47387 Mercruiser TUBE, Inner Cylinder


47387 TUBE, Inner Cylinder Mercruiser 5220200AS, 91331015 TUBE
47387 TUBE, Inner Cylinder Mercruiser
Rating:
93

Buy TUBE, Inner Cylinder 47387 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 14
 

Compatible models:

5220200AS   91331015   Mercruiser

Mercruiser entire parts catalog list:

Information:

Start By:a. remove oil pan 1. Turn the crankshaft until two pistons are at bottom center. Remove connecting rod caps (1) from the two connecting rods. Remove the lower half of the bearings from the caps.2. Push the connecting rods away from the crankshaft, and remove the upper half of the bearings.
Be careful not to damage the crankshaft journals. Do not turn the crankshaft while any of the connecting rod caps are removed.
Install the bearings dry when the clearance checks are made. Put clean engine oil on the bearings for final assembly.3. Clean the surfaces where the bearings fit. Install the upper half of the bearing in the connecting rod. Pull the connecting rod slowly on to the crankshaft.4. Install lower half of the bearing in the cap.
When the connecting rod caps are installed, make sure that the numbers on the side of the caps are next to and respective with the number on the side of the connecting rods.
The serviceman must be very careful to use Plastigage correctly. The following points must be remembered:...Make sure that the backs of the bearings and the bores are clean and dry....Make sure that the bearing locking tabs are properly seated in their slots....The crankshaft must be free of oil where the Plastigage touches it....If the main bearing clearances are checked with the engine upright or on its side, the crankshaft must be supported. Use a jack under an adjacent crankshaft counterweight and hold the crankshaft against the crown of the bearing. If the crankshaft is not supported, the weight of the crankshaft will cause incorrect readings....Put a piece of Plastigage on the crown of the bearing half that is in the cap. Do not allow the Plastigage to extend over the edge of the bearing....Install the bearing cap using the correct torque-turn specifications. Do not use an impact wrench. Be careful not to dislodge the bearing when the cap is installed....Do not turn the crankshaft with the Plastigage installed....Carefully remove the cap but do not remove the Plastigage. Measure the width of the Plastigage while it is in the bearing cap or on the crankshaft journal. Do this by using the correct scale on the package. Record the measurements....Remove the Plastigage before reinstalling the cap.When using Plastigage, the readings can sometimes be unclear. For example, all parts of the Plastigage are not the same width. Measure the major widths to make sure that they are within the specification range. Also, experience has shown that when checking clearances tighter than 0.10 mm (.004") the readings may be low by 0.013 to 0.025 mm (.0005 to .0010"). Out-of-round journals can give faulty readings. Also, journal taper may be indicated when one end of the Plastigage is wider that the other.For complete details concerning measuring bearing clearances, see Engine Bearings And Crankshafts, Form No. SEBD0531.5. Check the bearing clearance with Plastigage (A). Put Plastigage (A) on the bearing.6. Put 2P2506 Thread Lubricant on the threads of the rod bolts and seat surfaces of the nuts.


Parts tube Mercruiser:

38377
 
38377 TUBE, SHIFT ACTUATING CABLE
00014332, 00019003, 01321017, 01326013, 2140208, 2165208, 2250507, 5000165CE, 5220200AS, 91331015
78458A 1
TUBE, EXHAUST
78458A 1 TUBE, EXHAUST
00014332, 00019003, 01321017, 01326013, 02602347, 02608427, 04544347, 06661346, 2140208, 2165208, 257B021JS, 457B100KS, 4V71222PD, 4V71222TD, 5000165CE, 5120136JS, 5120150AR, 5220200AS, 5231100LP, 5232100N1, 5C30150FS, 5E31200N1, 5E31200TP, 5E31200TS
92054
 
92054 TUBE, EXTENDING
00019003, 01321017, 01326013, 30001854, 32001876, 5000150DP, 5000165CE, 5120150AR, 5220200AS
96400
 
96400 TUBE, Steering (NON POWER STEERING)
00019003, 01321017, 01326013, 5000147JS, 5000150DP, 5000165CE, 5111200LP, 5220200AS, 91331015
75914 6
 
75914 6 TUBE, Water
5220200AS, 91331015
47439
 
47439 TUBE, Cable Guide
5220200AS, 91331015
85018 11
 
85018 11 TUBE
5120150AR, 5220200AS
85018 6
 
85018 6 TUBE
5120136JS, 5120150AR, 5220200AS, 5231100LP, 6020006JS, 6211001N1, 6311002NZ, 6315002NZ, 6416003N2, 6511102N1, 6811001N1
Back to top