804666A05 Mercury DECAL, EPA Label Information (2005)

The clutch warning sign is located on the clutch housing (if equipped).
Clutch warning sign.
Rotating gears- finger or hand entanglement. Do not service until reading the operator's manual.
Located near batteries (if equipped):
Improper jumper cable connections can cause an explosion resulting in personal injury.Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal (if machine not equipped with starter negative terminal, connect to engine block.) Follow procedure in the operation manual.
Located on the mounting base (if equipped) near the lifting holes:
Improper lift rigging can allow load to tumble causing injury and damage.
Located on the fuel tank (if equipped):
Drain fuel tank before lifting unit. Lifting this unit when fuel is present in the tank could result in separation of the tank from the base and cause personal injury or death.
Located on engine lifting eye cover assembly.
Do not use the engine lifting eyes to remove the engine and generator together.
Located on the side panels of the generator (if equipped):
Do not connect generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure main distribution system switch. Or if the connection is permanent, install a double throw transfer switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility as to the applicable circumstances.
Located on the outside of the control panel vandal door (if equipped):
Always operate this unit with the vandal door open. Operating the unit with the vandal door closed restricts access to the emergency stop button and could result in injury or death.
Located on the outside of the control panel vandal door (if equipped), above the emergency stop warning:
Do not operator or work on this engine or generator set unless you have read and understand the instructions and warnings in the operation and maintenance manuals. Failure to follow the warnings and instructions could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Located inside the generator housing (if equipped):
Before working inside the generator, make sure that the starting motor can not be activated by any automatic or manual signal. When servicing or repairing electric power generation equipment make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses. Make sure the generator engine is stopped. Make sure all batteries are disconnected. Make sure all capacitors are discharged. Failure to do so could result in personal injury or death. Make sure residual voltage in the rotor, stator and the generator is discharged.
General Hazard Information
Attach a DO NOT OPERATE or similar warning tag to the start switch or controls before performing maintenance or repairing the engine. These tags, SEHS7332, are available from your Caterpillar dealer. When appropriate, attach the tags at the engine and at each operator's position. Disconnect starting controls when appropriate. Do not allow unauthorized personnel on, around or in the engine unit when it is being serviced.Diesel engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside.Use caution when removing filler cap, grease fittings, pressure taps, breathers or drain plugs. Hold a rag over the cap or plug to prevent being sprayed or splash