5137 Mercury DIAPHRAGM AND GASKET KIT

"Rating Number"
"Rating Number" is a reference number that corresponds to the rating map that is resident in the personality module (flash file). Flash files may contain more that one rating."Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
The "Engine Serial Number" should be programmed to match the engine serial number that is stamped on the engine information plate. When a new ECM is delivered, the engine serial number in the ECM is not programmed."FLS" (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information ratings plate. A new ECM requires this parameter to be programmed. If this parameter is not programmed, the ECM will generate a 253-02 Check Customer Or System Parameters."FTS" (Full Torque Setting)
"FTS" is similar to "FTS". This parameter must be programmed. If this parameter is not programmed, the ECM will generate a 253-02 Check Customer Or System Parameters."Ether Control"
The "Ether Control" parameter allows the operation of this feature to be enabled or disabled. If the engine is not equipped with an ether starting aid, this parameter should be programmed to "Disabled"."Engine Fan Control"
The "Engine Fan Control" parameter allows the operation of this feature to be enabled or disabled. If the application is equipped with a demand fan, this parameter should be programmed to "Enabled".Parameter Table
Table 1
Customer Specified Parameters    
Parameter    Available Range or Options    Default    Required Password    
"Rating Number"     software dependent     none    
"Equipment ID"     17 characters     blank     none    
"Engine Serial Number"     8 characters     blank     none    
"FLS"     -128 to +127     0     Factory    
"FTS"     -128 to +127     0     Factory    
"Ether Control"     "Enabled" or "Disabled"     "Disabled"     none    
"Engine Fan Control"     "Enabled" or "Disabled"     "Enabled"     none    Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Information from ECM    
"Rating Number"    
   
"Rated Power"    
   
"Rated Peak Torque"    
   
"Top Engine Speed Range"    
   
"Test Spec"    
   
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Release Date"    
   
"Personality Module Description"    
   
"FLS"    
   
"FTS"    
   
"Ether Control"    
   
"Engine Fan Control"    
   
"Total Tattletale"    
   
Information From Engine Information Plate    
Engine Serial Number    
   
Full Load Setting
(for new ECM)    
   
Full Torque Setting
(for new ECM)    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the Engine Information Plate. The FLS and the FTS should only be changed because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine.