832952 1 Mercury INDICATOR, Throttle Position (Inside)

Illustration 1 g01641133
Schematic for the starting aid
Test Step 1. Inspect Electrical Connectors and Wiring
Inspect the following connectors:
EMCP3 connector
Con 1 connector on the Engine Interface Module
Inspect the terminal connections on the glow plug start aid relay. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the connectors that are associated with the glow plug starting aid.
Check the harness for abrasion and pinch points from the glow plugs back to the control panel.
Check that the fuses are not blown. Expected Result:All connectors, pins and sockets are correctly coupled and/or inserted. The harness is free of corrosion, abrasion and pinch points. The fuses are not blown.Results:
OK - The harness and the connectors appear to be OK. Proceed to Test Step 2.
Not OK - There is a fault with the harness and connectors.Repair: Repair the connectors or the harness and/or replace the connectors or the harness. Ensure that all of the seals are correctly in place and ensure that the connectors are completely coupled. Replace blown fuses.Use the