
or
Photo-Tachometer 1
245-5829 Coolant/Battery Tester Gp 1
Making contact with a running engine can cause burns from hot parts and can cause injury from rotating parts.When working on an engine that is running, avoid contact with hot parts and rotating parts.
Illustration 2 g00876179
4C-6500 Digital Thermometer
The 4C-6500 Digital Thermometer is used in the diagnosis of overheating conditions and in the diagnosis of overcooling conditions. This group can be used to check temperatures in several different parts of the cooling system. Refer to the tool's Operating Manual for the testing procedure.
Illustration 3 g01311364
285-0910 Multi-Tool Gp
The 285-0910 Multi-Tool Gp is used to check the air flow through the radiator core.
Illustration 4 g00286276
9U-7400 Multitach Tool Group
The 9U-7400 Multitach Tool Group is used to check the fan speed. Refer to Operating Manual, NEHS0605, "9U7400 MULTITACH II GP. & 9U7402 MULTITACH II PHOTO GP" for the testing procedure.The 9U-7400 Multitach Tool Group can measure engine rpm from a magnetic pickup. This magnetic pickup is located in the flywheel housing. The magnetic pickup also uses the ability to measure engine rpm from visual engine parts that are rotating.
Illustration 5 g00296064
1U-6602 Photo-Tachometer
The 1U-6602 Photo-Tachometer is a photo-tachometer that is held by hand for general use. The 1U-6602 Photo-Tachometer is a phototach, so this tachometer only registers basic input frequency on any visible, rotating part. The basic input frequency equals one revolution per a piece of reflective tape. The 1U-6602 Photo-Tachometer does not replace the 9U-7400 Multitach Tool Group.
Illustration 6 g00286369
9S-8140 Pressurizing Pump
The 9S-8140 Pressurizing Pump is used to test the filler caps. This pressurizing pump is also used to pressure test the cooling system for leaks.Show/


Parts pan Mercruiser:

804912T02
 
804912T02 PAN, Oil
4211025US, 4211025UU, 424106LUS, 424106PUU
Back to top