813644 Mercury GROMMET

Engine Rating Parameter
Rating Number
The rating number is the selected rating within a power rating family. The flash file defines the power rating family. The flash file can contain one to four ratings. The rating number defines the power rating that is used within the power rating family.
Table 1
Minimum    Maximum    Default    
1     4     1    Low/High Idle Parameters
Low Idle Speed
The "Low Idle Speed" is the minimum engine rpm.
Table 2
Minimum    Maximum    Default    
700 rpm     1200 rpm     750 rpm    High Idle Speed
The "High Idle Speed" is the maximum engine rpm.
Table 3
Minimum    Maximum    Default    
1900 rpm     2900 rpm     2650 rpm    ECM Identification Parameter
Equipment ID
"Equipment ID" is the identification of the equipment that is assigned by the customer. The "Equipment ID" is only for reference by the customer. The "Equipment ID" is not required by the Electronic Control Module (ECM).
Table 4
Value    Default    
17 digits
The available characters are dependent on the service tool that is being used.     Not programmed    PTO and Throttle Lock Parameters
Throttle Lock Feature Installation Status
The "Throttle Lock Feature Installation Status" is used to turn on the throttle lock features. When this parameter is changed to "Installed", the "PTO engine Speed Setting", the "Throttle Lock Increment Speed Ramp Rate" and the "Throttle Lock Engine Set Speed Increment" parameters are active and the parameters can be programmed.
Table 5
Value    Default    
Not Installed
Installed     Not Installed    PTO Engine Speed Setting
The "PTO Engine Speed Setting" is the engine speed that is attained when the PTO switch is moved to the ON position. If the "PTO Engine Speed Setting" parameter is programmed, the feature is turned off. If the "PTO Engine Speed Setting" parameter is set to a value that is between "1" and the low idle speed, the parameter is set to the low idle speed value. If the "PTO Engine Speed Setting" parameter is set to a value that is higher than the high idle speed, the parameter is set to the high idle speed value.
Table 6
Minimum    Maximum    Default    
0 rpm     3000 rpm     0 rpm    Throttle Lock Increment Speed Ramp Rate
The "Throttle Lock Increment Speed Ramp Rate" is the rate of engine acceleration when the PTO switch is held in the ACCELERATE position. If this parameter is set to "0", the feature is turned off.
Table 7
Minimum    Maximum    Default    
0 rpm/sec     600 rpm/sec     400 rpm/sec    Throttle Lock Engine Set Speed Increment
The "Throttle Lock Engine Set Speed Increment" controls the increase in engine speed when the PTO switch is briefly operated to ACCELERATE or DECELERATE. If this parameter is set to "0", the feature is turned off.
Table 8
Minimum    Maximum    Default    
0 rpm     200 rpm     10 rpm    Miscellaneous
Monitoring Mode Shutdowns
"Monitoring Mode Shutdowns" controls the shutdown feature that is associated with the engine monitoring feature. When this feature is enabled and an event code with a "-3" suffix is detected, the engine will be shut down.
Table 9
Value    Default    
Disabled
Enabled     Disabled    Monitoring Mode Derates
"Monitoring Mode Derates" controls the derate that is associated with the engine monitoring feature. When this feature is enabled and an event code with a "-2" is detected, the engine will be derated.