39257 Mercury BRACKET (PORT) 39- 40

Illustration 1 g00687617
Enter the service mode. Select "STATUS" from the menu by using the keys for direction.
Illustration 2 g00687638
The third line of the display will show the status "ID" and the respective "ID" numbers. The meaning of the "ID" numbers are listed in the following chart of parameters. The illustration above shows that the engine speed is 1948 rpm.
Table 1
Parameters    
ID     Status     Display    
1     Governor actuator feedback signal     unit [%]    
2     Drive pump delivery pressure     unit [kPa]    
3     Idle pump delivery pressure     unit [kPa]    
4     Boom hold pressure (Attachment)     unit [kPa]    
5     Backup switch status     BACK UP / CONTROL    
7     Fuel level     unit [mm]    
8     Coolant temperature     unit [°C]    
9     Hydraulic oil temperature     unit [°C]    
10     Power supply voltage     unit [V]    
11     Engine speed     unit [rpm]    
12     Alternator status     CHARGE/
NO CHARGE    
13     Supply condition of +12 V power supply voltage     ON / OFF    
14     Required speed     unit [rpm]    
15     AEC mode selection status     First stage: OFF Second stage: ON    
16     Travel mode selection status     First speed: SLOW Second speed: FAST    
17     Travel alarm cancel status     CANCEL / ALARM    
19     Travel mode switching status     First speed: SLOW
Second speed: FAST    
20     Activation status of action alarm     ON / OFF    
21     Activation status of travel alarm     ON / OFF    
22     Activation status of straight travel control     ON / OFF    
23     Unloading valve status     ON/OFF/ATTACHMENT    
24     Release condition of swing brake     Release: FREE Brake: BRAKE    
25     Power shift pressure     unit [kPa]/DISABLED    
26     Negative Flow Control Pressure Reducing Valve
(Attachment)     unit [kPa]/DISABLED    
27     Negative Flow Control Pressure Reducing Valve
(Attachment optional)     unit [kPa]/DISABLED    
29     Temperature condition control status     Low temp. mode: COLD MODE
Normal temp. mode: NORMAL MODE
Derating mode: DERATE MODE    
30     Speed setting status of engine speed dial     unit [rpm]