69174A 2 Mercruiser WIRE, (24.00 Inches) (RED)


69174A 2 WIRE, (24.00 Inches) (RED) Mercruiser 00014332, 01321017, 03301310, 2140208, 2165208, 5220200AS, 91331015 WIRE
69174A 2 WIRE, (24.00 Inches) (RED) Mercruiser
Rating:
88

Buy WIRE, (24.00 Inches) (RED) 69174A 2 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 7
 

Mercruiser entire parts catalog list:

00014332 1982
01321017 1987
03301310 1980,1982,1983,1984,1985,1986,1987,1988,1989,1990,1993,1994
2140208 1978,1979,1980,1981,1982
2165208 1978
5220200AS 1988
91331015 1985,1986,1987

Information:


Table 1
J1939 Code and Description CDL Code and Description Comments
5588-9
Proprietary Network #2 : Abnormal Update Rate 1998-9
N/A The code is logged.
6806-9
ECU Interface Mismatch : Abnormal Update Rate 246-9
Proprietary CAN Data Link : Abnormal Update Rate The code is logged. Note: If either the engine ECM or the SCR ECM are not powered on, the 5588-9 code or the 6806-9 code can be active. Ensure both ECM's are being powered before attempting to troubleshoot.
Table 2
Troubleshooting Test Steps Values Results
1. Check the Resistance on the Data Link
A. Turn the AC and DC breaker to the OFF position.
B. Disconnect the aftertreatment ECM J1 and J2 connectors from the aftertreatment ECM.
C. Measure the resistance of the data link between pin 8 (CDL (+)) and pin 9 (CDL (-)) on the J1 connector.
D. Measure the resistance of the data link between pin 34 (Global CAN (-)) and pin 50 (J1939 (+)) on the J1 connector.
E. Measure the resistance of the data link between pin 11 (Local CAN (-)) and pin 12 (Local (+)) on the J2 connector.
60+/-10 Ohms
Result: The resistance is less than 50 Ohms.
There are more than two terminating resistors installed in the wiring harness or a short circuit has been detected.
Repair: Repair or replace parts as necessary.
Verify the repair resolved the issue. Return to service.
Result: The resistance is 60 10 Ohms. The terminating resistors are OK.
Proceed to Test Step 2.
Result: The resistance is 120 10 Ohms.
There is a problem with a terminating resistor. Check the resistance on each terminating resistor.
Repair: Replace the failed terminating resistor.
Verify the repair resolved the issue. Return to service.
Result: The resistance is greater than 130 Ohms.
There is a problem with both terminating resistors or an open circuit has been detected.
Repair: Determine the cause of the problem. Repair the problem, when possible. Replace parts, if necessary.
Verify that the problem is resolved. Return to service.
2. Check for Power to the Aftertreatment ECM
A. Turn the DC breaker to the OFF position.
B. Disconnect the aftertreatment ECM


Parts wire Mercruiser:

67203
 
67203 WIRE ASSEMBLY, DISTRIBUTOR TO SOIL (8 1/4")
01206002, 01207333, 01326013, 01406002, 01407333, 2165203, 2165208
79148A 1
 
79148A 1 WIRE ASSEMBLY, Jumper (RED)
00014332, 01321017, 03301310, 2140208, 2165208, 5220200AS, 91331015
87379A 5
 
87379A 5 WIRE, SOLENOID TO SOLENOID (RED)
00019003, 01321017, 01326013, 03301310, 5000165CE
95084A 2
 
95084A 2 WIRE, FUSE
00019003, 01321017, 01326013, 03301310, 4S42028N1, 5000147JS, 5000150DP, 5000165CE, 5111200LP, 5120136JS, 5120150AR, 5120150R1, 5220200AS, 5231100LP, 5232100N1, 5C30150FS, 5E31200N1, 6020006JS, 6211001N1, 6311002NZ, 6315001N1, 6315002NZ, 6416003N2, 6
86322A15
 
86322A15 WIRE, SOLENOID TO SOLENOID (BLACK)
00019003, 01321017, 01326013, 03301310, 40200002D, 40200002G, 4S42028N1, 4S42028TS, 4S42028TT, 4S42028UT, 4S42028UU, 4S420P8UE, 5000147JS, 5000150DP, 5000165CE, 5111200LP, 5120136JS, 5120150AR, 5120150R1, 5220200AS, 5231100LP, 5231100TP, 5232100N1, 5
62826A 6
 
62826A 6 WIRE, FLYWHEEL HOUSING STUD
00014332, 01207333, 01402414, 01407333, 01701335, 01751347, 01851333, 01854335, 02287333, 02602347, 02607333, 02608427, 04544347, 04707333, 04708004, 04881333, 06661346, 07711346, 08987343, 257B021JS, 30001854, 32001876, 40420001D, 40500006T, 4050001
88974A 1
 
88974A 1 WIRE ASSEMBLY (BLACK)
00019003, 01321017, 01326013, 5000165CE
Back to top