896332026 Mercruiser SCREW

Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the air conditioner system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Personal injury can result from contact with refrigerant.Contact with refrigerant can cause frost bite. Keep face and hands away to help prevent injury.Protective goggles must always be worn when refrigerant lines are opened, even if the gauges indicate the system is empty of refrigerant.Always use precaution when a fitting is removed. Slowly loosen the fitting. If the system is still under pressure, release it slowly in a well ventilated area.Personal injury or death can result from inhaling refrigerant through a lit cigarette.Inhaling air conditioner refrigerant gas through a lit cigarette or other smoking method or inhaling fumes released from a flame contacting air conditioner refrigerant gas, can cause bodily harm or death.Do not smoke when servicing air conditioners or wherever refrigerant gas may be present.Use a certified recovery and recycling cart to properly remove the refrigerant from the air conditioning system.
Recover the air conditioner refrigerant from the air conditioner system. Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the correct procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the correct tools.
Illustration 1 g00852815
Remove six bolts (1) and side grill (2). Repeat this procedure for the opposite side.
Illustration 2 g00634806
Open access door (3) on left hand side of machine.
Illustration 3 g00634810
The refrigerant condenser (4) is located below the aftercooler (5) .
Illustration 4 g00634808
Disconnect two tube assemblies (6) and (7) from refrigerant condenser (4) .
Illustration 5 g00634811
Support the refrigerant condenser (4). Remove three bolts (8). Repeat for the other side.
Remove refrigerant condenser (4) from radiator guard assembly.Installation Procedure
Replace the O-ring seals that are used on the hose assemblies with new parts for the assembly.
Illustration 6 g00634811
Support refrigerant condenser (4). Install refrigerant condenser (4) and six bolts (8) on the radiator guard assembly.
Illustration 7 g00634808
Connect inlet tube assembly (6) and outlet tube assembly (7) to the refrigerant condenser (4) .
Illustration 8 g00852815
Install side grill (2) and six bolts (1). Repeat this procedure for the opposite side.
Evacuate the air conditioner system. Charge the air conditioner system. The correct charge is 2.3 kg (5.0 lb). Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the correct procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the correct tools.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".