855975A98 Mercury DECAL SET


855975A98 DECAL SET Mercury 1040203YL, 1040213YL DECAL
855975A98 DECAL SET Mercury
Rating:
38

Buy DECAL SET 855975A98 Mercury genuine, new aftermarket parts with delivery
Number on catalog scheme: 0
 

Compatible models:

Mercury entire parts catalog list:

1040203YL 2001,2002,2003,2004
1040213YL 2001,2004

Information:


Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     456-7994     Engine Turning Tool     1    Start By:
Remove oil pan.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01139029
Use Tooling (A) to turn the crankshaft until the connecting rod bearing caps are accessible.
Check connecting rod (3) and connecting rod caps (1) for identification and for the location.
Remove connecting rod cap bolts (2) and connecting rod cap (1) from connecting rod (3). Remove the lower half of connecting rod bearing (5) from connecting rod cap (1) .Note: This engine has fractured connecting rods. Fractured connecting rods must be handled with care. Use a soft faced hammer in order to tap the connecting rod cap, if necessary.Note: Do not place the fractured faces of the connecting rod cap on any surface. The connecting rod cap must be laid flat on the side in order to prevent damage to the fractured faces of the connecting rod cap.
Push connecting rod (3) away from the crankshaft. Remove the upper half of connecting rod bearing (4) from connecting rod (3) .Note: Do not damage the fractured faces of the connecting rod. Place a suitable protective cap on the ends of the connecting rod in order to prevent damage to the fractured faces of the connecting rod.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The joint between the connecting rod and the connecting rod cap is produced by fracturing. The connecting rod assembly must be handled with care in order to avoid damage to the mating surfaces. The connecting rod assembly must be replaced if any damage occurs to the mating surfaces. New connecting rod assemblies come with the connecting rod caps bolted on the connecting rod.Use only a soft faced hammer to tap the connecting rod cap when separating the connecting rod cap from the connecting rod.Failure to use a soft faced hammer may result in damage to the fractured surfaces of the connecting rod assembly.
Use Tooling (A) to turn the crankshaft until the connecting rod bearing cap is accessible.
Illustration 2 g01139029
Note: Install the connecting rod bearings dry when clearance checks are performed. Apply clean engine oil to the connecting rod bearings for final assembly.
Remove the protective caps from the end of the connecting rod and install the upper half of connecting rod bearing (4). Ensure that the bearing tab engages with the slot in connecting rod (3) .
Pull the piston and connecting rod assembly onto the crankshaft.
Install the lower half of connecting rod bearing (5) into connecting rod cap (1). Ensure that the bearing tab engages with the slot in connecting rod cap (1) .Note: Do not place the fractured faces of the connecting rod cap on any surface. The connecting rod cap must be laid flat on the side in order to prevent damage to the fractured faces of the connecting rod cap.
Install connecting rod cap (1) and connecting rod cap bolts (2) .
Check the bearing clearance. Refer to Disassembly and Assembly, "Bearing Clearance - Check".
Tighten connecting rod cap bolts (2) to a torque of 50 5 N m (37 3 lb ft).
Place an index mark on each connecting rod cap bolt (2). Tighten each bolt for an additional 90 5 degrees (1/4 turn).
Use Tooling (A) to rotate the crankshaft in order to ensure that the crankshaft turns freely.


Parts decal Mercury:

804664A00
 
804664A00 DECAL, EPA Information
1031203UB, 1031203UD, 1031207ZF, 1040213YL
804664A01
 
804664A01 DECAL, EPA Information
1031203UB, 1031203UD, 1031207ZF, 1040213YL
804664A02
 
804664A02 DECAL, EPA Information
1031203UB, 1031203UD, 1031207ZF, 1040213YL
808683A01
 
808683A01 DECAL SET
1031203UB, 1031203UD, 1031207ZF, 1040213YL
808615A01
 
808615A01 DECAL SET
1031203UB, 1031203UD, 1031207ZF, 1031312DB, 1040213YL
808682A01
 
808682A01 DECAL SET
1031203UB, 1031203UD, 1031207ZF, 1040213YL
802987
DECAL
802987 DECAL
1030201YL, 1031207ZF, 1040203FL, 1040203YL, 1040213YL
855973A98
 
855973A98 DECAL SET
1040203YL, 1040213YL
Back to top