35312 Mercruiser PIN, Dowel, REAR BEARING CAP (1/4" DIA.)

Illustration 1 g01020684
Illustration 2 g00103219
Illustration 3 g06350702
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the entire package. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted.Some removals require lifting fixtures to obtain proper balance. Lifting fixtures also help to provide safety.Lifting eyes are designed and installed for each package. Alterations to the lifting eyes and/or the package make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Cat dealer for information regarding fixtures for proper lifting.
Radiators that are factory installed as part of a generator package, but shipped without coolant, must not be lifted after filling with coolant.
Lifting the Engine Only
To remove the engine ONLY, use lifting eyes (1) and (3) that are on the engine.Lifting the Generator Only
Note: The control panel and the terminal box will need to be removed before attempting to lift the generator.To remove the generator ONLY, use lifting eyes (3) on each side of the generator.Lifting the Entire Package (Three Point Lifting)
Do NOT use only the engine lifting eyes or only the generator lifting eyes to lift the entire package. The procedure for lifting the package utilizes a three-point lifting method. The lifting points are the front engine lifting eye (1) and on each side of the package support rails (4).Aftertreatment Component Lifting
Improper lift rigging can allow unit to tumble causing injury and damage.
Refer to the Application and Installation Guide for additional information on lifting aftertreatment components.SCR Reactor Housing
Illustration 4 g03535936Attach appropriately lifting equipment to the lifting eyes at each corner of the SCR reactor housing. Ensure that lifting equipment is clear of all sensors and fittings prior to lifting. Do not use reactor housing mounting feet to lift the SCR reactor housing.Depending on the installation configuration of your CEM, the lifting links may be installed in alternative locations. Spreader bars may be required from some lifting configurations. If necessary, the inlet and outlet spool may be removed to allow clearance to the lifting links. Consult your Cat dealer for detailed procedures.Do not lift the CEM with a fork lift after the CEM has been removed from the original shipping pallet.Lifting the Dosing Cabinet
Illustration 5 g06033498
Dosing cabinet lifting slots
Insert the appropriate lifting straps through the lifting slots, as indicated, in the base of the dosing cabinet.
Table 1
Dosing Cabinet Dimensions
Length 1010 mm (39.8 inch)
Width 553 mm (21.7 inch)
Height 634 mm (25 inch)
Weight without DEF 95 kg (209.4 lb)